气隙

The installation of an air gap and drain line are recommended.

建议安装气隙和排放管道。

Push as much of the sensing hose as possible into the air gap drain funnel to prevent over spray.

将尽可能多的感应软管推到气隙排放漏斗内，以防止从上面喷溅。

Remove L shape bracket from one side of air gap drain.

从气隙排放装置的一侧拆卸L型支架。

Hang the Air Gap Drain on the body of the relief valve Fig.

将气隙排放装置悬挂在安全阀阀体上（图2）。

A new type AMB-AB was brought forward in this paper, the film air bearing was integration in AMB. The axis space is saved and the rotors dynamics performance is improved.

本文研究了一种新型的磁气混合轴承结构，其特点是将箔片气体轴承集成在磁轴承的气隙里面，不占据轴向空间，因此与国外的研究有本质的区别。

Transformer parameters influence due to the coil position and air gap is discussed and simulated by means of ANSYS.

讨论了绕组位置和气隙对可分离变压器参数的影响，并利用电磁场软件ANSYS进行了有限元仿真，得出了变压器参数随气隙变化的规律。

The air holes of all products hacek already had been adjusted,no more adjustment .

制动器出厂时气隙已调整到正常工作气隙，安装时不需重新调整。

Using Q-V Lissajous figure method,the effect of exciting voltage peak and dielectric thickness on the main discharge parameters were studied.

研究表明：增大激励电压峰值VP-P、减小介质厚度ld可提高放电功率P、单周期电荷传输量Q、气隙有效电场强度Eg和气隙折合电场强度E/n。

The results are helpful for design of the rotor wingding ventilation system with gap-pickup diagonal flow.

本文的研究结果对汽轮发电机转子气隙取气斜流通风系统的设计具有指导意义。

The thermal boundary condition of the cast iron cooling stave with surface alloyed steel pipe was used for numerical simulation of temperature field and commercial software ANSYS and the method of coupling heat-structure were used to calculate thermal deformation of steel pipe at high temperature,and analyze the influence of air gap and thermal deformation on the life of cooling stave.

根据合金化管铸铁冷却壁热态试验数据确定了合金化管铸铁冷却壁温度场数值模拟的边界条件，利用ANSYS软件、采用热-结构耦合的方法计算了高温状态下合金化管铸铁冷却壁内钢质冷却水管的变形，分析了气隙层和水管热变形对合金化管铸铁冷却壁寿命的影响，得出保证合金化管铸铁冷却壁长寿的最佳气隙层厚度和相应的最佳使用热负荷。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。