气油

With the investigation of the domestic and foreign literature systematically, the bases on the domestic and foreign present research and the comprehensive utilizations of the various knowledge of fluid mechanics in porous medium, reservoir engineering, mathematical physics, perforation completion, numerical simulation and so on, this article takes numerical simulation of gas reservoir of water solubility as the research aim which has completed following research works and obtained the corresponding research results: it analyzes the nature of the Water-soluble gas and formation water as well as the influent factors of the solubility through the study of massive materials; It establishes mathematical models three-dimension, the dual medium, the gas-water phase through the way of finite difference in the migration of water-soluble gas, which describes the entire process of release, migration and production in formation, where it considered the problems of variable bubble point; According to the numerical models of gas reservoir of water solubility it provides solution procedure that based on black oil model; It discovers that there will obtain the good effects in the lowly speed of development through simulation; the reinjection of formation water may largely enhance the produce degree of water-soluble gas when we consider reinjection in simulator; It considered the influence of perforated completion on development so as to increase the simulator"s versatility, It discovers that the simulator may reflect the conditions of development when we exanimate he simulator"s reliability with the empirical datum.

本文以水溶性气藏数值模拟研究为研究目标，在系统调研国内外文献、深入分析国内外研究现状的基础上，综合利用渗流力学、油气藏工程、数学物理方法、射孔完井以及数值模拟理论等多方面的知识，完成了以下研究工作并取得相应的研究成果；①通过对大量的资料调研，分析了水溶气、地层水性质、储层地质性质以及影响气体在水中溶解度的因素。②考虑到由于高压产生的大量水力裂缝，采用有限差分方法建立水溶气运移的三维、双重介质、气-水两相全隐式数学模型，该模型描述了水溶气在地层中的释放、运移和采出的整个过程。③在原有黑油模型的基础上，根据水溶性气藏数值模型编制了该数值模型的求解程序，该程序可以求解单重、双重介质两种情况。④通过模拟不同开采速度对水溶气开发效果的影响，发现开采速度较慢的时候可以取得较好的开采效果。⑤在模拟器中考虑了注水对水溶性气藏开发的影响，地层水回注可以大幅度提高水溶气的采出程度。⑥为增加模拟器的通用性，在模拟器中考虑了射孔完井方式对开采的影响。⑦检验模拟器计算的可靠性，发现在使用实验数据对水溶性气藏进行模拟时，模拟器可以很好的反映气藏开发的状态。

Caused by the brake disc brake on back wheel should not have four kinds of spaces possible: First, the foot brake 5 exhaust inlets, high pressure gas instinct Pai people the atmosphere, caused by gas-liquid master cylinder should not spring back to place, cause the system Oil will move the brake disc brake wheel cylinder piston top dead can not come back to places; are gas-liquid two disc brake master cylinder to the tubing plug, resulting in brake wheel cylinder piston can not come back to places; are three master cylinder of gas-liquid Can not spring back to their own spaces, brake fluid under high pressure gas, liquid should not return to the master cylinder reservoir chamber, resulting in brake wheel cylinder piston can not come back to places; are four wheel disc brake piston brake system because of moving fluid dirty or rusty Pistons Can not Back-bit card dead.

造成盘式制动器上的制动分泵不能回位有4种可能：一是脚制动阀5的排气口堵塞，高压气体本能排人大气，造成气液总泵的弹簧不能回位，导致制动油将盘式制动器的制动分泵活塞顶死而不能回位；二是气液总泵至盘式制动器的油管堵塞，造成制动分泵活塞不能回位；三是气液总泵的弹簧本身不能回位，制动液在高压气体作用下，不能回到气液总泵的储油室，从而造成制动分泵活塞不能回位；四是盘式制动器制动分泵活塞由于制动液太脏或活塞生锈卡死而不能回位。

Caused by disc brake on the brake Wheel Cylinder could not return to places 4 possible: First, 5 foot brake valve exhaust port blocking, high-pressure gas instinct platoon atmosphere, caused by gas-liquid master cylinder of the spring could not return to place, resulting in the system move oil, brake disc brake Wheel Cylinder Piston top dead and could not return to places; second is to the disc brake master cylinder gas-liquid pipeline blockage, resulting in brake Cylinder piston can not return to place; third master cylinder of the gas-liquid Spring itself can not return to position, brake fluid under high pressure gas can not return Axial pump to gas-liquid master cylinder reservoir chamber, resulting in brake Cylinder piston can not return to places; Fourth Wheel Cylinder piston disc brake system, due to moving fluid dirty or rusty card dead and can not return to the piston position.

造成盘式制动器上的制动分泵不能回位有4种可能：一是脚制动阀5的排气口堵塞，高压气体本能排人大气，造成气液总泵的弹簧不能回位，导致制动油将盘式制动器的制动分泵活塞顶死而不能回位；二是气液总泵至盘式制动器的油管堵塞，造成制动分泵活塞不能回位；三是气液总泵的弹簧本身不能回位，制动液在高压气体作用下，不能回到气液总泵的储油室，从而造成制动分泵活塞不能回位；四是盘式制动器制动分泵活塞由于制动液太脏或活塞生锈卡死而不能回位。

Theoretical basis of thermodynamics on fluid phase balance is studied in this paper, and estimating rule of thermoelectrical equilibrium with interfacial phenomena is analyzed. Adsorption theoretical model is evaluated on the base of essential theory of adsorption.

本文研究了流体相平衡的热力学理论基础，并分析了存在界面现象时的热力学判据，研究了吸附的基本理论，选择了空穴溶液理论模型计算凝析气在多孔介质表面的吸附；应用晶格理论吸附模型计算凝析油在多孔介质表面的吸附；应用气相吸附数据计算二元液相吸附，作为应用晶格模型研究多元液相吸附的输入数据，并且首次考虑气液混合吸附，以凝析油的临界流动饱和度作为判断气液混合吸附还是单纯的液相吸附的条件。

In this paper,a general formula applicable for mixing gas source material including sapropel type Kerogen and humic type Kerogen was built up,based on the formulas given by previous scholars.

在前人判别煤型气和油型气母质类型和转化程度公式的基础上，建立了既适用于煤型气又适用于油型气母质来源的统一的判别公式。

After the reserves of unassociated gas being increased fast, it is asked to adjust the main direction of natural gas development to deepen exploration of natural gas in the two basins in the central part and the regions (eg.the areas of northern and southern Tianshan mountains) near pipelines in China.It is suggested that tight gas reservoirs should be enhanced to explore,e...

在气层气储量快速增长后，应当调整我国天然气勘探主攻方向：深化中部两盆地和管线附近的天然气勘探；加强致密气藏勘探，特别是滚动勘探开发工作；对海上天然气应加大投入，除南海北部和东海外，还要注意渤中坳陷轻质油分布区的气层气勘探，还要按隆起和坳陷的不同情况开拓黄海这个战略后备区；东部中小气田经济价值高，作为地下气库应发挥更大作用。

By oil-source correlation, it is clear that the Qinggao oil fields main oil-source comes from source rock of S4 section of BoXing sag; The geochemical index of hydrocarbon gas inflects it has the character of petroliferous gas and has suffered from different extent of biology degradation.

通过油源对比，说明高青油田油源主要来自博兴洼陷沙四段烃源岩；烃类气的地化指标反映为油型气，且都不同程度遭受生物降解。

Supply oil to the fuel oil system by hand oil supply pump and release all the air through the injector pump and fuel injector's vent screw until the oil overflows and no more air found.

采用手压输油泵向燃油系统供油、通过喷油泵及喷油器放气螺钉放气、直至开始溢油并无残留气为止。

Also the multi-scale entropy processing and analysis of conductance fluctuating signals acquired by VMEA sensor for five flow patterns with water as the continuous liquid are conducted. The study result indicates that the increase of f o makes oil in water type slug flow occur at lower U sg; for low flow velocity, the continuous liquid inversion occurs at about f o=0.9 and the increase of U sg makes the inversion point move to low oil volume fraction; the multi-scale entropy detail describes the nonlinear dynamic characteristics of oil-gas-water flow patterns and the rate of MSE at low scales sensitively indicates the variation of flow patterns and can act as the efficient criterion of three-phase flow patterns identification.

对水为连续相的5种流型VMEA传感器波动信号进行了多尺度熵分析，研究结果表明：含油率增加可使水包油段塞流在较低气相表观速度下产生；较低流速下的油水相态逆转可发生在油液比为0.9左右，气相流速增加使得逆转点向含油率低的方向偏移；多尺度熵细节可以刻画油气水三相流非线性动力学特性，而低尺度的多尺度熵变化率敏感地反映流型转变，是划分油气水三相流流型的有效准则。

Then quality upgrading scheme was explored in order to solve the high content of sulphur and nitrogen in pyrolytic oil, low flash point as well. Yields of pyrolysis of scrap tires in a pilot-scale rotary kiln under 550℃were firstly summarized. Then elemental composition and physiochemical properties were analyzed on both pyrolytic crude oil and its fractions. Based on these researches, the feasibility that pyrolytic oil is used as fuel was discussed. From FT-IR spectra the functional group compounds were generally acquainted, and by column chromatography analysis chemical compositions were clearly known. Then through GC analysis the absolute content of BTX in pyrolytic crude oil was defined.

本文首先考察了中试回转窑550℃下的废轮胎热解产率及热解原油的元素组成和理化特性，对其作为燃料使用的可行性进行了分析；通过实沸点蒸馏研究了轻质、中质馏分热解油的基本特性：红外分析得出了有代表性馏分热解油的大致官能团组成形式，对热解油的强芳香性和部分不饱和性有了整体了解；化学族组成分析进一步了解了热解油内在化学族组成和含量，对热解油的内在性质有了更为深入理解；气相色谱分析对热解油中富含的苯、甲苯和二甲苯进行绝对定量，为热解油提取BTX化工原料的经济性提供了参考。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。