气室

Based on the previous research on the deposition of amorphous/microcrystalline silicon tandem solar cells, silane concentration for the deposition of microcrystalline bottom cell was selected to further optimize the performance for micromorph tandem solar cells using very high frequency technique. Finally, micromorph silicon tandem solar cell with 11.02%(Area=1.0cm2) initial conversion efficiency has been fabricated at a certain silane concentration and suitable light trapping structure.

采用甚高频等离子体增强化学气相沉积技术，在前期我们单室沉积的微晶硅薄膜太阳电池和非晶硅/微晶硅叠层太阳电池研究的基础上，通过对微晶硅底电池本征层硅烷浓度的优化，获得了初始效率达到11.02%（电池面积1.0cm2）的非晶硅/微晶硅叠层太阳电池。

BACKGROUND: Diagnosis otitis media with effusion in children is very important. The commonly used diagnostic methods are pneumatic otoscopy, tympanometry, acoustic reflectometry, and myringotomy.

背景：小儿积液性中耳炎的诊断相当重要，较常用的方法包括：气式耳镜、鼓室图、声反射检查及鼓膜切开术等。

Each group 30cases. The patients in the two groupsall were treated by Oral use of persantine, vitaminE, shenyankang. And lowfrequency direct current electroacupuncture at renal regions acupoints[Sanjiaoshu point (BL22), shenshu point (BL23), pishu point (BL20), qihaishupoint (BL24), zhishi point(BL52)]were added to the treatment group.

治疗组在对照组治疗基础上加用低频直流电针肾区穴位(三焦俞、肾俞、脾俞、气海俞、志室穴)，对照组运用潘生丁、维生素E、肾炎康复片治疗；疗程均为20天。

Symptom : the main function of the small intestines is absorbing the nutriment and transport the food leftover to the bowel, the main function of bowel is excretion and have no digestion function , if the contraction and ballooning of the colon appeared ,it will raise bugling ,poor digestion ,abnormal excretion and no molding stool, when it over-expand; after defecating you want to defecate again, so the chronic toxin can easily deposit in the colon and the diverticulun is formed.

症状：小肠的主要功能为吸收养分，吸收完后的食物残留物则输送至大肠，而大肠本身没有消化的功能而主司排泄，所以当肠道出现紧缩或扩张的现象时，就会引起胀气，消化不良，排泄不正常或大便不成型，扩张过度时亦会造成排完便后仍有便意，也容易造成肠道壁有慢性毒素沉积而产生憩室与宿便的囤积。

These are body-plant, metre, rear flowboard, bumper, instrument board, door panel, top celling, seat, air intake manifold, radiator water chamber, oil tank, tyre, tube, door and window sealing strip, reduce shake part, frictions, textiles and inorganics materials used in vehicles.

包括车身外板、格栅、后阻流板、保险杠、仪表板、门内板、顶棚内村、座椅、进气歧管、散热器水室、油箱、汽车轮胎、胶管、门窗密封条、减振橡胶制品、汽车摩擦材、汽车用化学纤维、汽车用无机材料等。

Methods by using a broad pH range column(Gemini NX C18,4.6mm×150mm,5μm),basic mobile phase which was[H_2O-ammonia-glacial acetic acid] (96:3.6:0.4)-methanol,the related substances in etimicinsulfate were separated and detected by electrospray ionization and positive ion monitoring,the ESI ion source condition was following: temperature is 350℃,nebulizing pressure is 50 psi,dry gas flow is 10 L /min.some related substances in etimicinsulfate were identified by comparing the retention time in chromatography,~+ spectrum and MS~2 spectrum with reference substances\',the others which haven\'t reference substances were identified or speculated by analyzing their MS~2 fragmentation with the help of a rule summarized from the MS~2 fragmentation of gentamicin C1a,micronomicin and etimicin.Results nineteen related substances in etimicinsulfate were separated and detected.

方法利用宽pH范围的Gemini NX C18(4.6mm×150mm，5μm)色谱柱，在碱性条件下，以[水-氨水-冰醋酸(96：3.6：0.4)]-甲醇(70：30)为流动相，直接分离各组分；并用HPLC-ESI-MS~2检测样品中各组分，质谱条件：ESI离子源，离子源温度350□，雾化室压力50 psi，干燥气流速10 L/min，正离子检测方式；对有对照品的有关物质采用比对有关物质与对照品的色谱保留时间、准分子离子的质荷比及二级质谱方法进行鉴定，无对照品的有关物质，则是先通过解析庆大霉素Cla、小诺霉素、依替米星的二级质谱，对该类化合物的二级质谱裂解规律进行归纳，并以此推测未知新化合物进行结构，再用推测的结构对二级质谱进行解析，如所有的碎片离子均合理解释，表明推测合理。

Pneumatic control valve of the film room, while not consume air, but if the gas supply system with water, oil and other impurities, then the valve positioner will, following such attachment plug and actuator failure.

气动调节阀的膜室虽然不消耗空气，但如果气源系统含有水分、油污等杂质，则会使阀门定位器、继动器等附件堵塞并发生故障。

If the resistance rises to the pre-set number(1245－1470Pa), the controller will send out signals, first to control the lift valve to do these operations: close the hole of the valve board to cut air current and stop filtering, and then to open the electromagnetic pulse valve to blow compressed air whose pressure is 0.5-0.7Mpa into filter bag with a short time(0.01－0.12s).

当含尘烟气由进风口进入灰斗以后，一部分较粗尘料在这时由于惯性碰撞、自然沉降等原因落入灰斗，大部分尘粒随气流上升进入袋室，经滤袋过滤后，尘粒被阻留在滤袋外侧，净化的烟气由滤袋内部进入箱体，再由阀板孔、出风口排入大气，达到收尘的目的，随着过滤过程的不断进行，滤袋外侧的积尘也逐渐增多，从而使除尘器的运行阻力也逐渐增高，当阻力增到预先设定值（1245－1470Pa）时，清灰控制器发生信号，首先控制提升阀将阀板孔关闭，以切断过滤烟气流，停止过滤过程，然后电磁脉冲阀打开，以极短时间（0.01－0.12s）向箱体内喷入压力为0.5－0.7Mpa的压缩空气，压缩空气在箱体内迅速膨胀，涌入滤袋内部，使滤袋产生变形、震动，加上逆气流的作用，滤袋外部的粉尘便清除下来掉到灰斗，清灰完毕之后，提升阀再次打开，除尘器又进入过滤状态。

The cold-flow field in the gasifier chamber is studied.

本文对水煤浆气化炉喷嘴进行了简化处理，在此基础上，对气化室内的冷态流动过程进行了研究，发现：整个气化室都处于流动的回流区长度范围以内；水煤浆气化炉中，由于操作压力很高，气相密度很大，所以即使对于d〓=150μm的较大煤颗粒，其对流体的跟随特性也很好，没有发生流动特性突跃的现象；两相的最大回流速度、回流强度，颗粒相的浓度分布，以及气化室内的静压力损失等，均与气化炉的负荷、水煤浆浓度、煤粒直径、O〓在喷嘴两个流道中的分配比例。

The nozzle of the gasifier is simplified. The cold-flow field in the gasifier chamber is studied. The research shows that the chamber has recirculation along the whole length. The particles in the chamber perform a very good flowing characteristics even for the large particles of dp=150μm, and no abrupt change is observed. This is due to the operational pressure is high and the density of the gas is large there. The maximal reflux velocity of both phases, the reflux intensity, the concentrational distribution of particles, and the static pressure loss in the chamber are all related to following factors: the load of gasifier, the concentration of coal-water slurry, the diameter of the coal particle, the distribution ratio of oxygen in the two channels of the nozzle, and the angle of jet in nozzle.

本文对水煤浆气化炉喷嘴进行了简化处理，在此基础上，对气化室内的冷态流动过程进行了研究，发现：整个气化室都处于流动的回流区长度范围以内；水煤浆气化炉中，由于操作压力很高，气相密度很大，所以即使对于dp=150μm的较大煤颗粒，其对流体的跟随特性也很好，没有发生流动特性突跃的现象；两相的最大回流速度、回流强度，颗粒相的浓度分布，以及气化室内的静压力损失等，均与气化炉的负荷、水煤浆浓度、煤粒直径、O2在喷嘴两个流道中的分配比例、以及喷嘴的射流角等参数有关。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐