气压

You feel pains in your ear because of a change in air pressure.

您感到耳朵痛是由于气压改变的缘故。

We had a common hydraulic pneumatic Safety valves tank that we utilized to actuate those four ball valves on our high service pumps," said Jeff Childers, the Dyal plant's Assistant Superintendent."

我们有一个共同的液压气压罐，我们用来开动就高这四个服务泵球阀，"杰夫说德斯的Dyal工厂的助理监督。"

In fact,i really don't like rain,besides the rain can cause low pressure which make people feel choky, and i always feel some kind of sadness when rainy day. i don't know why,perhaps the sound of drippy alway make peole remember the past story,who knows.

事实上我不太喜欢雨，除了因为下雨时的低气压使人感到窒息外，更是因为每当下雨的时候我总感到一种莫名的伤感，我真的说不出为什么，也许是滴滴的雨声总能勾起人们对往事的回忆吧。。。。。。

Our products have already been widely applied in the Automobile Industry such like rain scraper, the rear view mirror, the seat regulator, the safety belt and so on; Consumer Electronics such like self-operated thermostatic control, chronoscope, coffeemaker, thermotron, electric razor, fuel gas equipment for kitchen; Electronic and Communication such like coupling, antenna, switch potentiometer, hard disk guide rail, radiator; Furniture Hardware such like hinge, handle and so on; Architectural Engineering such like aluminum gate, window, screw and so on; Hydraulic and Pneumatic such like valves, quick release, line frame, coupling, pump, cylinder.

我们的产品已经广泛应用于汽车零部件如雨刮器、后视镜、坐位调节器、安全带等；消费电子如自动调温器、记时器、咖啡机、电子温度计、电动剃刀、燃气厨房设备；电子和通信如连接器、天线、开关电位器、硬盘导轨、散热器；家具五金如合叶、把手、铰链等；建筑工程设备如铝制门、窗、螺丝等；液压气压设备如阀体、快拆、线框、连接器、泵、汽缸。

In this research, the index for Hadley circulation intensity is defined as the maximum positive value of the zonal mean streamfunction occurring within the latitudinal zone of 0°~30°N, and index for NPO as normalized sea level pressure difference between the region (20°N, 180°~160°W) and the region (60°N, 180°~160°W).

本文选取0°~30°N区域里最大质量流函数来描述北半球Hadley环流强度随时间的演变，利用(20°N， 180°~160°W)和(60°N， 180°~160°W)区域平均的标准化海平面气压差代表NPO强度。

Cloud chamber; nepheloscope

可以部分或全部控制气压、温度、湿度等条件以制造云雾的箱室装置。

In the one half part, according to the strontium nature, thermodynamic calculation of correlative reaction and the principle of the vacuum aluminothermy reduction process, with the laboratory findings of preparation strontium by vacuum aluminothermy reduction compared and analyzed in different parameter conditions, a variety of factors which effect the decomposition rate of SrCO_3 and the percent reduction of strontia are gotten out. The factors include that the decomposition rate of SrCO_3 is influenced by different addition and pressure. They also include that the percent reduction of strontia is influenced by excess coefficient of reducing agent aluminium powder, the particle size of raw material or reducing agent, the pressure of barbecuing, temperature and reduction time. According to those, we can draw the conclusion as follows:(1) Decomposition temperature of SrCO_3 is decreased by adding carbon and alumina in different degree.(2) With quantitative carbon added under the vacuum condition, the decomposition temperature of SrCO_3 is decreased obviously, which can fall 150℃ compared with atmospheric pressure.(3) In keeping 1150℃ of 2.5h, under the 5Pa vacuum condition, the decomposition rate of SrCO_3 nearly keeps in 99% steadily.

在前半部分的真空铝热还原法中，根据锶的性质、相关反应的热力学计算及真空铝热还原法原理，通过对不同参数条件下的真空铝热还原法生产金属锶的实验结果的分析比较，得出了影响SrCO_3的分解率和氧化锶的还原率的种种因素，具体因素包括不同添加剂、不同气压对SrCO_3分解率的影响，还原剂铝粉的过量系数、原料与还原剂的粒度、制团压力、温度和还原时间等对氧化锶还原率的影响，得出具体结论如下：(1)添加碳和Al_2O_3能不同程度的降低SrCO_3的分解温度；(2)真空条件下加入一定量的碳可显著降低SrCO_3的分解温度，比之常压下可降低150℃之多；(3)在1150℃恒温2.5h、真空度达到5Pa的条件下，SrCO_3的分解率几乎保持稳定在99％；(4)氧化锶的还原率随还原剂过量系数的增大而增大，但是趋势越来越小，当过量系数超过25％后，氧化锶的还原率几乎不再增加；(5)氧化锶的还原率随原料与还原剂的粒度的变细而增加；(6)氧化锶的还原率随制团压力的增加而增加，但超过一定值后，氧化锶的还原率反而会下降；(7)氧化锶的还原率随还原温度的升高而增加；(8)氧化锶的还原率随还原时间延长而增加，在本实验条件下，超过2.5h趋于稳定。

The amount of compound, super lattice and nitrogen in tantalum increases with temperature rising. And the account of compound phase has a maximum with the increasing of hydrogen mole fraction,and this maximum decreases with the increasing of temperature.

氮在钽中的固溶度随气压、温度和氢摩尔分数的增加而增加，化合物和超晶格相含量随温度增加而增加，同时化合物相随氢摩尔分数增加有一个极大值，该极大值随温度增加而下降。

The series of ZNFM Full Automatic Lamianator is a compound device which uses the pre-pasted and no-glue film with papers,its head adopts Feida head automatic feeding system,the laminating steel rod using hot oil cycle heating system,the compound pressure adopts air pressure devices,the electrical control system uses PLC Programming controller,the cutting system equips with the cutting system of rotaty flying knife and uchigatana,the back equips with the automatic collecting system, it is space-saving and high degree of automatic,easy operation and high stable performance.

ZNFM全自动复膜机系列，用于预涂膜和无胶膜与纸张的复合设备，该复膜机头部采用飞达头自动输送纸系统，压合钢棍采用热油循环加温系统，复合的压力采用气压装置，电气系统采用PLC编程控制，分切系统配有打刀和旋转飞刀分切装置，复膜机后部配有自动收纸系统，整机占地面积小，自动化程度高，操作简便，稳定性高，是印刷及包装行业的首选设备，能为你在大量生产时可获得更好的经济效益。

The mechanism was similar to the equivalent barotropic warm core structure. The Conditional Instability of the Second Kind was the primary mechanism of development and maintenance for MCSs in case 2005. As the MCSs intensified and persisted, the latent heating was highly efficient in producing significant enhancement of Mei-Yu front systems. The LLJ intensified by Coriolis acceleration of ageostrophic wind was induced by the effect of latent heat release. The LLJ and the effect of latent heat released reinforce each other in convection system through a positive feedback process.

综合而言，2005年个案中梅雨锋面结构为垂直近乎不倾斜的浅系统，槽线系统不明显，锋面水平温度梯度微弱，低层具有强水平气旋式风切，较似正压系统，个案中MCS发展及维持机制，主要是透过CISK 过程来维持；其过程是由於低层锋面带上之辐合激发对流发展，对流潜热释放造成局部气压梯度增强，因而增强地转风；而潜热释放亦有利低层辐合之增强，产生非地转风，再透过科氏加速增强西南风，使LLJ增强，形成一正向的回馈作用。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。