气体化

It also describes the application of gas-soft nitriding technology to cold extrusion dies and th...

并且介绍了气体软氮化工艺在冷挤压模具上的应用，和国内研制的新型冷挤压模具钢65Cr4W3Mo2VNb及6W6Mo5Cr4V的试用情况。

Dehydrizing processes and mechanical properties of samples after gas nitriding were studied .

对气体氮化后的除氢工艺及力学性能进行了研究。

Through a single shot experiment powered by a constant voltage charging device,it is found that when discharging in N2,the generator has the same output waveforms for both isolation configurations;but when discharging in SF6,it has a faster rise time for the resistively isolated configuration than that for the inductively isolated configuration,and the reason for this phenomenon was analyzed preliminarily.

通过恒压源充电的单次实验发现，发生器在氮气(N2)中工作时，两种隔离方式的输出脉冲波形基本一致，然而在六氟化硫(SF6)气体中工作时，电感隔离型相对于电阻隔离型的输出脉冲前沿较慢；对其原因做出了初步分析。

In this paper, the process of the cleaner roasting of shaly coal was studied.

本研究对石煤清洁焙烧工艺进行了研究，发现钙化焙烧除可完全避免钠化焙烧过程中Cl2 、HCl等有害气体的产生外，石灰在焙烧过程中有很好的固硫效果。

It is found thatthere exist three modes in a magnetized, homogeneous, and collisional dusty plasma:the wholly damped mode due to the thermal diffusion, damped electrostatic dustacoustic wave, and damped electrostatic dust cyclotron wavediscovered by the dissertation for the first time; As neutral gas pressure increases,the damping rates of the EDA and EDC waves increase; The effects of dust densityon the EDA and EDC waves are remarkably different from unmagnetized orcollisionless plasma; A possible explanation to plasma crystallization is suggestedon the basis of the present results.

EDA的阻尼速度随中性气体压强的增大而增大，这一点与实验相符，对于EDC也存在同样的关系。尘粒密度对EDA波和EDC波的影响明显不同于非磁化或者无碰撞尘埃等离子体中的情况。当忽略碰撞时，阻尼的EDA和EDC波回到纯振荡波。最后就尘埃等离子体晶化给出了一个可能的解释。

The unpractically large and complex surface areas for the tar to stick were also minimised by removing the gas conditioning coil present in the isokinetic sampling train.

通过去除等动力采样环节的气体交换圈，可使用于支撑的柏油不切实际的大而复杂的表面积最小化。

The major phase of both slags produced from air and CO/CO2 conditions were SiO2 and Fe2O3, which have much benefit to the encapsulation of heavy metals. The leaching concentration of zinc in CO/CO2 reducing condition is an order less than that in air oxidizing condition due to the higher vapored heavy metals in CO/CO2 reducing condition compared to that in air oxidizing condition. Furthermore, the leaching rate of heavy metals in both CO/CO2 and air conditions are almost the same.

在熔渣特性改变方面，空气气体与CO/CO2还原气氛下所得之熔渣除外观上不同外，两种熔渣之XRD之图谱因熔渣之结晶程度不良，仅可鉴定出SiO2及Fe2O3两种晶相，因而熔渣中之SiO2及Fe2O3可视为较为稳定之晶体结构，故在还原气氛熔融时，对熔渣中重金属之匣限化仍具有正面助益。

The high-purity manganese carbonate is prepared by leaching manganese with sulfur dioxide, removing impurities, carbonating and crystallizing from Xiangtan's low-grade manganese ore .

采用湘潭低品位的贫软锰矿为原料，对二氧化硫气体湿法浸锰、浸出液除杂、碳化结晶制备高纯碳酸锰的工艺进行了研究。

Carbonitriding Carbonitriding, sometimes known as dry cyaniding or nicarbing, is a case-hardening process in which the steel is held at a temperature above the critical range in a gaseous atmosphere from which it absorbs carbon and nitrogen.

碳氮共渗碳氮共渗，有时也称为干法氰化或渗碳氮化，是一种表面硬化工艺。通过把钢放在高于临界温度的气体中，让它吸收碳和氮。

Earbonitriding Earbonitriding, sometimes known as dry cyaniding or nicarbing, is a case-hardening process in which the steel is held at a temperature above the critical range in a gaseous atmosphere from which it absorbs carbon and nitrogen.

碳氮共渗碳氮共渗，有时也称为干法氰化或渗碳氮化，是一种表面硬化工艺。通过把钢放在高于临界温度的气体中，让它吸收碳和氮。

The concept of equivalent rotationally rigidity is offered and the formula of rotationally rigidity is obtained.

主要做了如下几个方面的工作：对伸臂位于顶部的单层框架—筒体模型进行分析，提出了等效转动约束的概念和转动约束刚度的表达式。

Male cats normally do not need aftercare with the exception of the night after the anesthetic.

男猫通常不需要善后除了晚上的麻醉。