气

The gas-forming hypotheses are mainly synthetic gas and earth outgas hypotheses.

其成气假说主要有合成气说和地球脱气说。

The paper also presented the detailed experimental analysis on the combined technology of ozonization, engineering bacteria reinforcement and aeration, included the functions of different units in the system and demonstrated the superiority and necessity of the combined application of the ozonization, engineering bacteria reinforcement and aeration.

针对以上情况，在对固定化生物活性炭技术多年研究的基础上，首次提出采用臭氧固定化曝气生物活性炭滤池组合工艺对石化特种废水深度处理进行深入研究，文中对臭氧氧化、工程菌强化、曝气组合工艺进行了详细试验，总结出不同处理单元在系统中的作用，论证了臭氧氧化、工程菌强化、曝气联合应用的优越性和必要性，出水可以达到回用水标准。

Discussions are made on dust-free collection of reducing slag site of magnesium production with Pidgeon process and on process of making aerated concrete block taking magnesium reducing slag as main raw material.

探讨了"皮江法"炼镁的还原渣现场无粉尘收集和以镁还原渣为主要原材料生产加气混凝土砌块的工艺，采用该工艺生产的加气混凝土砌块性能符合GB 11969—1997《蒸压加气混凝土砌块》的要求。

Taking the eastern sag of the Liaohe basin where coal, oil and gas resources coexist and the Wangying borefield of the Fuxin basin where coalbed gas was first discovered, researched and developed in China as examples, we systematically discuss the control of volcanism on the lateral and vertical distribution of brown coal, flame coal and gas coal in the third member of the Paleogene Shahejie Formation and on the gas source conditions of each coal region. Both the methane released in the process of regional plutonic metamorphism and the additional methane generated by contact metamorphism are calculated. The physical properties and storage capacity of the coal beds changed greatly due to the formation of blackcoal and highlymetamorphosed crevice coal from igneous intrusion. The sealing capacity of intrusions with various occurrences such as dikes is highlighted.

以煤、油、气共生的辽河盆地东部凹陷和我国首次在矿井中发现、研究、开发煤层气藏的阜新盆地王营井田为例，系统地阐述了火山活动在古近系沙河街组三段对褐煤、长焰煤和气煤在平面及垂向分布的控制，进而导致各赋煤区气源条件的不同；估算了王营井田在区域深成变质过程释放甲烷气的基础上，接触变质作用所形成的附加甲烷量；指出由于岩浆侵入形成了天然焦和高变质裂隙煤，使煤层物理性质及储集能力发生了大的变化；强调了岩墙等不同产状的岩浆侵入岩体对煤层气的封闭作用。

Taking the eastern sag of the Liaohe basin where coal, oil and gas resources coexist and the Wangying borefield of the Fuxin basin where coalbed gas was first discovered, researched and developed in China as examples, we systematically discuss the control of volcanism on the lateral and vertical distribution of brown coal, flame coal and gas coal in the third member of the Paleogene Shahejie Formation and on the gas source conditions of each coal region. Both the methane released in the process of regional plutonic metamorphism and the additional methane generated by contact metamorphism are calculated. The physical properties and storage capacity of the coal beds changed greatly, due to the formation of blackcoal and highly-metamorphosed crevice coal from igneous intrusion. The sealing capacity of intrusions with various occurrences such as dikes is highlighted.

以煤、油、气共生的辽河盆地东部凹陷和我国首次在矿井中发现、研究、开发煤层气藏的阜新盆地王营井田为例，系统地阐述了火山活动在古近系沙河街组三段对褐煤、长焰煤和气煤在平面及垂向分布的控制，进而导致各赋煤区气源条件的不同；估算了王营井田在区域深成变质过程释放甲烷气的基础上，接触变质作用所形成的附加甲烷量；指出由于岩浆侵入形成了天然焦和高变质裂隙煤，使煤层物理性质及储集能力发生了大的变化；强调了岩墙等不同产状的岩浆侵入岩体对煤层气的封闭作用。

Producted RF and CRF aerogels by process of sol-gel technics, dynamic-exchange, CO2 supercritical drying, and procedural increase in temperature carbonization methods, which have eximious capability and nanometer network structure; Systemic analysis various factors which effect gel course, such as ratio of reactants and the dosage of catalyst, and probed into the better experiments conditions(the concentration of resorcinol and formaldehyde is more than 2% and the value of R/C is between 50 and 300); During gel course , primary investigated the viscosity curve and particle size distribution of sol-solution, and analyzed the reason of catalyst dosage effects particle size of gel, and confirmed that the up-growth of gel follows the theory of " polymerize increase ".The experiment results indicated that ultrasonic with unvarying temperature disposal shortened gel time and optimized quality of gels, and the factors of ultrasonic effect gel reaction velocity were analyzed; Prepared organic aerogels using compounds of resorcin and hydroquinone substitute resorcinol reacts with formaldehyde the first time, and also optimized the proportion of resorcinol and hydroquinone (the proportion of hydroquinone in 10%～40%).

采用溶胶-凝胶工艺结合动态溶剂交换、CO2超临界流体干燥与程序升温碳化方法制备出性能优良、具有纳米网络结构的RF与CRF气凝胶；深入研究了反应物配比催化剂用量等条件对凝胶过程的影响，得到了较佳的RF凝胶制备条件(RF浓度应大于2%，R/C值取50～300)；初步研究了凝胶过程中的粘度、粒径变化情况，分析了催化剂用量影响凝胶中粒子尺度的原因，在实验上印证了凝胶生长遵循"聚增长"的理论；通过引入超声波改进了RF气凝胶的制备工艺，缩短了凝胶反应时间，提高了凝胶品质，并探讨了超声波促进RF凝胶反应作用的原因；首次用对苯二酚与间苯二酚复配制备了混合有机气凝胶，优化出复配比(对苯二酚含量为10%～40%)。2。

Using the 294cc rotary engine, it can influence the maximum rpm and power of the engine output under the terms of using all kinds of length intake. Then it can find out the best length of intake of the rotary engine. In addition, under the terms of space limit of intake, it can influence the maximum rpm and power of the engine output when the intake is forced to limit on a certain length. To install a resonance in the intake system, according to the equation of Helmholtz, it can design the all kinds of size of the resonance. Using to change the volume and geometirc form of the resonance, it can find out the maximum rpm and horsepower of engine output in order to reduce the influence of the variation of engine intake length. Under the verification of the experimental result, this simple device can increase the rpm and horsepower of the rotary engine obviously to achieve the output performance that the engine requires to supply. Such the revisal of intake need the lower cost but it can obtain very obvious efficiency. It is a very feasible way.

藉由一具294cc的飞行器引擎，在使用各种不同长度进气道的条件下，对引擎所能输出的最大转速及马力有一定的影响，藉此找出该具引擎的最佳进气道长度；此外，在进气道因空间限制的前提下，进气道被迫只能局限某个长度以下时，在这种条件下，引擎所能输出的最大转速与马力等相关性能会随之受到影响，在进气系统加装一个共振腔，配合Helmholtz的方程式，设计出各种共振腔各部位的尺寸，利用改变共振腔的体积与几何形状，可以寻求增加引擎转速与输出马力的最大值，藉此降低进气长度变化所带来的影响，在实验结果的验证下，此一简单的装置可以明显的增加引擎转速与马力，以达到对引擎所需的输出性能要求，这样的进气系统修改所需的费用极低，但却可获得很明显的功效，是十分可行的方式。

The effects of external cross flow, hole geometry and Reynold number in the hole were taken into account.

该算法主要考虑了气膜孔出口主流流动状况、气膜孔几何参数和孔内流动雷诺数对气膜孔流量系数的影响。

scatheless measurement ; numerical simulation ; helium pressure

利用氦气在不同压力下具有不同的状态参数和热力参数，可以通过传热方法测量包壳内的氦气压力。1试验装置和研究方法如图1，把燃料棒浸入到一个高温的池子内，热量会在燃料棒内传递开来，通过测量管壁外面不同位置出的壁面温度，就可以推测到包壳内的氦气压力

This paper is reviewed for importance of gas media used in ceramic-to-metal seal technology, it point out that increasing N2 content of working Gas media made ceramic-to-metal seal safe production, decreeing cost and guarantee quality.

本文所研究的基于气体介质的电火花铣削加工技术主要指气中电火花铣削加工以及相应的超声辅助气中电火花铣削加工和浸液辅助气中电火花铣削加工。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。