毫米

Central awn slightly shorter to slightly longer than its lemma; lateral awns 0–1 mm

中心芒稍短在稍长于它的外稃；侧的芒0-1毫米 10

The axles run in two-row self aligning ball bearings on the gear side, and a standard sealed ball race on the other end in the sprung axle box, both 12mm bore.

两轴运行的排调心方对球轴承齿轮，和一个标准就在轴箱弹簧的另一端密封球的比赛，两个12毫米口径。

Minutes to make a complete backplate (including the 4 holes) out off a massive block It's possible to do it faster but I have been using a 4 mm.

20分钟，使一个完整的backplate指出小康大规模座有可能这样做更快，但我已使用了4毫米。

In the back I want to have a ball bearing 12*21*5 mm.

在后面的我想有一个球轴承12 * 21 * 5毫米。

The front ball bearing will be 8*16*4 mm.

前球轴承将有8 * 16 * 4毫米。

It can be shaped easily from a 2mm thick balsa.

它可以形成很容易从1毫米厚balsa 。

When the gunner aligned his sight onto the target, electrical impulses would be transmitted to the computer, which would control the power system of the barbette and 20 mm guns to coincide with the alignment of the sight, allowing for deflection and the angular differences of the barbette and sight.

当射手把他的瞄准具对准目标时，电子脉冲会被传送到这个计算机，计算机能够控制炮座上的动力系统和20毫米炮与瞄准具指向同一目标。计算机会自动修正瞄准具和炮座之间的位置和角度的差别。

There, Endeavour will execute a slow backflip maneuver, presenting its belly and other areas of its heat protective tiles to station residents Barratt and Padalka, who will use digital cameras equipped with 400 and 800 millimeter lenses to acquire detailed imagery.

在那儿，奋进号将完成小速度机动，将翻转机腹和机身其他区域的隔热瓦面向位于空间站上的Barratt 和Padalka，他们将使用400和800毫米镜头的相机对航天飞机进行详细拍照。

"Collection" series, barrel-shaped section of the table to say it seems very simple, but from an aesthetic point of view, it is necessary to make a symmetrical and harmonious watchcase bucket is indeed very difficult, even if only both sides of the ratio of bias the thousandths of millimeters, also can not tell where people feel it is wrong to feel uncomfortable.

"典藏"系列，酒桶形的表款说起来好像很简单，可是从美学的角度来讲，要做出对称而和谐的桶形表壳，确实是很难的，两边的比例就算只偏差了千分之一毫米，也会让人有种说不出哪里不对却就是不舒服的感觉。

All angle connections at base of column sections and/or anchor plates at column base shall have hole diameters a maximum of 1/4 inch (6 mm) larger than the anchor bolts diameter.

柱子截面底部的连接角，或柱子底部的地基板应该设有孔，孔的最大直径比地脚螺栓的直径大1/4 英寸(6 毫米)。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。