母线

To uninstall pressure release board before bus bar installation, the board and bolt all keeping kindly.

主母线安装前应先卸下开关柜顶部的压力释放板，这些释放板和螺钉都应妥善保管。

The company has five bus production line, annual production capacity of 3000 tons.

公司拥有5条母线生产线，年产3000吨。

It simulates the circuit breaker with a zero impedance branch, and adopts the linear network characteristic and theory, variable structure and variable parameter analyses to transfer the short-circuit current flow in the bus-bar equality into each side of circuit breaker, and deduces the sequence component model and algorithm for calculating the short-circuit current of circuit breaker when the short-circuit fault occu...

该方法将断路器作为一条阻抗为零的支路来模拟，运用线性网络特性、定理及变结构与变参数的分析方法，将母线上短路时的短路电流等值转移到断路器两侧，导出了相当于在断路器两侧分别发生短路故障时，流过断路器的短路电流的序分量模型和算法。

From the burden increased aspect clarify set up the necessity of station, then pass to drew up to set up generalize of transformer substation and line direction to consider, and pass to analysis of carry the data, safety, economic and dependable consider and made sure the 110 kV, 35 kV, 10 kV and station use electricity of lord connect line, then again through burden calculation and power supply scope made sure main number, capacity and model number of the transformer set, also in the meantime make sure the station uses capacity and model number of transformer, end, according to biggest keep on work electric current and short circuit calculating of calculation result, to the high pressure Rong break a machine, insulate a switch, female line, insulate son and wear a wall set tube, electric voltage with each other feeling machine, electric current with each other the feeling machine carried on choose a type, thus completed a 110 kV electricity a part of design.

本文首先根据任务书上所给系统与线路及所有负荷的参数，分析负荷发展趋势。从负荷增长方面阐明了建站的必要性，然后通过对拟建变电站的概括以及出线方向来考虑，并通过对负荷资料的分析，安全，经济及可靠性方面考虑，确定了110kV ，35kV ，10kV 以及站用电的主接线，然后又通过负荷计算及供电范围确定了主变压器台数，容量及型号，同时也确定了站用变压器的容量及型号，最后，根据最大持续工作电流及短路计算的计算结果，对高压熔断器，隔离开关，母线，绝缘子和穿墙套管，电压互感器，电流互感器进行了选型，然后进行配电装置和平面布置的设计以及防雷的设计，从而完成了110kV 电气一次部分的设计。

The test results indicate that,because of the capacitive coupling between500kV high voltage line and400V power-supply line,high voltage was induced on the power-supply line during the isolator operation.

试验结果表明，开关操作时由于500kV串内连接线和400V电源线间存在电容耦合，在操作电源供电母线上有较高的感应电压存在。

Another MCU, 89C2051 is used to realize the control of the three rows LED monitor showing coordinates of axis X and Z axis and other state of the system. Charnel A and C of 8155 are used for editor keyboard, which make the inputting or editing of the NC code and data possible. Charnel P1 of 8031 is used for the operation keyboard such as system power on/off and movement of axis X or Z. a programmable parallel I/O chip, 8255, is used to achieve system I/O and the transmission of other information. In summarize, the system developed is characterized by its simplicity, low development cost and high reliability.

在CPU存储器扩展电路设计中， CPU选用MCS-51系列的8031单片机，外扩32K的程序存储器和 8K的数据存储器，分别用于存放系统管理程序、数控加工程序以及运算数据；在显示电路设计中，选用MCS-51系列的89C2051单片机作为从CPU，控制三排LED显示器，用于X轴、Z轴动态坐标以及相关数字的动态显示；在手动键盘和编辑键盘设计中选用8155芯片的PA口和PC口作为行、列母线，扩展矩阵式编辑键盘，用于程序和数据的输入或编辑，同时选用8031单片机的P1口扩展手动键盘，用于系统启动、停止以及运动部件在X、Z轴方向的手动控制；在I/O口扩展电路设计中选用8255芯片扩展输入输出口，用于接收和传送开关量及相关信息。

The shape of the generator of liner surfaces was described with a function in the form of circular arc with additional terms.

在构造药型罩旋转面母线函数的近似函数时，采用了在圆弧基础上加修正项的函数形式。

A conic section whose plane is not parallel to the axis,base,or generatrix of the intersected cone.

圆锥的一部分，其切面既不平行于轴和基面，也不平行于圆锥母线

Because the main frequencies of generator floor and bus bar floor are in the range of earthquake, so their convulsionary reaction is obvious.

结果表明，对于发电机层和母线层的楼板，其地震反应仍以竖向振动为主，对于风罩，以机组段纵向为主。

A projection method is used to smooth out start and end points of the ruling line sets. With predefined Euclidean 6 space distances, the problem of ruled surface approximation from line sets in Euclidean 3 space can be converted into a least square B-spline curve fitting issue in Euclidean 6 space.

利用"投影"光顺法对齐直母线段族首末端点，再通过定义欧氏6空间下的距离函数，将欧氏3空间下的直线族逼近直纹面问题转换成欧氏6空间下B样条曲线最小二乘拟合问题。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。