母线

Was established in March 2008, mainly to sales of coal as the main equipment: Mine fan, Hair Dryers Mine, mine hoist, cars, light rail, the chute, wire rope, and rolling, LED light source Miner'slamp cold, anti-explosive coal locomotive, mining scraper plane, trailing bucket ROCK LOADER, anti-explosive switches, optical instrument seized Watts, Alarm, self-help, electronic wind table, monitoring systems, mine cable, blasting - Lines, such as bus blast.

重庆市立迅矿山设备有限公司成立于2008年3月，主要以销售煤矿设备为主体：矿用风机、矿用风筒、矿用提升绞车、矿车、轻轨、溜槽、钢绳、地滚、LED冷光源矿灯、防爆煤机车、矿用刮板机、耙斗装岩机、防爆开关、光学瓦检仪、报警仪、自救器、电子风表、监控系统、矿用电缆、爆破子线、爆破母线等。

The electrical and mechanical jointing of the trunking elements is achieved by a special connect.

两段母线间的机械及电气连接通过双面接触的特殊连接器来完成。

This paper analyzes the unbalancing problem of neutral-point voltage with light load in DC-Rail ZVT soft-switching inverter.

分析了轻载时直流母线零电压过渡软开关逆变器存在的中点电压不平衡问题。

Switchgear 11000v Single bus-bar 11000v 25kA 95kV BIL metalclad withdrawable modular switchgear.

开关11000v单母线11000v 25ka 95kv胆红素金属包层可更换模块化开关柜。

This paper presents a new reactive power compens ator to reduce the negative and zero sequence components of load currents and to improve the load bus power factor of unbalanced three-phase three-wire and three-phase four-wire distribution feeders.

提出了一种用于补偿不对称负荷产生的负序、零序分量并调整负荷母线电压，且适用于三相三线制和三相四线制系统的新型无功补偿器。

The new compens ator consists of a three-phase voltage source inverters(to eliminat e negative sequence current and adjust reactive power)and a single-phase voltage source inverters(to eliminate zero seq uence current).

该补 偿器由用于补偿负序分量并调整负荷母线电压的三相电压型逆变器和用于补偿零序分量的单相逆变器组成。

By rotating the X-axis of the measurement coordinates, the straightness data of each generatrix are transformed into a unified 3D coordinate system whose Z-axis superposes the least square mean axis calculated with the data of the multiple generatrices. The computer simulations and experiments prove that the construction by rotating the abscissas can effectively eliminate the distortion of the constructed profile.

通过测量坐标系中X轴的旋转，将各条母线直线度偏差数据统一到同一个空间坐标系中，采用两端面圆的最小二乘轴心的连线作为零件轴线，消除了直接构造所带来的表面变形，并能进一步计算出被测内孔的直径、圆度和轴线直线度误差，使测量系统集成化和多功能化。

In this strategy, different start-up commutating instant under different source voltages are collected first.

该方法首先通过改变母线电压值，采集相应的起动换相时刻数据样本。

An algorithm for the 3D profile construction of the measured surface with the straightness data of multiple generatrices is suggested and realized.

提出并实现了利用多条母线的直线度测量数据构造被测表面三维模型的算法。

The results show that when the cone angles are equal to a series of special values incident beams normal to the bottom surface of a cone passing through this cone will exit along its generatrices,and form a circle-type spot on the plane perpendicular to the axis of cone,all its energies is concentrated in the circle.

结果显示圆锥体的顶角等于一系列特定值时，垂直圆锥体底面入射的光束经过该圆锥体后光束沿着其母线方向出射，在垂直于圆锥体轴线的平面上形成一圆周型光斑，其光能量全部集中在圆周上。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。