残余

Finally, we simulate the relationship of the residuary intensity modulation coefficient and the scale factor stability of fiber-optic gyro by using the Matlab simulation tool.

最后，对所得出的残余强度调制系数与光纤陀螺标度因数稳定性的关系进行了Matlab 仿真，通过仿真结果，更进一步说明残余强度调制对数字闭环光纤陀螺标度因数稳定性的影响。

Finally, we simulate the relationship of the residuary intensity modulation coefficient and the scale factor stability of fiber-optic gyro by using the Matlab simulation tool. The simulation results further explain the effect of residuary intensity modulation on digital closed-loop fiber-optic gyro scale factor stability.

最后，对所得出的残余强度调制系数与光纤陀螺标度因数稳定性的关系进行了Matlab仿真，通过仿真结果，更进一步说明残余强度调制对数字闭环光纤陀螺标度因数稳定性的影响。

Through the interferencing light intensity under a sine-wave modulation signal analysis, the output signal of fiber-optic gyroscope is demodulated. And then the change of the output signal of gyro is gotten. Through the analysis of the change we know that the effect of residuary intensity modulation on the performance of Interferometric Fiber Optic Gyroscope is related with the precision and accuracy requirements of IFOG. The higher precision, the more obvious effect.

本文首先通过正弦波调制下干涉信号光强分析解调出光纤陀螺的输出信号，进而得出残余强度调制存在的情况下陀螺输出信号的变化情况，同时，通过分析陀螺信号的变化说明残余强度调制对光纤陀螺性能的影响与陀螺精度要求有关，精度越高，其影响越明显。

Those rarely refer to the researches about water pressure function mechanism. In fact, the water flow intrudes upwards with a loss of the distance water and energy wastes for splitting rocks when confined groundwater intrudes upwards through coal seam water-resisting layer. The water flow under the coal seam scaleboard consumes more energy after it intrudes at a certain height.

实际上，煤层底板高承压含水层水沿隔水底板岩层向上导升过程中，存在一定的沿程水头损失和劈裂岩体裂隙的能量损耗，下伏含水层高压水在底板隔水层下部劈裂导升一定的高度后，在导升段的能量消耗很大，这时作用于有效隔水层段下部的实际水压已远远小于含水层中的观测水压，真正作用在有效隔水层上的水压为残余水压P_c，对底板有效隔水层起破坏作用的有效水压力亦应为残余水压。

A method of eliminating the residual vibration of redundant flexible robot manipulators is put forward. The endpoint residual vibration can be reduced easily through optimizing the joint self-motion.

继而提出了利用自身运动进行开环控制以消减冗余度柔性机器人残余振动的方法，在机器人末端运动停止后，通过选择最优的关节自运动，使末端的残余振动尽快消减下来。

The residual stress in the thickness after one LP and multi-LP and the distribution of residual stress after single pill and multi-pills shot the sheet metal are analyzed.

数值模拟分析了激光单点喷丸板料后，材料厚度方向的残余应力分布，以及激光多点。多排喷丸板料后材料厚度方向的残余应力分布。

The flatness quality problems such as sidewise bending and warping usually appear in hot rolled sheet product. Residual stress distribution of hot rolled steel sheet before and after straightening was obtained by modified hole–drilling technique, in order to improving the quality of hot rolled steel sheet product.

本文针对热轧钢板产品常出现的旁弯、翘曲等板形质量问题，通过盲孔法测量钢办矫直前以及粗矫、精矫后的残余应力分布来分析矫直工艺对带钢残余应力分布的影响，以便改善热轧钢板产品的质量。

Relatively speaking, the drawing for tube with fixed short plug technology would reduce the difference of the residual stress between inside and outside of the tube, and increases its uniformity.

外模半锥角对固定短芯头拔管材的轴向残余应力具有显著的影响；当半锥角为12 时，拉拔后管材的轴向残余应力值较小且分布均匀。

The residual stress distribution of the tangential residual stress,the hoop residual stress and the normal residual stress test of spiral seam arc weld pipe were studied on the basis of elastic mechanics analysis and superposition theorem.

基于弹性力学应力分析和叠加原理，研究了螺旋缝埋弧焊管切环法残余应力测试中的残余应力分布。

Probe into theory of X-ray diffraction testing residual stress in glass-ceramic and effect on accuracy of stress with the X-ray diffraction.

探讨了X射线法测量微晶玻璃残余应力的原理及该方法对残余应力值精确度的影响。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。