正火

According to the original plan to plant gum ebastine oncontour des cription, yin to write off a bit of the solid line that the leucogranites part of the dashed line just like the Internet image dot propomon descend to steam-and-ink, the line displayed is referred to as "blue mold" in translucent Lithographing of adhesive tape, then to bandnoise and extracranium needle stroke, put on, and then charged with paste paper will be charged against print-out, transfer to a long fibers'interface scourability yarn of paper, to sweep the LAN Dian powder, and will be responsible for the falling rocks, flushed with water, it emerged, each color will have to follow the program falls, injuring a writing brush and steam riemerella Tsui pen-and-ink hand according to the profile, the tone of a dense gradient is vvibdv Tsui pen point network.

照原图以植物胶依边框勾描，晴位部以不实线表现，浅色局部以实线不离像上钩图像的深浅网不面比例，以汽火不朱不兵线条表现不入来，称为「蓝模」，刻画在半透明的石印胶纸上，再以针笔勾瘪纹，擦上黑不朱，再用浆糊纸不兵黑不朱不正印不入来，转印于一种不幼纤维的冲纱纸上，以蓝靛粉扫上，再不兵之功降石上，以火冲刷，边框便呈现不入来，每一个印色便给依步调降一块石，再以羊毫及鸭咀笔用汽火不朱依边框手描，浓不浓不突变色调则给用幼咀钢笔不面网。

In the present study, the effect of pre-heat treatment of isothermal normalizing on the structure and performance of 20CrMoH gear steel were studied, and the effects of the parameters of different carburizing on the microstructure in carburized layers of the steel were also investigated.

本文研究了20CrMoH 汽车齿轮用渗碳钢的预先热处理等温正火工艺对组织和性能的影响，还研究了不同渗碳热处理工艺参数对渗碳层显微组织的影响。

The corrosion characteristics in water, 5% HCl solution and 5% HNO3 solution of the coatings on 45 steel cladded by electrospark deposition with Cr, W, Mo and Ni anode was studied.

对正火45钢基体上的Cr、W、Mo和Ni电极电火花熔涂层在水、5vol%盐酸及硝酸水溶液中的腐蚀行为进行了研究。

Today, salt-bath stove is still one of the main heating equipments in the heat-treating workshops.

盐浴炉是热处理车间的主要加热设备之一，多用于零件的淬火、回火、正火等处理。

For common structural steel parts with not very high mechanical properties , normalizing can be used as final heat-treatment.

对于普通结构钢零件，机械性能要求不很高时，可以正火作为最终热处理。

After 25% deformation and normalizing at 980℃ for 2 hours, the impact toughness and wear resistance of the cast iron increase by 71.95% and 8.6%, respectively.

该铸铁经25%变形后再经960 ℃保温3 h正火处理后的冲击韧性和滑动磨损性能分别提高71.95%和8.6%。

The manufacturing process of the H22-40SiMnCrNiMoA taper connected drill rod is provided.

以上是40SiMnCrNiMoA钢中780℃×30min亚温正火处理的主要强化机理。

Before 1949, Beijing has heat treatment furnace, salt dissolved by thermocouples means furnace, quenching and tempering, parts of annealing, normalizing, quenching and tempering, carburizing and etc.

热处理 1949年前，北京已采用电炉、盐溶炉、热电偶等手段进行零件退火、回火、淬火、正火、调质、渗碳等热处理。

This series 1350℃Temperature Box type Resistance Furnace, mainly used for steel products, high speed steel, all kinds of mold normalizing, quenching, annealing and other heat treatment, solid stainless steel melt-processing, various ceramic products, ceramic roller sintering, of which SX2 series of laboratory experimentsfurnce for chemical analysis purposes.

本系列1350℃高温箱式电炉，主要供合金钢制品，高速钢，各种模具正火，淬火，退火等热处理，不锈钢固熔处理，各种陶瓷制品，陶瓷轧辊烧结，其中SX2系列实验电炉可供实验室做化学分析用途。

This series 1350℃Temperature Box type Resistance Furnace, mainly used for steel products, high speed steel, all kinds of mold normalizing, quenching, annealing and other heat treatment, solid stainless steel melt-processing, various ceramic products, ceramic roller sintering, of which SX2 series of

本系列1350℃高温箱式电炉，主要供合金钢制品，高速钢，各种模具正火、淬火、退火等热处理，不锈钢固熔处理，各种陶瓷制品，陶瓷轧辊烧结，其中SX2系列实验电炉可供实验室做化学分析用途。

For a big chunk of credit-card losses; the number of filings (and thus charge-off rates) would be rising again, whether

年美国个人破产法的一个改动使得破产登记急速下降，而后引起了信用卡大规模的亏损。

Eph. 4:23 And that you be renewed in the spirit of your mind

弗四23 而在你们心思的灵里得以更新