次轴

Then we use IEEE First Benchmark system model and the 500kV system which contain 500MW and 600MW turbo-machines, as typical examples, the shaft systems without exciter in these examples are also analyzed on its impact on torsional oscillation.

首先对采用静止励磁方式的汽轮发电机轴系建模进行了说明；然后以IEEE次同步谐振标准模型和东北电网中伊敏电厂计划安装的500MW和600MW汽轮发电机组为典型算例，研究了改用静止励磁方式对轴系扭振的影响。

Because on the turnplate axis power is by the turnplate under after the bevel gear commutation, decelerates transmits, moreover their velocity ratio is 6, also because the bevel gear velocity ratio is not bigger than 3 generally, therefore has designed two axes, by realizes the bevel gear two commutation, decelerates.

因为转台上的轴动力是由转台下经锥齿轮换向、减速传来的，而且它们的传动比为6，又因为锥齿轮的传动比一般不大于3，所以多设计了两根轴，以实现锥齿轮的两次换向、减速。

After analyzing the earth pressure, struts axial force, walls deflection, soil upheave, walls axial force and moment obtained from two tests, we have a good grip of the mechanical characters of PDW and consider that the lateral skin friction between walls and soil is the key to propose a theory about PDW.

在对两次试验中土压力、支撑轴力、墙体变形位移、土层隆起沉降、墙体轴力和弯矩等实测结果进行了深入分析后，加深了对预应力地下连续墙结构力学性状的理解，认为反映墙——土剪切共同作用的侧摩阻力是预应力地下连续墙设计计算理论研究的关键。

Loaded the simulated acetabular cup at an inclination of 35°, 40°, 45°, 50°, 55° to 6 cadaver pelves. Made the pelves tilt around the frontal axis and sagittal axis with 5° each time in a scope of ± 30°. Take standard radiograph of the pelvis accordingly.

按35°，40°，45°，50°，55°外展角分别放置于6具防腐骨盆标本髋臼窝内，使骨盆标本沿冠状轴、矢状轴在±30°的范围内按5°/次分别旋转，保持X射线投照中心点始终与标准骨盆正位片投照中心点一致。

For example, you might have the main sequence beam in your program controlling a robot's forward motion but have a second sequence beam controlling a robotic arm that sits on top of the robot.

举例来说，可以让主程序轴控制机器人向前移动，同时让次程序轴控制其手臂的动作。

The quadratic regression orthogonal rotary method was adopted to study the offect of three different mixing homogeneity : mixing time, block coefficient and rotary speed of the paddle shaft, also study the dominant effect, the single effect and interactive effect.

通过二次回归正交旋转组合试验，对影响翻转式双轴桨叶混合机混合均匀度的3个因素(混合时间、充满系数及桨叶轴转速)以及对混合的主效应、单因素效应、两因素间的交互效应进行了分析，并且得出了各因素水平间的最佳组合工艺。

And the "three-factor quadratic regression orthogonal rotary method" was adopted to study mixing performance of the mixer,after the machine had been designed and trial-produced. It was showed that the optimum technological parameters for mixing time, block coefficient and rotary speed of the paddle shaft were 180 s, 0.75 and 56 r/min, respectively. At the same time, the remains in the bin was little (0.015%). The effe...

为了提高双轴桨叶混合机的混合性能，采用二次回归正交旋转组合试验，对设计样机进行混合均匀度及机内残留率的试验研究，得出了其工作参数的合理组合：混合时间为180s，充满系数为0.75，桨叶轴转速为56r/min；机内残留量极小(约为0.015%)，满足其作为配合饲料生产，尤其是预混合饲料生产的工艺要求，也为进一步改进设计提供了依据。

Packing ring preparations 1 braided At the appropriate size of the axis of winding packing or packing ring using calibrated cutting machine; upon request, packing neatly cut into the butt, or miter (30-45 degrees), a cut of a ring, and use shaft or stem test size is appropriate.

编织盘根在适当尺寸的轴上缠绕盘根，或使用校准过的盘根环切割机；根据要求干净利落地切割盘根成对接或斜接（30-45度），一次切一个环，并用轴或阀杆检验尺寸是否合适。

Based on the 70 axial force monitoring data on 64 manometers in south tower piles foundation of JiangYin Bridge, the force transferring mechanism of socketed pile group using friction ineffective treatment at the top 20 meters was analyzed. The surcharge problem, the course of stress adjustment and the transition of the slip surface on which was easiest to slide in pile group were discovered.

根据江阴大桥南塔墩基桩轴力64个测点的70次观测成果，分析了桩周摩擦失效嵌岩群桩的传力机理，揭示了群桩中的超载问题和应力调整过程以及最不利滑面的迁移；采用理论计算、定性评价和数值分析相结合的方法首次建立了基桩轴力安全监控模型。

Optimum extraction conditions were determined as follows, to blade, temperature 80℃, time 2 h, 80% EtOH as extracting solvent, the ratio of solid to liquid 1:10, extracting for three times, the extraction rate of total flavonoids 61.13%; to rhachis, temperature 80℃, time 1 h, 70% EtOH as extracting solvent, stock ratio 1:10, extracting for three times, the extraction rate of total flavonoids 71.71%.

结果表明，在浸提3次条件下，得到叶片总黄酮最佳工艺条件为：乙醇浓度80%、固液比为1：10、提取温度80℃、提取时间2h，在此条件下香椿叶片总黄酮提取率为61.13%；叶轴总黄酮最佳提取条件为：乙醇浓度70%、固液比为1：10、提取温度80℃、提取时间1h，在此条件下香椿叶轴总黄酮提取率为71.71%。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。