次优化

Therefore, because any recommendations will be implemented for the first time, organizations may not feel they are reinventing the wheel or spending additional money to recreate already-established controls.

情景2----公司缺乏适当的安全基础设施，当优化建议第一次被执行的时候，客户可能觉得这是多此一举或花额外的钱来再次重建已经建立好的控制系统。

Regression equal between traction resistance and partial sphere height, bottom circle radium was set up to explore the effect of two evident factors(height and bottom circle radium of the partial sphere) on traction resistance by optimum calculation.

采用二次回归试验设计的方法，建立了球冠高度和球冠底圆半径大小与牵引阻力间的回归方程，进行了优化计算，进一步考察了球冠高度和球冠底圆半径大小两个显著性因素对牵引阻力的影响规律。

Research on Using Rice Hull to Extract Arabinoxylan s;2. Study on the Inheritance and Variation of Arabinoxylan s in Hard Wheat;3. In order to enhance the extraction yield of arabinoxylan from wheat bran,the effect of temperature,time,the concentrations of sodium hydroxide and hydrogen peroxide and shaking speed on yield of arabinoxylan were investigated.

为提高小麦麸皮中阿拉伯木聚糖的得率，本研究在考察了温度、时间、碱液与H2O2浓度和振荡速度等单因素对阿拉伯木聚糖得率影响的基础上，采用二次回归正交旋转组合设计对阿拉伯木聚糖的碱提工艺条件进行了优化并建立数学模型。

The experiment and the research indicate that:(1) Through the Hot-Continuous-Rolling production technics under small reduction ratio of 4.04 and 5.08, the rectangular continuous-casting billet of 235×265mm can be used to produce big size steel stick of Φ140mm and Φ 125mm whose macrostructure and mechanical properties meet the standards, this technics is viable;(2) This rolling technics can make the deformation penetrate to the center of the billet by low temperture and low velocity and big roller diameter and large reduction quantity at every pass and optimum design and arrangement of rollers, which is the key of Hot-Continuous-Rolling technics under small reduction ratio;(3) The sending technics used in Xining Special Steel Co.,Ltd can not use waste-heat of billet adequately, but the sensitive temperature section of A1N or sulphides or inclusions separating out is avoided, creating a favorablecondition for insuring good surface quality of final rolled steel;(4) The Hot-Continuous-Rolling technics under small reduction ratio has a close relationship with the billet quality control and the hot sending process control and the cooling control after rolling.

通过实验研究表明：(1) 235×265mm矩形连铸坯分别采用4.04和5.08的小压缩比热连轧生产工艺，所生产的Φ140mm和Φ125mm的大规格棒材，其低倍组织和机械性能均符合标准要求，该工艺是可行的；(2)本实验所采取的低温低速、大辊径大道次压下量轧制工艺加上轧辊孔型的优化设计与配置，可以使加工变形渗透到铸坯的中心，这一点是实现小压缩比热连轧生产工艺的关键；(3)西宁特钢在红送过程中虽然铸坯余热未能得到充分的利用，但是有效地避开了A1N、硫化物的析出及夹杂物偏析的敏感温度区，为保证最终轧材良好的表面质量创造了有利的条件；(4)小压缩比热连轧生产与铸坯质量控制，热送过程控制以及轧后冷却控制密不可分。

Mathematic models between yield and N fertilizer and plant density for two peanut variety types were set up by using quadratic saturation D-optimization design under single-seed planting.

采用二次饱和D—最优设计建立了精播条件下不同类型花生品种N肥用量和密度与产量的数学模型，探讨肥料与密度的产量效应及优化配置。

Substation automation is the secondary substation equipment (including measuring instruments, signal systems, relay protection, automatic devices and remote devices, etc.) through a combination of functions and optimize the design, use of advanced computer technology, modern electronic technology, communication technology and signal processing technology, on all major substation equipment and transmission and distribution lines of automatic monitoring, measurement, automatic control and computer protection, and integrated communications and scheduling automation features.

变电站综合自动化是将变电站的二次设备（包括测量仪表、信号系统、继电保护、自动装置和远动装置等）经过功能的组合和优化设计，利用先进的计算机技术、现代电子技术、通信技术和信号处理技术，实现对全变电站的主要设备和输、配电线路的自动监视、测量、自动控制和微机保护，以及与调度通信等综合性的自动化功能。

As for the serrated phenomenon on image edges, the algorithm interpolates the image edges with the bi-cubic algorithm when interpolating. Thus, the visual effect on edges can be optimized.

针对图像边缘处的锯齿现象，该算法在图像插值时对边缘像素采用双三次插值，优化了图像边缘的视觉效果。

Novozym 435 was used for the synthesis of vitamin A plamitate. The influences of solvent, the molar ratio of substrates, the reaction temperature and time, and the water concentration were optimized and the best result was obtained by interesterification from 0.200 g vitamin A acetate and 0.468 g palmitic acid, at 30℃, in 10 mL hexane, containing 0% of water, with 10% of lipase(mass ratio, immobilized lipase to vitamin A plamitate). In these conditions, 75% of vitamin A acetate was converted into vitamin A plamitate. The immobilized lipase was reused about 6 batches.

对催化合成维生素A棕榈酸酯反应的脂肪酶和反应介质比较，同时对影响合成维生素A棕榈酸酯反应的因素（温度、初始水含量、底物摩尔比、反应时间和酶量等）进行了探讨，优化了反应条件：在10 mL不含水分的正己烷中，0.200 g 维生素A醋酸酯和0.468 g棕榈酸在酶量为10％（指固定化酶与维生素A醋酸酯的质量比）的固定化脂肪酶催化下，在 30℃、190 r/min下反应6 h，转化率可以达到75%，固定化酶可连续使用6次以上。

Systemic works was carried out on the followed area, the surface modification of templates, the optimization of roll-press technique, the reason and simulation of crack formation in RPCs using FEM , the investigation of the two-step centrifuging technique.

在对工艺过程深入研究的基础上，通过有机泡沫体的表面处理、辊压工艺的优化、缺陷形成原因及有限元计算结果的分析、两次离心挂浆工艺及其影响因素等方面做了深入系统的研究，并为具有可控结构网眼多孔陶瓷的制备提供了一条崭新的途径。

The optimized conditions for isolation and culture of endophytic bacteria isolated from grasses in alpine area in this study. The different tissues of grasses were immersed in 0.1% of SDS for 15 min, 3% of NaClO for 3 min, 0.1% of mercuric chloride for 10 min, 75% of alcohol for 1 to 2 min. The endophytic bacteria were isolated after aseptic grinding and diluted to 10^(-3) and using TSA culture medium for 5 to 7 days under 28℃.

通过对高寒牧草内生细菌的分离培养方法研究，得出了优化的分离培养条件，即牧草不同组织器官用0.1%SDS浸泡15min、3%NaClO浸泡3min0.1%升汞浸泡10min、75%酒精1~2min处理后（各步间均用无菌水冲洗3~4次），研磨并稀释至10^(-3)，涂布于TSA培养基上，置28℃恒温条件下培养5-7d，可从高寒牧草组织中分离获得数量、种类较多的内生细菌。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。