横向的

In this paper,the method of weighted residuals is employed to analyze the bending problems of anisotropic skew plates.

近几年对各向同性斜交板的横向弯曲问题有过不少的分析方法仁，一'〕。

In addition,it is found that the width of the corresponding waveguide of the rectangular cavity has an essential effect on the number of solutions for the resonance condition equation.

结果表明，随着横向尺寸的减小亚波长谐振条件的物理解数量将逐渐增多直至趋于无穷。

The reticle consists of two horizontal marks and the inverted V-shaped center mark, that allows for faster target acquisition.

该标线由两个横向商标和倒V形中心的标志，即更快的目标捕获允许。

Craft Fence horizontal roll ring ring stiffener, at the same time increase the overall costs low, so that networks face a significant increase in the strength and beauty, is currently at home and abroad, one of the most popular road isolation network.

工艺护栏网采用横向卷圈环状加强筋，在整体成本增加不多的同时，使网面强度和美感显着增加，是目前国内外最受欢迎的道路隔离网之一。

This paper proposes that willow bushes are used to prepare plate,and introduces the experiment and results.Fiber reinforced technology is introduced into scriber's reinforcement.

纤维束定向板材(也称重组木Scrimber)是近30年来，国内外人造板研究发展的最新技术，它是利用横向不断裂、纵向连续的木束，经干燥、铺装、施胶和热压而成。

SKID TEST. PART 4: METHOD FOR MEASURING THE TRANSVERSE SKID FACTOR WITH A SCRIM DEVICE.

打滑试验。第4部分：带有沙罩装置的横向打滑因子的测量方法。

The fluctuating mangnetic field cutting across the turns or loops of wire of the secondary coil sets up an electrical pressure or voltage in these loops.

起伏变化的磁场横向切割着次极线圈的线匝和线环时，会在这些线环中引起电压。

Dough per hour. Sheeter should have both vertical and horizonttal cutters.I think I wrote all this to you before.

这种切割机每小时至少应该有能力切割70至100公斤的东西，切割机应该有纵向和横向切片，我想之前应该告诉过你的。

We need sheeter which can make this and it should have capacity to make at least 70 to 100 kg. dough per hour. Sheeter should have both vertical and horizonttal cutters.I think I wrote all this to you before.

这种切割机每小时至少应该有能力切割70至100公斤的东西，切割机应该有纵向和横向切片，我想之前应该告诉过你的。

Due to the characteristic of high tension during cold rolling and the transverse flow in cold rolling different from hot rolling, the Shohet criterion, which is universally used in hot rolling, is not applicable to cold rolling.

由于冷轧过程的大张力轧制特点以及金属横向流动性与热轧有很大区别，因此在热轧中广泛应用的Shohet判别式不能很好应用于冷轧。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。