横

Length 295 ~ 360 mm; head, neck, chest and upper back for the gray stone; on the back and chest with metal flashing green and purple, back for the rest of the light gray; wings have a black cross on the spot; slate gray tail feathers , To the end of its wide horizontal black spot.

体长295～360毫米；头、颈、胸和上背为石板灰色；上背和前胸有金属绿和紫色闪光，背的其余部分为淡灰色；翅膀上各有一黑色横斑；尾羽石板灰色，其末端为宽的黑色横斑。雌雄相似。

Length 295 ~ 360 mm; head, neck, chest and upper back for the gray stone; on the back and chest with metal flashing green and purple, back for the rest of the light gray; wings have a black cross on the spot; slate gray tail feathers , To the end of its wide horizontal black spot. Similar to the male and female.

体长295～360毫米；头、颈、胸和上背为石板灰色；上背和前胸有金属绿和紫色闪光，背的其余部分为淡灰色；翅膀上各有一黑色横斑；尾羽石板灰色，其末端为宽的黑色横斑。

The height or vertical dimension of a flag or of any square sail other than a course.

降下桁木横帆之外的横帆或旗的高度或垂直距离

The results show that homogeneous collagen dispersion can be gained by both methods. But only by the second method can we receive typical cross striation structure which was observed by EM. The solid content and viscosity of the collagen dispersion can be easily controlled.

结果表明：两种方法均能得到均匀的溶胀体，但用酸法提取的材料电镜观察为非横纹结构；而酶消化法提取的材料，电镜照片为典型的横纹结构，胶原溶液的固体含量、粘度等指标可控制。

The results show that the formation mechanisms of the event are as follows.(1) The strong warm advection of 500hPa over the west Europe led to a blocking high created in Siberia area, and a zonal though, the north-east stream in the north edge of the though led to super polar cold air and the cold air from west together and got to strengthen, and then the abnormally strong cold high, front zone, cold temperature center and cold temperature advection appear.

结果表明：这次寒潮及寒潮天气主要成因是(1)西欧上空500hPa强暖平流致使在西伯利亚地区形成阻塞高压，建立横槽，横槽北侧的东北气流引导超极地冷空气和西路冷空气合并加强；形成了异常强的冷高压、锋区、冷温度中心和冷温度平流。

At this time, loosen the connection screw of standard section with spanner, hang the shaft of hand crane on the upper angle bar, sway the shaft of hand crane upward, separate this standard section from the next section, and lay it in the suspension coop, dismantle the other standard section for the same method, and turn the shaft to another direction, draw the lifting wire rope tightly, the operation staff leave the suspension coop, open the lock stopping instrument, fall the suspension coop to next position and lock the brake instrument, the operation staff return to the top of suspension coop, continually dismantle note: forbid the staff leave on the top of suspension coop or in the coop when the suspension coop is running

8.1折除时，首先将吊笼用停层装置停靠在待拆除的标准节的下两节上，操作人员上到吊笼顶，卷扬机松绳，用小吊杆将顶梁略向上提起，拔出顶梁横销，使顶梁值得徐徐降下，降到拆除节下一节中间框架角处，并重新穿上横销，这时用板手将标准节连接螺栓松开，将手摇起重机小吊杆钩挂在待拆节上框架用钢土，到吊笼内，用同样的方法拆下另一节标准节，然后将吊杆转向不影响升降机运行的方向，收紧起升钢丝绳，操作人员离开吊笼，打开锁止机构，使吊笼下降到下一个拆除位置，并将锁止机构锁死，人员重返笼顶，进行下一拆除循环注意：在吊笼运行时绝不允许有人员留在吊笼顶部或吊笼内

When dismantle the machine, firstly, stop the suspension coop on the lower 2 sections of the standard sections, the operation staff go on the suspension coop top, the hoisting machine loosen rope, lift the pillar with small shaft, pull out the horizontal pin of pillar, let the pillar fall slowly to thedismantled section's middle angle bar, insert the horizontal pin again. At this time, loosen the connection screw of standard section with spanner, hang the shaft of hand crane on the upper angle bar, sway the shaft of hand crane upward, separate this standard section from the next section, and lay itin the suspension coop, dismantle the other standard section for the same method, and turn the shaft to another direction, draw the lifting wire rope tightly, the operation staff leave the suspension coop, open the lock stopping instrument, fall the suspension coop to next position and lock the brakeinstrument, the operation staff return to the top of suspension coop, continually dismantle note: forbid the staff leave on the top of suspension coop or in the coop when the suspension coop is running

8.1折除时，首先将吊笼用停层装置停靠在待拆除的标准节的下两节上，操作人员上到吊笼顶，卷扬机松绳，用小吊杆将顶梁略向上提起，拔出顶梁横销，使顶梁值得徐徐降下，降到拆除节下一节中间框架角处，并重新穿上横销，这时用板手将标准节连接螺栓松开，将手摇起重机小吊杆钩挂在待拆节上框架用钢土，到吊笼内，用同样的方法拆下另一节标准节，然后将吊杆转向不影响升降机运行的方向，收紧起升钢丝绳，操作人员离开吊笼，打开锁止机构，使吊笼下降到下一个拆除位置，并将锁止机构锁死，人员重返笼顶，进行下一拆除循环（注意：在吊笼运行时绝不允许有人员留在吊笼顶部或吊笼内

All patients who underwent bilateral orchidectomy were applied with transverse incision in front of pubic symphysis.

目的 探讨耻骨联合横切口行双侧睾丸切除术的疗效方法回顾分析我院2003年6月～2005年12月收治的25例D期前列腺癌的临床资料，全组行去势治疗均采用耻骨联合前横切口双侧睾丸切除术。

Based on orthogonal function unfolding theory, the transverse fields can be represented as a superposition of waveguide modes. And according to coupled-wave theory, the time-dependent multi-mode coupling-wave equations (or the generalized telegrapher's equations) and the coupling coefficients among the different modes were deduced. The generalized telegrapher's equations are a set of coupled one-dimensional partial differential equations for the amplitudes of the modes.

应用正交函数的展开理论，将变截面波导中的电磁场表示为横电波和横磁波本征模式的级数；然后根据耦合波理论，推导了考虑波导金属壁有限电导率的变截面波导时域多模耦合波方程组及各模式间耦合系数的表达式。

A transcendental function which can be used to express the shape of body sectionis presented here.Fair ship surface is formed by a set of hull lines.

本文提出了用一种超越函数表示横剖线，并用形成一组横剖线，构造出光顺的船体曲面。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐