模拟试验

In this paper, cyclic thermal, tests on threaded fasteners simulating the real reactor internal thermal conditions and analyses of the tests are performed. Influences of the cyclic thermal loads on preloads and fastener structures are studied.

对通过模拟实际联接结构的联接件进行热循环试验和分析，研究热循环载荷对预紧力和联接结构的影响。

The third thermal boundary condition equation joined with the degradation rate of interior wall was used to get the contour of interior wall vs. time under the condition of identical heat flux between fluid and solid in axis direction. The numerical simulation results agrees well with that of measurements.

在气流与固壁之间的热流量沿轴向一致的条件下，通过加入降解退移速率的第三类热边界条件方程，求解出不同时间管内壁面轮廓沿轴向变化情况，模拟值与试验结果基本吻合。

Through two methods measuring cutoff thrust and pressure of com - bustion chamber when testing liquid propellant rocket engine on ground , cu - toff impulse as simulated altitude condition is obtained .

本文叙述在地面条件下试验液体火箭发动机时，通过测量发动机后效段推力与测量发动机燃烧室压力两种方法来求得模拟高空后效冲量，并对这两种方法作简单评论。

In the regular wave experiment, the transverse error of wave height is less than 2%, the repeated error of the wave height is less than 1.28%and the period repeated error is less than 0.2%.

介绍了实验室的造波机系统和造波特性及其在模型试验中的应用，并讨论了实验室内模拟海浪的检验标准及其方法。

The validity of the model is verified by cyclic triaxial test results of Shanghai soft clays.

通过对上海软土的循环三轴试验的模拟，初步验证了模型的合理性。

The results of numerical experiments show that the method has the ability to filter the sample noise from limited number of background error member, to estimate the true background error correlation functions.

试验结果表明：基于球面小波的背景误差协方差模拟方法能够克服由有限背景误差样本引入的取样噪声，有效地估计出真实的背景误差相关函数。

Through the contrast analysis of laboratory model test and numerical simulation, the trueness and rationality of theory were proved.

通过实验室模型试验和数值模拟的对比分析，验证了理论分析的正确性和合理性。

Based on percolation theory , truncated Weibull distribution is used as the pore throat distribution function, a two phase and 3 dimensional quasi-static network model is established to simulate the primary oil displacement and secondary water flooding of reservoir cores.

结合逾渗理论，采用截断威布尔分布作为孔喉特征分布函数，模拟储层岩心的初次油驱过程和二次水驱过程，建立了油水两相三维准静态孔隙网络模型；通过模型计算与试验结果的对比，验证了孔隙网络模型的有效性。

Numerical Simulation of Liquid Steel Flow Characteristics in Centrifugal Flow Tundish for Continuous Casting

采用数值模拟对离心中间包内的钢液流动特性进行了研究，考察了分配室中挡坝的位置及旋转磁场强度对整体流场结构的影响，并通过试验验证了计算结果的可靠性。

The principle of partial discharge detection of gas insulation switchgear with ultra high frequency is discussed.A 220 kV GIS bus bar cavity is adopted as a test object to design and simulate four typical defect models in GIS.The PD signals produced by the four models are obtained via the PD detection system,which is developed by the authors on the basis of the narrow band UHF method.

为了提高GIS运行的可靠性，笔者简要说明了超高频法检测GIS局部放电的原理，并在实验室以一段220 kV电压等级的GIS母线为试验对象，设计和模拟了GIS中典型的4种局部放电模型，并使用自主研发的超高频窄带检测系统对其局部放电信号进行检测。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。