模拟实验

In a recirculating photocatalytic reactor,the degradation of low concentration butyraldehyde , a gaseous pollutant,over the catalyst was performed.

利用二氧化钛与活性炭共水热处理的方法制备了TiO2/AC复合催化剂，采用空气净化评价装置对其催化降解低浓度气体污染物丁醛的性能进行了模拟评价实验。

And the calculation method of theresistance modulus has been given by rule and line. The flow state in the pipeline of the densecolloid slurry is carried on numerical value simulation by the software CFD Fluent, which hasbeen grasped. And the critical flow velocity of the dense colloid slurry in the different ratio ofbetween water and earth is obtained by numerical calculations.

通过使用 CFD 软件 Fluent 对稠化胶体泥浆在管道内的流动状态进行了数值模拟，获得了稠化胶体泥浆在胶体流动性实验台管路中流动时的流型，并且通过计算得到了稠化胶体泥浆在不同水土比下的临界流速。

It is showed that the results obtained by computer chemistry simulation are in agreement with that by capillary electrophoresis.

结果表明，计算机化学模拟手性识别的结果与毛细管电泳实验结果相吻合。

In this thesis, the unsteady flow fields around two-dimensional oscillating cascades are studied numerically and experimentally.

本文对二维振荡叶栅的非定常流场进行了数值模拟和实验研究。

In order to improve the operation frequency, the self-suck resonator pulse detonation engine was founded, the ignition principle of the new engine use the method of shock focus autooscillation, so, it possess high ignition and operation frequency, many experts have taken experiment and numerical simulation. However, the physical processes in the resonator cavity are very complicate,the reliable theory haven't set up by now, require the further study.

为了提高脉冲爆震发动机的工作频率，自吸气共振型脉冲爆震发动机模型被提出，该新型发动机点火原理采用激波谐振聚焦点火方式，具有很高的点火及工作频率，许多专家对此进行了实验研究和数值模拟，但由于谐振腔内的物理过程非常复杂，到目前为止没有一套可靠的理论，有待于进一步研究。

This dissertation studied the overcompensatory responses of cotton,Gossipium hirsutum L. plants to leaf loss, square loss and cell sap lossand the changes in some physiological and biochemical contents with timein the case of overcompensation. The artificial defoliation, early squareremoval and aphis colonization were used as three types of simulated ornatural herbivory. The target of this study is to elucidate thephysiological mechanism of cotton plant overcompensation for insectherbivory.

本文以棉花为实验材料，采用人工去除棉花一部分叶片、花蕾及接种棉蚜的方法，分别模拟昆虫食叶、食蕾及吸汁为害等三种为害方式，研究棉花对于失叶、失蕾及损失细胞汁液所产生的超补偿作用，及一些生理生化代谢随棉花发育时间进程变化的情形，以期较为系统地从多个方面阐明棉花对于虫害超补偿作用的生理学机制。

Both the experimental analyses and computer simulation were conducted to determine the statistical relationship between the structures and mechanical properties of centrifugally cast TC4 alloy in ceramic-shell mould.

摘 要：实验与模拟计算相结合研究Ti-6Al-4V(TC4)合金在陶瓷壳型离心精铸条件下，铸件模数对凝固过程冷速的影响，以及铸件组织、性能随模数和冷速之间的统计关系。

The influence of statistical fluctuations on this method was studied with Monte Carlo simulation and CERN - NA22 and experiment data in the second part of this thesis.

在本文中，通过蒙特卡洛模拟和对 CERN - NA22 和实验数据的分析，讨论了统计起伏对这一方法的影响。

On the basis of twin-roll thin strip continuous casting experiments and solidification structure characteristic analysis of thin strip and combining with the simulation results of effects of technological parameters, the forming mechanism of solidification structure zone (especially equiaxed crystal zone) on 1Crl8Ni9Ti stainless steel twin-roll thin strip was investigated.

在双辊薄带连铸实验和薄带凝固组织特征分析的基础上，结合对薄带凝固组织区的模拟预测结果，研究了1Cr18Ni9Ti不锈钢双辊薄带凝固组织区的形成机理。结果表明：1Cr18Ni9Ti不锈钢双辊薄带凝固组织中的等轴晶区不但在凝固类型为半固态时形成，在轧制或理想型时也能形成。其形成机理为，熔池中悬浮游离晶体的沉积、聚集以及在枝晶生长前沿的长大和薄带离开二铸辊最小间隙后，薄带/空气界面换热系数骤然降低抑制了柱状枝品的生长，并促使薄带中部未凝固熔体中游离晶体的择优长大

Transitions of different neuronal firing patterns in the Chay model are explored by numerical simulation and bifurcation analysis of limit cycle, with respect to three firing sequences observed in experiments on neural pacemakers.

本文利用神经元Chay 模型，对实验中观察到的三种放电节律模式序列进行数值模拟，并应用余维1极限环分岔分析研究了其产生机理。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。