英语人>网络例句>模拟实验 相关的搜索结果
网络例句

模拟实验

与 模拟实验 相关的网络例句 [注:此内容来源于网络,仅供参考]

With the investigation of the domestic and foreign literature systematically, the bases on the domestic and foreign present research and the comprehensive utilizations of the various knowledge of fluid mechanics in porous medium, reservoir engineering, mathematical physics, perforation completion, numerical simulation and so on, this article takes numerical simulation of gas reservoir of water solubility as the research aim which has completed following research works and obtained the corresponding research results: it analyzes the nature of the Water-soluble gas and formation water as well as the influent factors of the solubility through the study of massive materials; It establishes mathematical models three-dimension, the dual medium, the gas-water phase through the way of finite difference in the migration of water-soluble gas, which describes the entire process of release, migration and production in formation, where it considered the problems of variable bubble point; According to the numerical models of gas reservoir of water solubility it provides solution procedure that based on black oil model; It discovers that there will obtain the good effects in the lowly speed of development through simulation; the reinjection of formation water may largely enhance the produce degree of water-soluble gas when we consider reinjection in simulator; It considered the influence of perforated completion on development so as to increase the simulator"s versatility, It discovers that the simulator may reflect the conditions of development when we exanimate he simulator"s reliability with the empirical datum.

本文以水溶性气藏数值模拟研究为研究目标,在系统调研国内外文献、深入分析国内外研究现状的基础上,综合利用渗流力学、油气藏工程、数学物理方法、射孔完井以及数值模拟理论等多方面的知识,完成了以下研究工作并取得相应的研究成果;①通过对大量的资料调研,分析了水溶气、地层水性质、储层地质性质以及影响气体在水中溶解度的因素。②考虑到由于高压产生的大量水力裂缝,采用有限差分方法建立水溶气运移的三维、双重介质、气-水两相全隐式数学模型,该模型描述了水溶气在地层中的释放、运移和采出的整个过程。③在原有黑油模型的基础上,根据水溶性气藏数值模型编制了该数值模型的求解程序,该程序可以求解单重、双重介质两种情况。④通过模拟不同开采速度对水溶气开发效果的影响,发现开采速度较慢的时候可以取得较好的开采效果。⑤在模拟器中考虑了注水对水溶性气藏开发的影响,地层水回注可以大幅度提高水溶气的采出程度。⑥为增加模拟器的通用性,在模拟器中考虑了射孔完井方式对开采的影响。⑦检验模拟器计算的可靠性,发现在使用实验数据对水溶性气藏进行模拟时,模拟器可以很好的反映气藏开发的状态。

Although the tendency and the occurrence of fish-hook effect in partial separation efficiency curve agree with experimental data, simulation results are still two-fold lower than experimental data. It is necessary to improve the simulation method to obtain accurate data in the near future.

两相流的模拟结果亦显示,增加水旋风分离器之分流比可以提高分级效率,而且有明显的鱼钩现象出现,这和实验结果有相同的趋势;但是模拟的分级效率比实验结果低了大约2倍,因此尚有进一步的改善空间。

In order to simulate the fire of the cables in plenum, the fire tests on plenum cables were carried out in the burn room and plenum structure of a typical full-scale combustion flatlet model in the present paper.

在一个全尺寸燃烧套房模型中进行了起火室和顶棚夹层空间电缆火灾的实验研究,并采用大涡模拟的方法对实验中烟气速度场进行了数值模拟。

It is presented that indirect assimilation experiment of CMW data from TCFM method improves effectively not only on vertical velocity field but for precipitation.4 Based on theory analysis, E-Ir relationship is brought forward with two electrification mechanisms. One is inductive mechanism, i.e., cloud particles collide with precipitation particles then flick away, the other is noninductive mechanism because of different temperature, i.e., bigger supercooled cloud particles collide and freeze with hail particles combined with ice scraps. By means of CINRAD and FY2C data assimilation, precipitation intensity Ir can be obtained, then electric field intensity E, discharge time and locations can be achieved with supposed threshold 300KV/m. Though it can not distinguish between IC (Intra-Cloud) lightning and CG (Cloud-to-Ground) lightning, results are still comparable to LLS observations.5 Example analysis shows that the relationship between precipitation data from AMS and CG data from LLS is not very clear.

同化实验对于台风眼区的螺旋形雨带贡献显著,说明TCFM云导风资料同化实验不仅有效调整了模式的垂直速度场,还对降水模拟有了明显改善。4通过理论分析,利用云粒子与极化降水粒子碰撞并弹离的感应起电机制和较大过冷云滴与雹粒碰冻并产生冰屑的温差起电机制下得到的E-Ir,由雷达、卫星遥感资料直接和间接同化模拟得到Ir,来反推E,了解雷暴云中闪电强度的平面分布,设置放电阈值为300KV/m,推算出放电的位置和首次发生闪电的时间。

The proposed method has the capability of predicting the performance of condenser including threedimensional effects due to the change of cooling water temperature and the multiple tube paths arrangement. The proposed algorithm is more suitable to the condenser of multiple tube-paths than existing method. The proposed method is applied to a N11220-1 condenser to demonstrate its predictive capability, the results indicate that condensation rate of each bay and the air concentration at gas offtake is quite different, which can not be predicted by two-dimensional method.

对N11220-1型凝汽器的一个实验工况的模拟表明,该方法的热流密度计算结果与实验结果吻合良好,证明方法是有效的,模拟结果还表明,由于冷却水温度沿程变化,沿轴向各个汽室的冷凝量和抽气口的空气浓度均有明显不同,而目前国内外仍在使用的二维模型程序无法考虑这些影响,计算精度较差。

Numerical Simulation and Experimental Investigation on A Thermoacoustic Engine with Tapered Resonance Tube A symmetrical standing-wave thermoacoustic engine with tapered resonance tube has been numerically simulated with liner thermoacoustics. The simulation shows that using tapered resonance tube in thermoacoustic engine could decrease the velocity amplitude and lower the total acoustic power loss in the resonance tube. The experimental results indicate that the harmonic was suppressed effectively by using the tapered resonance tube, and the pressure ratio was improved.

采用锥形谐振管的热声发动机的数值模拟和实验研究利用线性热声理论,对一台采用锥形谐振管的驻波型热声发动机进行了数值模拟,发现采用锥形谐振管可有效降低工质气体的速度振幅,进而减小在谐振管中声功率的损失;与一台在相同频率下工作的采用等直径圆柱谐振管的驻波型热声发动机进行了实验对比,结果表明,在使用锥形管作为谐振管的热声发动机系统中,谐振管中的非线性效应得到了明显的抑制,热声发动机在基频模式下稳定运行,压比增大而加热温度降低。

Detailed work have done at four aspects as follows: the usage of SPIV in multistage turbomachinery; the study of compressor rotor tip complex flow with SPIV; the study of compressor stator tip complex flow with Rotor/Stator interaction and the detailed analysis and comparison of the unsteady flow field respectively obtained by CFD and experiment investigation.

详细本文主要以SPIV非定常实验测量和CFD非定常数值模拟为工具,研究叶轮机端壁复杂流动的一些机理性问题,围绕四个方面开展了叶轮机端壁非定常流动方面的研究工作:适用于多级叶轮机械使用的SPIV技术;压气机转子尖区复杂流动;动静叶干扰条件下压气机静子内尖区非定常流动;以及非定常数值模拟结果与非定常实验测量结果的对比。

Simulation results of initial hole included the relationship of punch load and punch stroke, the hole profile, the distribution of stress and strain, the forming limit diagram, and the variation of the workpiece thickness. The simulation results showed good agreement with the experiments in the bore-expanding process.

由初始孔径4mm之料片於扩孔成形之数值模拟与实验结果比较得知,冲头负荷与冲程关系、内孔轮廓大小、应力与应变分布、成形极限图与工件厚度分布等,皆显示实验与数值模拟间的一致性。

"ERP Integrated Training Enterprise Information sand table" based on "ERP sandbox simulation" course simulation business, to simulate a company's business activities, the experimental data, accounting and business management in accordance with the basic requirements of design information-based solutions, in line with "ERP sand table simulation" course in contrast to the manual mode of operation, so that students deal with personal feelings manual and computer processing set up between the posts, business processes, work efficiency differences, a deep understanding of the necessity and advantages of information technology.

ERP沙盘企业信息化综合实训》基于《ERP沙盘模拟》课程中的模拟企业,以模拟企业的业务活动为实验资料,按照会计核算与企业管理的基本要求,设计信息化解决方案,以与《ERP沙盘模拟》课程的手工操作方式形成对比,使学生切身感受手工处理和计算机处理之间在岗位设置、业务流程、工作效率等方面的差异,深刻理解信息化的必要性及优越性。

The thickness of the ice cover on the wall surface heat transfer is greater than the thickness of it on the air heat transfer form. The thickness of the ice cover on the wall surface heat transfer along the way changes slowly, but it on the air heat transfer along the way changes significantly. Reducing the entrance velocity, lowering the wall surface or air temperature, the formation of the thickness of the ice cover will increase; in the 3D circumstances, The thickness of the ice cover was relatively uniform in the import of the U-turn model, the ice cover was gradual accumulation in the convex bank when the stream traversed the import of the U-turn model, the thickness of the ice cover in the convex bank was significantly bigger than the thickness in the concave bank. The temperature field under the ice cover tends to be complex because of the existence of the secondary flows. The temperature in the convex bank is greater than it in the concave bank. Compared with the data from experiments, the laws in the numerical simulation are similar with them in the experiments

模拟结果显示:二维情况下,运用壁面传热形成的冰盖厚度大于运用空气传热形成的冰盖厚度,壁面传热形成的冰盖厚度沿程变化缓慢,而空气传热形成的冰盖厚度沿程变化明显,减小入口流速,降低壁面或空气温度等,形成冰盖的厚度都会增大;三维情况下,弯道入口处凸、凹岸形成的冰盖厚度基本相同,进入弯道后,凸岸形成的冰盖厚度逐渐增大,而凹岸的冰盖厚度逐渐减小,受横向环流的影响,冰盖下水流的温度场趋向复杂,并且凸岸的温度小于凹岸的温度;与实验室实验所得数据相比较,数值模拟研究得到的规律基本符合实验规律。

第35/100页 首页 < ... 31 32 33 34 35 36 37 38 39 ... > 尾页
推荐网络例句

She gently rebuff ed him, but agreed that they could be friends

她婉言拒绝了,但同意作为朋友相处。

If in the penal farm, you were sure to be criticized.

要是在劳改农场,你等着挨绳子吧!

Several theories about reigniting and extinguishing of the arc have been refered.

本文综合考虑了几种电弧重燃和熄灭理论。