模态

In fact,in his criticism,has also developed a modal logic with non-modal logic truth table semantics sentence comparable to the form of semantics.

事实上，在他的批评之后，模态逻辑也发展出了可与非模态语句逻辑的真值表语义学相媲美的形式语义学。

The terminal sliding mode controller is designed by using unit vector style; the switching function of the terminal sliding mode is designed by the quadratic optimal control theory.

采用单位向量控制形式的最终滑动模态控制器，并采用二次型最优控制理论设计最终滑动模态的切换函数。

In order to optimizing the vibration isolation of some diesel generator set ,an analysis of the vibration character and excitation forces of it is presented through theory study and vibration testing.

通过对频响函数的测试，获得了某型柴油发电机组隔振系统各阶刚体模态频率和弹性模态频率，分析了该机组振源和振动特点。

The power generator is designed in the form of cantilever beam and excited at first resonance mode to generator maximum vibration amplitude.

首先利用有限元素法分析微发电机结构之第一共振模态，本论文还利用实验量测发电元件的模态并与有限元素分析结果比对。

The APW in summer is less than 25 mm which is the least limit value of monsoon areas.This means that Xinjiang is not affected by monsoon.The geographic distribution of APW is adverse with that of precipitation,videlicet,higherAPW values corresponding to lower precipitation values.With the effects of westerly winds,the APW mode presents as an uniform change within Xinjiang area and has a stable distribution.It is very different from Xinjiang rainfall mode which changes a lot spatially.As mentioned above,there is no obvious change during 1961～2000,this indicates that APW is not a dominant factor determining precipitation,it is the result of dynamic condition,water vapor convergence and other causes.

APW的地理分布与实际降水量分布相反，其最大区域却为降水量最小区，受西风带影响，新疆APW模态主要表现全疆一致变化，分布稳定，与降水模态分布差异性大有显著不同，且近40年来无显著变化趋势，表明决定新疆降水差异的根本原因不在于水汽的多少，而是由降水产生的动力条件、水汽辐合和其它因素差异决定的。

In order to investigate buckling mode, buckling load and failure mode of structure, shear experiments were conducted for stiffened thin-walled composite plate. Finite element method was also used to analyze the buckling behavior of that composite structure. Analysis results reveal buckling mode and buckling loading of finite element analysis are accordable with experimental results.

通过对复合材料薄壁加筋板结构进行剪切载荷下的屈曲试验研究，得到结构的屈曲模态、屈曲失稳载荷以及破坏形式，并通过有限元方法对结构的屈曲进行数值分析，分析得到的复合材料薄壁加筋板结构的屈曲模态和试验结果一致，屈曲载荷与试验结果吻合较好。

On strength computation,the finite element models of rotating mirror were established according to the real structure of the mirror,and the rotating three-faced beryllium mirror were analysed.Results display that the surface deformation magnitude of the mirror is approximately 0.334 6 μm,and the maximum stress is 0.204 GPa at 600 m/s of edge linear speeed.The regions of maximum stress are on the axial hole and symmetric to symmetrical planes of mirror body,and keep beelines to surfaces.On the modal analysis,the results show that the first and second modals of bending vibration exist around 3.4×105 r/min and 6.6×105 r/min,which appear binate and orthogonal respectively,and another modal belongs to the first torsional vibration that occurs by 5.13×105 r/min.

运用该方法得出转镜镜面变形量、内部应力分布和振动模态参量的定量数值：在边缘线速度600 m/s下，三面体铍转镜的最大变形量为约0.334 6 μm；最大应力0.204 GPa，位于轴孔附近并与镜面距离最短处；两个在互相垂直平面内的一阶弯曲振动模态发生在3.4×105 r/min附近，一阶扭振点位于5.13×105 r/min附近，两个二阶弯曲振动点位于6.6×105 r/min附近。

Experimental modal analysis of damaged cantilevered beams was used to study the previously proposed pragmatic parameters which are based on mode shapes to exhibit the desired jump.

本文结合对悬臂梁的试验模态分析数据，对现有的两种基于模态振型的损伤识别方法进行了研究，并对这两种方法的可靠性进行了验证分析。

These antennas can cover GSM900/DCS/PCS/UMTS operation. In the chapter 2, the antenna is designed based on the concept of monopole antenna. Furthermore, the antenna structure have two radiant paths and coupled each other at tail end to do impedance matching. In addition, to raise distance between radiation plane and ground will avoid capacitative effect effectually. In the chapter 3, the antenna is designed based on the concept of planar inverted-F antenna. Furthermore, that the antenna structure have two radiant paths and coupled each other at tail end to do impedance matching is similar to chapter 2. But there is a difference in them. We can choose the short position to change input impedance at this structure. In the chapter 4, the antenna is designed based on the concept of planar inverted-F antenna which takes coupled-fed. It will produce the first mode and high-order mode near the frequency, 900MHz. The feature of this type is to reduce the volume effectually. This antenna can not only cover GSM900/DCS/PCS/UMTS operation but maintain good radiation efficiency. Finally, we will compare three antennas, and develop procedure with industrial view, and propose the prospect of the GSM/GPRS antenna in PND, as a conclusion.

在第二章中，我们使用单极天线设计概念，使用双路径架构并於末端耦合来对天线阻抗做匹配，产生涵盖GSM900/DCS/PCS/UMTS四频操作频带，并提高与接地面的辐射高度，以避免电容效应，使天线具有良好的辐射特性；在第三章中，使用倒F形天线设计概念，使用双路径架构於末端耦合，并於辐射臂上采取适当接地点电感效应作输入阻抗匹配，达成涵盖GSM900/DCS/PCS/UMTS系统的四个操作频带；在第四章中，采用倒F形架构并使用耦合馈入方式，使得长辐射金属臂在低频900 MHz附近产生共振，产生低频基频模态及高阶模态，以达成宽频及频宽涵盖GSM900/DCS/PCS/UMTS频带操作，并有效缩减使用体积；最后，分别比较此三种架构的优缺点，再加以业界角度来思考，研发产品天线的流程及思考方向，以及天线应用於可携式导航装置中未来的展望作为本论文的总结。

With this idiom, the information has migrated from the user's head into the program where it is visible and choosable.

在大多数文本编辑器中，存在一个用户可设置的选项在插入模态和改写模态之间切换。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷