检测装置

The company's production equipment, complete, complete detection means, strong technical force, rich production experience, is a professional manufacturer of fire equipment, ship life-saving fire protection products, marine oil-water separator, marine oil-water separator devices, marine bilge oil water separator device enterprises .

公司的生产装备齐全，检测手段完备，技术力量雄厚，生产经验丰富，是专业生产消防器材，船舶救生消防产品，船用油水分离器，船用油水分离器装置，船用舱底油污水分离器装置的企业。

With the development of the railroad, the capability and the stability of the act-enable parts of these equipments are faces baptism. At the same time, testing the biometry of the equipment faces higher needs than before too.

随着铁路运输部门的发展，对列车制动装置的性能与稳定性提出了严峻的考验，同时也对制动装置寿命检测提出了更高要求。

This paper gives out the principles and improving schemes of transformer discharge equipment and resonance booster discharge equipment. By detecting the current in the main circuit, the gap's breaking-down can be identified, and the single chip micro-computer will send out corresponding control signal to make the IGBTs to switch off or cut off the input voltage, by this mean, we can make sure that every time of the experiment, the sample will discharge only once. The paper also introduces the principle of the protection circuit. At last, the experimental waveforms were listed, which prove the feasibility of the high voltage discharge fast switch-off device.

该文给出了变压器和谐振升压器2种高压放电试验装置的原理以及改进方案，通过检测主回路电流大小判断间隙是否被击穿，由单片机发出相应控制信号，采用IGBT等开关器件控制试验电压的通断，保证了试品每次试验只进行一次放电，介绍了保护电路的原理，给出了试验波形，证明了此高压放电速断装置的可行性。

This paper deals with the design for automatic test system of missile guided system, which is signal oriented.

从某型导弹制导装置的输入/输出信号特性出发，设计了制导装置自动检测系统。

Ice jam of pipes for transporting oil and gas in winter threatens momently the safety running of petrochemical units in cold area.

冬季油气输送管线的冰堵时刻威胁着高寒地区石油化工装置的安全运行，带式传感器动态应变定位检测技术的研制与开发解决了这一难题，它能迅速而准确地查找冰堵点，从而保证炼化装置的冬季正常运

Based on imaging technique, the shape measurement method and light scattering characteristics of static aerosol particles are investigated. The experimental apparatus is set up and the main effort is paid on the design of the scattering chamber and the optical fiber arrangement. The air-proof and the light-proof scattering chamber are designed for dynamic aerosol particles, and they are different from those for static aerosol particles. The control of airflow and the calibration procedure are also developed.

2针对静态气溶胶粒子，提出了基于成像法检测其形状与散射的方案，以散射腔为核心，确定了光纤插孔的排布，研制出"中正式"结构的实验装置；针对动态气溶胶粒子，设计了密封和光封的独特散射腔，实施了流量控制，制订了定标方案，初步完成了满足动态气溶胶粒形统计要求的实验装置。

The system can obtain the real-time image of the monitored scene. By image detection of the moving object, the wireless image transmission device can give off alarm signals when moving objects enter the scene. Then alarm signals and real-time image are transmitted through wireless receival station into the monitoring room for inspection.

该系统可以获取被监控现场的实时图像，对图像中运动物体检测，当有运动物体进入监视现场时，无线图像发射装置给出报警信号，并将报警信号以及实时的图像画面通过无线图像发射装置发射出去，通过无线接收基站传入监控机房，监控人员可以在监视器上观察报警现场的情况。

Preparation of the cathode includes:shaping under the press of 40Mpa, sintering at 550℃for 1 hour and at 900℃for 8 hours and threading with molybdenum bar; Considering the literatures we choose CaCl2 as salt for preparation titanium. Pretreatment of salt is for 1 hour at 100℃and for 2 hours at 300℃. Partial pressure of oxygen which need lower than 5.11×10-7Pa to reduct titanium oxides and hygroscopic property of salt need a sealed equipment to electrolyse. And finally successfully designed a satisfied one and the results show that the equipment can be satisfied the requirment of the experiment. Flow of the inert gas is 1.5L/min, the voltage is 2.8 V, temperature is 850℃and time is 2 hours during pre-electrolysis. Flow of the inert gas is 0.2L/min, the voltage is 3.1 V, temperature is 900℃and time changes with the mass of TiO2 during electrolysis, namely the greater need the longer time; To eliminate influence of salt and other impurities, the products need to wash with distilled water and dilute chlorhydric acid , then wash with dilute hydrochloric acid under supersonic wave assistant. Finally, electrometical properties of the electrolysis of TiO2 is researched by cyclic voltammetry and chronoamperometry, and results show that there are two main reodox steps, namely from TiO2 to TiO and from TiO to Ti.

阴极制备主要包括40MPa压力下模压成型、两段式烧结(1小时内升至550℃保温1小时，再1小时升温至900℃保温8小时)及烧结后TiO2块打孔用钼棒串接三个主要环节；实验中选用CaCl2作为电解熔盐，并对其进行预处理(100℃，保温1小时； 300℃，保温2小时)；经热力学计算，还原钛氧化物的氧分压至少要低于5.11×10-7Pa，结合电解过程中所用熔盐CaCl2有极强的吸水性的特点，电解装置应有较高的密封性，自行设计了一套密封性可靠的电解装置，便于实验过程中熔盐预处理和氧分压的控制；通过干燥处理预电解过程中Ar流量大约为1.5L/min、电压为2.8 V、温度为850℃、时间为2小时，电解过程中Ar流量大约为0.2L/min、电压为3.1V、温度为900℃，实验结果表明电解时间与TiO2质量密切相关，质量越大需要电解的时间越长；通过自来水冲洗—稀盐酸浸泡、洗涤—在超声波辅助作用下稀盐酸洗涤，可减少熔盐及其它杂质对电解产物检测结果的影响；最后，通过循环伏安法、计时电流法对电解机理的研究，确定电解还原TiO2制备金属钛主要经历了TiO2-TiO-Ti的过程。

The disclosed combined detection method for high-pure SO3 gas with SO2 as impurity comprises: constant-volume sampling at least 60Deg better 60-80Deg to avoid liquidation of SO3, absorbing with alkali solution to obtain total volume percentage concentration of high-pure SO3 gas and SO2; processing the absorbed liquid, using iodometric method to obtain SO2 volume percentage concentration and then the SO3 concentration.

一种高纯度SO 3 气体及其中杂质SO 2 气体浓度联合检测的方法，包括用吸收装置进行定容采样，然后用碱溶液吸收，得到高纯度SO 3 气体及其中杂质SO 2 气体的总体积百分浓度，再对吸收液进行处理后，采用直接碘量法测得SO 2 气体的体积百分浓度，将高纯度SO 3 气体及其中杂质SO 2 气体的总体积百分浓度减去SO 2 气体的体积百分浓度即为高纯度SO 3 气体浓度，其所述吸收装置进行定容采样时，是在至少60℃以上的热环境中进行的。

It has proved that this equipment can perfectly carry out the auto-detecting, and greatly improve the detecting efficiency with the precision of 5＃－10＃which is far surpass the capability of naked-eye 0.2＃.

实践证明该装置能较好的实现水准泡的自动检测，使水泡检测的效率大大提高，并且检测精度可达5＃－10＃，远远超出人眼的最大分辨本领0.2＃。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。