检测板

Results Spatial relations of the tumors to the lamina terminalis, anterior commissure and anterior communicating artery complex were clearly shown in T2R images. The optic nerves, optic chiasm and optic tracts were detected in 93.3%, 100% and 86.7% of the patients on T2R images and 66.7%, 93.3% and 66.7% on T1 weighted images, respectively. Detection rate of optic pathway on T2R images was higher than that on T1 weighted images.

结果 重T2加权灰阶反转成像可清晰显示肿瘤与终板、前连合及前交通动脉丛的空间关系；其视神经、视交叉和视束的检测率分别为93.3%、100%和86.7%，而在T1加权成像中则分别为66.7%、93.3%和66.7%，前者对视路的检测率显著性高于后者。

At last, guided by the theoretical calculation mentioned above, a series of experiments were carried out. The wavefront distortion of a plano concave lens was measured. The total error was less then 8%. This certified the measured results of the interferometer. The wavefront distortion of a one-side pumped zigzag slab gain medium in different pumping power was measured.

最后，在上述理论计算的指导下，进行了一系列波前检测实验：对一个焦距已知的平凹透镜所产生的波前畸变进行了检测，总的测量的误差小于8%，验证了系统测量结果的准确性；测量了一个单侧泵浦的之字形板条增益介质，在不同泵浦功率下的波前畸变情况。

The error source of CMM is complex, and the current main research is its geometric error. In the paper, 21 items of geometric error are measured accurately, simply and fast with the 2-D laser interferometer and four quadrants photo detector. The measurement gets rid of measuring so many lines and several diagonal lines in linear displacement method, and also solves the question that error measure of large-scale CMM can not be measured with 1-D ball array and ball plate conveniently.

坐标测量机的误差源纷繁复杂，当前主要研究的是其几何误差，课题中研究了一种采用二维激光干涉仪和四象限光电探测器相结合的测量方法，对三坐标测量机的21项几何误差进行了准确、简便、快速的测量，摆脱了线位移法测量直线过多且包含多条对角线测量的弊端，同时也解决了一维球列和球板不方便检测的大型测量机的误差检测问题。

Based on the different permeability of DNA-intercalant dyes YO-PRO-1 and propidium iodide to the membrane of viable, apoptotic and necrotic cells, cell samples were stained with 4μmol/L YP and 4μg/ml PI for 10 min, and the fluorescence intensity of both YP and PI were measured by fluorometer at Ex/Em wavelength of 485/538nm and 530/590nm, respectively.

根据正常细胞、凋亡细胞和坏死细胞的细胞膜对核酸荧光染料的不同选择通透性，用4μmol/LYO-PRO-1和4μg/ml碘化丙啶(Propidiumiodide，PI)染色96孔板中的细胞样品。分别在485/538和530/590的检测波长下借助荧光分光光度计检测细胞样品孔的YP和PI荧光强度。

The test system to molten steel purity, which including macrography, chemical analysis, Smills, photograph, image analysis and SEM test, is constructed by measuring and analyzing the inclusions in different process stage of BOF, TD, slab and sick plate.

对转炉、中间包、连铸坯和中厚板不同工艺阶段的夹杂物进行检测分析，完善形成了包括低倍检验、化学分析、大样电解、金相分析、图象分析仪分析与扫描电镜能谱仪分析等手段的钢水纯净度检测系统。

Methods The cells were divided into 5 treatment groups（10,25,50,75 and 100 μmol·L-1 QUE）, blank control and menstruum control group. The rat C6 cells were cultivated to 1×106·mL-1 in the RPMI 1640 medium, then added into 96 holes board with various doses of QUE by 3 holes per group,and MTT assay was used to observe the proliferation of the cells treated for 24,48 and 72 h. The change of cell cycle was also observed by flow cytometry after the cells were treated with 50 and 100 μmol·L-1 QUE for 48 h. The changes of the protein P53 and Bcl-2 of C6 cells treated with 50 μmol·L-1 QUE for 48 h were detected by immunocytochemical methods.

按QUE浓度分成10、25、50、75及100 μmol·L-15个处理组和空白对照组及溶剂对照组，大鼠脑胶质瘤C6细胞在RPMI 1640培养基中生长达1×106·mL-1后，在96孔板中分别加入上述浓度的QUE继续培养，每组设3复孔，作用24、48及72 h，采用MTT比色法检测QUE对大鼠脑胶质瘤C6细胞的增殖抑制情况，流式细胞术对50及100 μmol·L-1的QUE作用48 h的大鼠脑胶质瘤C6细胞进行周期分析，免疫组化法检测50 μmol·L-1的QUE作用48 h 的p53和bcl-2基因产物。

OBMorph adopted a paraboloidal mirror to vary the incident angle, the wave-plates to modulate phase retardation, a reference optical path to stabilize the optical source, and a flow-injection system to drive bio-sample into the bio-chip. In order to having high precision in the ellipsometry subsystem of OB-Morph, it adopt a 0.4μm accuracy servomotor to control the stage that carried the right angle mirror and to control the variation of the incident angle.

本文中所建构之OBMorph检测系统中，椭偏仪技术是采用相位调制架构设计，开发出利用抛物面反射镜与球面反射镜组合而成之控制入射角改变的光机，加上波板以完成相位调制动作；并以一参考光路做为校准光源之机制，以及设置流道系统提供生物检测之用。

this paper introduces a lossless detected circuit system.firstly,system gathers slender infrared signal with transducer,then amplifies them with low noise.through voltage comparator circuit,transforming simulation objection signals to digital signals.finally,transforming transport landscape orientation and portrait to single chip processing.in design of pcb,the amplifying of quadruplet signal,filter,voltage comparator decree and and logic function are manufactured in one board.if the diameter of workpiece is long,it can add multiple the number of transducer of four,to wide its range of practice,disposing circuit only need one module.

摘 要：介绍了一种无损检测的电路系统。系统首先利用传感器采集到微弱的缺陷信号，再将缺陷信号进行低噪声放大，然后通过电压比较判决电路将模拟缺陷信号变换成数字信号，最终将横、纵两路的输出信号送至单片机处理。在pcb设计中，将四路信号的放大、滤波、电压判决以及与逻辑功能做在一块板上，若被检测工件的直径较大，可以将传感器的个数以四的倍数增加，处理电路只需增加一个模块。

Methods The effects of various concentrations of tea polyphenols on proliferation, invasion and apoptosis of CGTH W-3 cells were observed by MTF assay, plate scarification assay and flow cytometer, respectively.

方法用MTT法检测细胞增殖活性，观察不同浓度茶多酚对CGTH W-3细胞增殖活性的影响；并通过培养板划痕法观察茶多酚对CGTH W-3细胞侵袭能力的影响；应用流式细胞仪检测各浓度茶多酚诱导CGTH W-3细胞凋亡的作用。

The company increases the superelevation member product home biggest production line, 4,600 tons presses 2 wraps, may produce 1560×3100×6 ~ 250mm each kind of gauge frame, the product, the color are complete, may according to the different users demand and the blueprint processing, has the home most advanced, the complete check-out facility and the automatic control examination system.

公司新增超高分子制品国内最大生产线，4600吨压机2台套，可生产1560×3100×6～250mm各种规格板、制品，颜色齐全，可按不同用户的需求及图纸加工，拥有国内最先进、完备的检测设备和自动控制检测系统。

I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""

客人们在卡罗利娜·埃凯家里，举止就文雅一些，因为卡罗利娜的母亲治家很严厉。

Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.

由著名品牌 Herm è s 设计，这件高贵的制服是香港本土制造，是我们第一套不配帽子的制服。