根轴

Pitch circle diameter: d = mz = 3X12 = 36 Tooth crown heights: ha = m (f0 + x)= 3X (l +0.5)= 4.5 Tooth High: hf = m (f0 + cx)= 3X (l +0.25-0.5)= 2.25 Tooth full height: h = ha + hf = 4.5 +2.25 = 6.75 Addendum circle Chemical pumps diameter: Da = d +2 ha = 36 +2 X4.5 = 45 Fixed string tooth thickness: Sxn = m (π/ 2 * cos2a + xsin2a)= 3X (1.387 +0.6428 X0.5)= 5.125 Fixed string of high gear tooth thickness measurement: hxn = m (π/ 8 * sin2a + xsin2a)= 3X (0.7476X0.117X0.5)= 2.42 Modulus coefficient x0.5 m3 O20 ° pressure angle tooth thickness Sxn5.12 fixed string Addendum Coefficient string f1 fixed gear tooth thickness measurement most high hxn2.42 Teeth z12 2, shaft wear and tear maintenance: Axis gear pump wear is mainly because with the support roller shaft at both ends between the friction and wear, so that smaller shaft diameter.

分度圆直径：d=mz=3X12=36 齿顶高：ha=m（f0+x）=3X（l+0.5）=4.5 齿根高：hf=m（f0+c-x）=3X（l+0.25-0.5）=2.25 齿全高：h=ha+hf=4.5+2.25=6.75 齿顶圆直径：Da=d+2ha=36+2X4.5=45 固定弦齿厚：Sxn=m（π/2*cos2a+xsin2a）=3X（1.387+0.6428X0.5）=5.125 固定弦齿厚测量用齿高：hxn=m（π/8*sin2a+xsin2a）=3X（0.7476X0.117X0.5）=2.42 模数m3变位系数x0.5 齿形角o20°固定弦齿厚Sxn5.12 齿顶高系数f1固定弦齿厚测最齿高hxn2.42 齿数z12 2、轴的磨损维修：齿轮泵中轴的磨损主要是因为轴两端与支撑滚针间的摩擦磨损，使轴径变小。

Moutan has two different reproduction ways:obligate seed reproduction and amphitrophic reproduction;the dormitory of its embryo has two stages of epicotyl and hypocotyl;the dormitory could be end if it is treated with two temperature conditions.

Moutan生殖特性，具有根状茎、块根、根出条多种形式的以营养繁殖为主、种子繁殖为辅和专性种子有性生殖的两种类型；胚具有上胚轴、下胚轴两段休眠特性，打破休眠需按一定的程序和两种不同的温度条件；……。

Next, a partial histogram, which is part of the component histogram ( 406 a), is taken from the component histogram ( 406 a), and is arranged at two-dimensional coordinates where a horizontal axis represents an arrangement of component cassettes and a vertical axis represents a number of pickup operations by the line gang pickup head.

其次，从该元件直方图(406a)中取出作为该元件直方图(406a)一部分的一个局部直方图(400)，并将它排列到一个两维坐标，其中一根水平轴代表某种元件盒排列，而一根垂直轴代表该生产线联动拣拾头的拣拾操作数。

According to analysis of roots locus,fast excitation tends to decrease damping of power systems which is controlled by AVR than slow excitation.But eigenvalues of power system are far from imaginary axis and strong damping is obtained when fast excitation system is added.

在高放大倍数的AVR控制下，快速励磁较慢速励磁更容易恶化系统阻尼；但是在同时附加励磁控制的情况下，快速励磁可使系统的机电模式根轨迹远离虚轴，机电模式阻尼较大；而慢速励磁下，系统机电模式根轨迹接近虚轴，机电模式阻尼较小，快速励磁优于慢速励磁。

Based on the analysis of the short life of the bearings in the speed increaser of Morgan finishing unit and elastic spacers and breaking of input shafts,the transformation is made to the output and input shaft bearings and the related parts in the speed increaser ,with the good results.

针对高线摩根精轧机组增速机轴承和弹性垫片使用寿命短，输入轴断轴等事故进行分析探讨，通过对增速机输出轴轴承、输入轴及相关配合零件的改造，取得较好的使用效果。

Based on the analysis of the short life of the bearing s in the speed increaser of Morgan finishing unit and elastic spacers and breaking of input shafts,the transformation is made to the output and input shaft bearing s and the related parts in the speed increaser,with the good results.

针对高线摩根精轧机组增速机轴承和弹性垫片使用寿命短，输入轴断轴等事故进行分析探讨，通过对增速机输出轴轴承、输入轴及相关配合零件的改造，取得较好的使用效果。

When packing for the valve, the valve packing section and the same space, it is best Preloading Central: When the time for the pump, valve packing and the space section (about 0.3mm-0.6mm) axis and the disk so that there is a leakage of the root space is conducive to lubrication and cooling.

当盘根用于阀门时，盘根截面和阀的空间一样，最好是预压环：当用于泵时，盘根截面和阀的空间(约0.3mm-0.6mm)使轴和盘根有一泄露间隙，有利于润滑和散热。

It was achieved by intradural microanastomosis of the L6 ventral root to S2 ventral root. After axonal regeneration, the "patellar ligament-spinal cord center-bladder" reflex pathway was reestablished. The function of the reflex arc was observed by nerve electrophysiological experiment, detrusor electromyography experiment, urodynamic testing and HRP retrograde tracing before and in 8 months after the spinal cord was destroyed horizontally between S1 and S4 level. There was one case of conical SCI patient who had L1 fracture and paraplegia was received intradural microanastomosis of the L6 ventral root to S2 ventral root after Li fracture and paraplegia.

将Beagle犬L6前根近端与S2前根远端在硬膜内显微吻合，经一段时间的轴突再生后，建立&膝腱－脊髓中枢－膀胱&人工反射弧，术后8个月，在破坏S1~S4脊髓节段前后分别进行神经电生理、膀胱肌电图及尿流动力学和辣根过氧化物酶逆行示踪等检查；对1例L1压缩性骨折伴截瘫患者行右侧T11与52前根经腓肠神经移植硬膜内吻合术。

How to ensure this new structure to be in elastic state under frequent earthqu ake, be mendable under design earthquake and not collapse under infrequent earthquake, especially the last item, is the problem to be solved imminently in engineering field. Center around this problem, 5 aspects of investigation are carried out as following:(1) The experiment of seismic performance of ASCCs in this new frame structure has not been reported, in order to study this problem, 9 ASCC specimens with shear steel plate are tested subjected to the horizontal low cyclic loading, in which, the shear span ratio is 3 and axial compression ratio is different. The hysteretic curves of 9 specimens are obtained. The seismic performance indexes such as energy dissipation, stiffness degradation, strength degradation, skeleton curves and ductility of this kind of column are acquired, and the seismic fortification measures including ultimate values of axial compression ratio under different seismic degree are suggested.

1新型框架结构中所采用的角钢混凝土柱抗震性能的试验研究尚未见报道，针对这一问题，本文进行了9根剪跨比为3、不同轴压比、采用钢板箍的角钢混凝土柱在水平低周反复荷载作用下的试验研究，获得了9根试验柱的滞回曲线，考察了该类柱的耗能、刚度退化、抗力衰减、骨架曲线及延性等抗震性能指标，建议了角钢混凝土柱在不同抗震等级下的轴压比限值等抗震构造措施。

The blade according to claim 13, further comprising a blade rooting part including at least one blade attachment bar which is elongate, composite, and twistable about a longitudinal axis, and extends outside the shell by passing through the blade root, the at least one composite bar of the at least one spar having a longitudinal axis substantially parallel to the longitudinal axis of the blade, the end of the at least one attachment bar, on the side opposite the shell, being arranged in linkage attachment to the rotor hub, the at least one attachment bar of the rooting part being integral with the at least one composite bar of the at least one spar and comprising reinforcing fibres agglomerated by the thermoplastic resin.

刀片根据索赔13 ，进一步组成的刀片生根的一部分，其中包括至少一个刀片实习大律师公会是伸长，复合材料，和twistable约一长轴，并扩大外壳，通过叶根，至少有一个综合酒吧的至少有一个SPAR公司有一个长轴大致平行的纵向轴的刀片，结束对至少有一个实习酒吧，就一侧对面的壳，现正安排在联系实习，以转子枢纽的地位，在至少有一名实习律师生根的一部分，正在积分与至少有一个综合的酒吧至少有一个SPAR公司组成的加强纤维烧结由热塑性树脂。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。