根段

It comprises an in-put shaft hinged to its yoke through one axis, and an out-put shaft also hinged to its yoke through another axis, and these two yokes (13) were combined together by only one axis position, perpendicular to that two yoke axes like a cross, so that this combined axis will bend just like the angle bisector of that two shafts to maintain its constant velocity by a few methods, firstly, by using a section of gear teeth mesh at both ends of the shafts' teeth were so polished so that it can turn longitudinally as usual gear, and also sideways, to provide a larger solid angle of turning from ordinary 45 degrees into 60 or even more.

它包括输入轴，其通过一根轴铰链连接于叉形支架，和输出轴，其通过另一根轴也铰链连接于其叉形支架。并且这两个叉形支架(13)只需用一根相对垂直铰链轴相连而组合在一起，使得这种组合的轴总能形成这两个轴的角平分线，以通过少数几种方法保持其恒速，首先，通过用啮合在轴的两端的一段齿轮齿抛光为以能够像普通齿轮一样纵向转动，并且还能够侧向转动，以提供较大的转向立体角，从通常的45度变成60度或更大。

Methods A modified Bramante muffle was used and 22 chinese mandibular second molars with Cshaped root or seperated roots were sectioned into four pieces perpendicularly distance from apex to 3,3.5,8 mm,respectively.The crosssectional anatomical morphology was observed and the minimum root canal wall thickness of each section was measured.

使用改良Branmante体外模型，将具有C形牙根或两个独立牙根中国人下颌第二恒磨牙各22颗，在距根尖3，5.5，8 mm处将样本锯为四段，观察C形根管横断面形态，测量断面最小根管壁厚度。

4DRG was co-culture with sciatic nerve segment in 10鸖 DMEM;the axons were longer and surround the sciatic nerve segment which was regard as anew evidence for chemotropism.

结果：(1)在无血清条件下单独培养的DRG，背根神经节的轴突数目众多，外形纤细弯曲，不成束，并且施万细胞和成纤维细胞稀少，所以可以排除两者对轴突生长的影响，为观察来源于变性坐骨神经段的可溶性因子对轴突生长的作用提供了有利条件；(2)在无血清条件下DRG和变性坐骨神经段联合培养，①先单独培养DRG，4天后待神经元轴突长出，再与坐骨神经段联合培养，观察到神经元的轴突数目减少，外形挺直，部分轴突之间相互粘附成束；②变性坐骨神经段和DRG同时联合培养，神经元的轴突数目明显减少，外形粗壮，轴突之间相互粘附成束；(3)有血清条件下单独培养DRG，轴突数目较多，外形挺直，长短不一，部分神经元的轴突之间相互粘附，施万细胞和成纤维细胞数目众多，观察到的轴突生长情况受到施万细胞和成纤维细胞的直接或者间接的影响。

Then the MEMS solenoid type electromagnetic actuating and novel, frictionless and wear-free, and simple structure are designed for fiber-deflecting type MEMS VOA: One of the two coupled single mode fibers is completely fastened in one of the three aligned U-shaped grooves while the deflectable fiber is partially fixed in another groove with a long front section suspending over the wider groove as a cantilever beam. The two fibers, any one for input and the other for output, are well aligned initially so that the insertion loss is very low. Beside the deflectable fiber is a solenoid microactuator with a U-shaped permalloy core attracting a permalloy piece glued on side of the fiber cantilever so that the fiber is deflected and the optical power coupled between the fibers decreased continuously. Using MEMS solenoid as a continuous actuator and the novel structure of VOA are not seen in literature.

为光纤偏移型MEMS可变光衰减器设计了MEMS螺线管电磁驱动方式以及新颖的避免了静摩擦、磨损而且简单的整体结构形式：在硅基片的三段V形槽结构中，将两个对接单模光纤之一完全固定在基片上，只将另一根光纤的稍后部位固定于基片上而使其前端的一定长度悬空，形成一个悬臂梁结构；初始对准后两根光纤之间的光传输损耗很小；通过U型铁芯MEMS螺线管吸引固定于光纤悬臂梁上的坡莫合金片，驱动光纤悬臂梁连续偏移以使两根光纤之间功率传输系数连续变化，从而达到光功率连续衰减的目的。

The screw entry point was located at the tip of transverse process. The average inclination angle should be 10°-20° headward and 30°-40° toward neutral line respectively. The screw was inserted and entered into the vertebral body along the external cortex of pedicle. The integrity of cortical bone around screws, the distance to segmental blood vessels and the penetration of cortex were observed after operation to evaluate the accuracy and safety of screw placement. Among 160 thoracic pedicle screws that were implanted in 34 cases, 148 screws (92.5%) were accurately inserted inside the costotransverse unit, and 12 screws (7.5%) were misplaced according to the image of X-ray and CT thin-slice scan.

应用椎弓根外内固定技术2004/2007年在中山大学附属第三医院骨科治疗34例患者，固定前采用CT加密扫描测量进钉点、进钉点至椎体前缘的深度、进钉角度和直径，固定中椎弓根钉入点为横突尖，进钉方向为平均向头侧倾斜10°~ 20°、与中线成角30°~40°，顺椎弓根外侧皮质进入椎体，固定后CT加密扫描观察螺钉周围的皮质骨是否完整、是否靠近节段血管、是否穿透皮质骨，评价置入钉的准确性和安全性。34例患者共置入160枚胸椎椎弓根螺钉，固定后CT加密扫描和X射线片观察到148枚(92.5%)螺钉置入准确，12枚(7.5%)螺钉发生错置。

Based on the tooth profile plane model's boundary scope and the geometry dimension of the transmission gear, the paper calculates every point's Cartesian coordinate in all parts of tooth profile, such as addendum arc, involute, dedendum easement curve, axle hole arc and other boundary line section.

最后根据齿廓的几何尺寸和五类齿廓平面模型的边界范围，计算齿廓各部分，即齿顶圆圆弧段、渐开线段、齿根过渡曲线段、轴孔圆圆弧段和齿廓平面模型上其他边界线段上点的坐标，并连接这些点生成各部分线段，从而生成齿廓平面模型。

From 2004 to 2007, 34 cases were treated with extrapedicular screw fixation in Department of Orthopaedics, Third Affiliated Hospital of Sun Yat-sen University. The screw entry point, angle, depth and diameter were measured and defined on the thoracic vertebrae pedicle by CT thin-slice scan in standard prone for all cases before operation. The screw entry point was located at the tip of transverse process. The average inclination angle should be 10°-20° headward and 30°-40° toward neutral line respectively. The screw was inserted and entered into the vertebral body along the external cortex of pedicle. The integrity of cortical bone around screws, the distance to segmental blood vessels and the penetration of cortex were observed after operation to evaluate the accuracy and safety of screw placement.

应用椎弓根外内固定技术2004/2007年在中山大学附属第三医院骨科治疗34例患者，固定前采用CT加密扫描测量进钉点、进钉点至椎体前缘的深度、进钉角度和直径，固定中椎弓根钉入点为横突尖，进钉方向为平均向头侧倾斜10°~20°、与中线成角30°~40°，顺椎弓根外侧皮质进入椎体，固定后CT加密扫描观察螺钉周围的皮质骨是否完整、是否靠近节段血管、是否穿透皮质骨，评价置入钉的准确性和安全性。34例患者共置入160枚胸椎椎弓根螺钉，固定后CT加密扫描和X射线片观察到148枚(92.5%)螺钉置入准确，12枚(7.5%)螺钉发生错置。

Those canines with cervical anterior spinal artery injury showed incomplete paraplegia of the hind legs postoperatively, but the myodynamia restored to I degree within 3 days.

家犬的脊髓前动脉沿脊髓前正中裂下行，在脊髓不同的节段由前根动脉汇入补充，在不同的节段根动脉数量不同。

Methods Seven calf lumar spine specimens(T13~S2) were biomechanically tested under pure moment of 10Nm loading with Tenor pedicle screw system as the fixation device. Range of motion and intradiscal pressure were measured in all unfused segments and compared among the control group, the single-segment-fixed group (L4/5) and the double-segment-fixed group (L3~L5), and the correlation analysis was performed.

取7具小牛腰段脊柱标本(T13-S2)，以Tenor椎弓根螺钉系统作为固定器械，在10Nm纯力矩加载下进行生物力学测定，测定各活动节段的运动范围和间盘内压，比较完整对照组、L4／5单节段固定组和L3～L5双节段固定组间上述指标的变化，并进行相关分析。

objectiveto develop an accurate, sensitive and reliable hplc method for puerarin, and to study the absorption characteristics of puerarin in different intestinal sections and the influence of p-glycoprotein on the absorption rate.methodsrat everted gut sac was used.

目的建立准确、灵敏、可靠的葛根素高效液相色谱测定方法，研究葛根素是否存在分肠段吸收的差异并考察肠上皮组织上的p-糖蛋白（p-glycoprotein）对葛根素吸收的影响。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。