校正

In the thesis, the error analysis of the instruments and error correction curve is presented, so the measurement accuracy is relatively high.

论文中分析了仪器的误差，并画出了误差校正曲线，以达到提高了测量精度的目的。

However,the derivative of this error,the slope of the error curve,is large and positive,making the control correction provide by the derivative mode large.

然而，错误的导数和误差曲线的斜率较大且为正，导数模式提供了很大一部分的控制校正。

At the same time, ambient temperature changes affect the acceleration of the method There is a certain measurement error, but the error of law stronger, from the basic structure, measuring principle, numerical and other aspects of the process of measuring the inclination and measurement system The structure of error correction for analysis.

同时，由于环境温度变化时对加速度计的影响，该方法存在一定的测量误差，但误差分布规律性较强，因此从基本结构、测量原理、数值计算等方面对倾斜度测量的过程和测量系统结构误差的校正进行分析。

Then a corresponding artificial neural network structure to identify the parameters of error model is established.

最后，通过建立的误差模型实现了对转向误差的自校正。

The error model of the sensor is analyzed in detail and the flow of correction procedure is given.

详细分析了磁阻传感器的误差模型，提出用Broyden算法实现误差校正，并给出了在个人电脑上的实现结果。

The error correction of measurement system is very important in the measurement of S-parameter of microwave network used network analyzer.

摘要在网络分析仪对微波网络S参数的测量中，测量系统的误差校正非常重要。

To ensure consistency of the data between the two systems and reasonableness of their data, G-M tube detectors of the new system are calibrated and corrected to background, 20% system error was eliminated. After 18 months parallel operation and comparison, the relative error of monthly average reading is mostly less than 5%.

为了确保新旧监测系统数据的衔接与可比性，对新系统CP-110探测器进行了刻度校准和自身本底的补偿校正，纠正了约20%的系统误差；并对新旧系统进行了18个月的并列运行监测，其月均值的相对误差大多小于5%。

Methods The effects of the reading error and the misalignment of the probes on the accuracy of measuring and all the harmonics of roundness were analyzed; The strategy and the algorithm for optimizing the parameters of the measuring system were proposed; The distribution and propagation patterns of the measured errors for all the harmonics of roundness were studied in detail; A software for correcting the errors caused by the measurement error of the angle positions of the probes and the sensitivity difference between three probes was presented.

分析了测头读数及角位置误差对圆度各次谐波及圆周各点测量精度的影响；提出了三点法测量系统的优化策略与算法；研究了三点法测量误差的分布与传递规律；提出了克服测头定位误差以及3个测头的灵敏度不一致影响的软件校正方法。

Some problems in the application of data reconciliation, including the estimation of measurement error variances, nonlinear data reconciliation are discussed. And some results are given.

分析和研究了数据校正的一些实际应用问题，包括测量误差的方差-协方差估计和非线性数据协调问题等，并给出了一些实例验证。

The RS and GIS information of eachpixcl can be extracted after the remote sensing image having been calibrated is superimposed onthe models of DEM of estimation region.

将校正后的遥感图像叠合到估测区域的DEM模型上，有效提取每一像元对应的遥感和GIS信息。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。