树脂

Methods:(1) Silica column chromatography and LH-20 were used in phytochemistry study.(2) Based on the extraction ratio of arctiin, the best extraction procedure was acheived under the direction of L9(34) orthogonal experimental design. From 10 types of resins, the one with the maximal binding ability for Arctii was selected and silica-column choramatograpy was used in its seperation and purification procedure.(3) The animal diabetic experimental model in Wistar rats was established with streptozotocin and many biochemical factors were used to indicate the pharmacological effects of arctiin, including glycosylated hemoglobin, serum creatinine, seralbumin, monoxide nitrogen, glycerin trilaurate, cholesterol, HDL-ch, LDL-ch, Blood urea nitrogen, creatinine, SOD, ET, MDA, total Urine protein and albuminuria.

(1)采用硅胶柱层析、聚酰胺层析、LH-20等方法对牛蒡子的化学成分进行研究；(2)采用正交实验设计方法，以牛蒡子苷为指标，确定了牛蒡子乙醇回流提取的最佳工艺；对10种类型大孔吸附树脂进行筛选，筛选出对牛蒡子苷吸附效果最佳的树脂；采用硅胶柱层析法，对牛蒡子苷进一步分离纯化；(3)建立实验性糖尿病大鼠模型，以GLU、TC、TG、HDL-ch、LDL-ch、TB、ALB、BUN、CREA、GHbAlc、NO、SOD、ET、MDA和尿液中TB、ALB为指标，研究牛蒡子苷药理活性；(4)以差速消化法纯化Wistar大鼠的主动脉内皮细胞并进行传代培养，测定牛蒡子苷对高糖条件下RAECs活性、RAECs释放LDH、MDA和NO的变化以及RAECs表达内皮型一氧化氮合酶表达的影响。

Any of various hard resins obtained from trees of the genera Shorea, Balanocarpus, and Hopea, native to southeast Asia and the Malay Archipelago and used in varnishes and lacquers.

达马树脂从婆罗属和坡亚属的树中提取的一种坚硬的树脂，原产于东南亚和马来群岛，用在假漆和天然漆中

In this paper, active groups terminated silicane was used to react with the hydroxyls of bisphenol A epoxy resins, that introduced organic silicon without consuming epoxy groups. This modifying process improved the combining degree of the cured resin, so both the toughness and the other characters (as strength, thermal resistance) were all could be improved.

为此本论文采用国内外文献中尚未见报道的、带活性基团的有机硅来改性双酚A型环氧树脂，通过端基基团与环氧链上的羟基反应生成大键能的Si-O键的方式来引进有机硅，改性过程中不仅不消耗环氧基，并且还提高了树脂固化物的交联密度，所以既能增韧树脂，又能提高其耐热、耐冲击等各项性能。

Butyl p-hydroxybenzoate was synthesized from p-hydroxybenzoic acid and butanol with sulfoacid resin as catalyst. The optimum conditions were as follow: ratio of n-butanol, p-hydroxybenzoic acid and sulfonic acid resin was 0.25 mol ∶ 0.05 mol ∶ 1.5 g, refluxing for 5 h using water separator at the reflow reaction temperature.

摘 要：以对羟基苯甲酸和丁醇为原料，用磺酸树脂作催化剂，催化合成了尼泊金丁酯，优化反应条件为：n∶ n=5 ∶ 1，催化剂磺酸树脂的用量为对羟基苯甲酸质量的21%，反应温度为回流温度，反应时间为5 h。

Adhesive has environmentally-friendly products are mainly urea-formaldehyde resin, melamine urea-formaldehyde resin and modified phenolic resin; concrete water reducer products are mainly water-reducing agent has Sulphamate, polycarboxylate water reducer and superplasticizer melamine.

胶粘剂产品主要有环保型脲醛树脂、三聚氰胺改性脲醛树脂和酚醛树脂；混凝土减水剂产品主要有氨基磺酸盐减水剂、聚羧酸减水剂和三聚氰胺减水剂。

Automatic control of exposure time, vacuum degree, plate cleaning time and temperature en sures quality of plate dev.of resin plate .It is especially applicable in high resolution sensitizat ion resin printing.

自动控制曝光时间及真空度、洗版时间、烘干时间及温度，从而可以保证树脂的晒版质量，特别适用于制作高网线的感光树脂版印刷版。

A photosensitive resin for UV curing acrylic powder coating has been synthesized by esterification of methacrylic acid and GMA-type acrylic resin at the presence of ethyl acetate as solvent, tetramethylammonium chloride as catalyst, YK as inhibitor.

以醋酸丁酯为溶剂，四甲基氯化铵为催化剂，氮氧自由基为阻聚剂，由甲基丙烯酸缩水甘油酯类丙烯酸树脂与甲基丙烯酸酯化反应制得了UV固化粉末涂料用感光性丙烯酸树脂。

The result showed that, rutile TiO2 was well consistent with carrier resin, so the prepared masterbatch had glabrous of surface, and application was better than acute TiO2; the masterbatch was prepared by using polymerization PE wax, whose application is better than masterbatch prepared by using other PE wax, such as hiding power of the film, whiteness of the templet; dispersion of TiO2 was uniformity, and application was improved, in particular hiding power and tinctorial power by adding PPA and nanocalcium carbonate in masterbatch.

结果表明，浓PE白色母粒的加工制备，样品中金红石型钛白粉与载体树脂相容性较好，载体树脂仍能形成连续相，制备出表面光洁的色母粒，且应用性能较优于锐钛型钛白粉；聚合型聚乙烯蜡制备的浓白色母粒，薄膜透过率较低，光密值较大，母粒的遮盖力强，注塑样板的白度高，母粒的着色力强，应用性能优于其它聚乙烯蜡；浓白色母粒中加入PPA和纳米碳酸钙，使钛白粉粒子的分散均匀，提高了母粒的着色力、遮盖力等应用性能。

The effects of solution\'s pH value, mol ratio between phenyl aldehyde and L-Arginine, concentrations of sodium chloride, ammonia chloride andL-Lystine, initial concentration of L-Arginine on precipitation rate of a -tolylene arginine were investigated, the results indicated that phenyl aldehyde precipitation method\'s appropriate pH value was higher than 11, suitable mol ratio between phenyl aldehyde and L-Arginine was 1.25, initial concentration of L-Arginine was must higher than 15g/L, sodium chloride had little effect on precipitation rate, on the contrary, ammonia chloride and L-Lystine had great effect on it, both of them must be eliminated; At the same time, adsorption isotherm at 25 C of L-Lystine on anion exchange resin A was measured, the result showed that the maximal equilibrium adsorbance was 30mg/g, the influences of solution\'s pH value, temperature, concentration of chloride ion on adsorption of L-Lystine by anion exchange resin A were also studied, the results indicated that appropriate operational pH value was 0.5 0.2, the effect of temperature on adsorption ratio was little, process could be operated at room temperature, the concentration of chloride ion must be eliminated.

考察了溶液pH值、苯甲醛与L-精氨酸摩尔比、氯化钠与氯化铵浓度、L-赖氨酸浓度、L-精氨酸初始浓度对苯甲醛沉淀L-精氨酸的影响，结果表明，沉淀反应的适宜pH值大于11，苯甲醛与L-精氨酸的适宜摩尔比为1.25，(来源：Aa6BC论文网www.abclunwen.com)L-精氨酸适宜的初始浓度在15g/L以上，氯化钠的存在对沉淀率基本上没有影响，而氯化铵和L-赖氨酸的存在使沉淀率下降；同时测定了25℃时阴离子交换树脂A吸附L-赖氨酸的吸附等温线，表明其最大平衡吸附量为30mg/g，考察了溶液pH值、温度、氯离子浓度对阴离子交换树脂A吸附脱除L-赖氨酸的影响，结果显示从L-精氨酸和L-赖氨酸混合液中吸附分离出L-赖氨酸的适宜pH值为10.5±0.2，温度对L-赖氨酸吸附率影响不大，吸附过程可在室温下进行，氯离子的存在使L-赖氨酸的吸附率降低。

The polymeric resin NDA-8 was employed to treat the industrial wastewater from hydrogenated deoxidization process in tolylene diisocyanate production and good performance of adsorption and desorption was shown.

经树脂吸附处理，废水中主要污染物2，4-二氨基甲苯和2，6-二氨基甲苯均得到完全去除，COD由6 300mg/L降为150mg/L以下，达到国家二级排放标准，采用稀盐酸可实现树脂的完全再生，高浓度脱附液经调碱和结晶，可回收2，4-二氨基甲苯和2，6-二氨基甲苯

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷