树脂

To optimize the compounding of the photo-sensitive resin, a novel prepolymer was synthesized and token by FT-IR. The prepolymer was an alicyclic epoxy acrylate, which was synthesized from the alicyclic epoxy resin.

为了优化光敏树脂配方，作者又合成了一种光敏树脂组分中的主体树脂并经傅立叶红外光谱表征，该树脂是以脂环族环氧树脂为原料合成的脂环族环氧丙烯酸酯。

This paper has studied the synthesis of hot-melt road marking paint using modified rosin -alkyd resin.

还研究了路标涂料基料树脂的合成，其中包括改性松香树脂的合成、醇酸树脂低聚物的合成以及改性松香-醇酸树脂的合成。

The results are listed as following :㏕he best anti-erosion proportion of resin present is 25wt% in the condition of silicon carbide reinforced SMCC, while the alumina reinforced SMCC is 40wt%.(2) The better anti-erosion results was achieved with the ratio of silicone resin to acrylic resin containing hydroxy being 3: 1.㏕he composites coating tends to be more brittle when added in alundum particles. It also means that the maximum erosion peak of alundum reinforced SMCC tends to normal angle.甌he change of erosion rate of SMCC can be divided into two stages with the increment erodent velocity: the slow erosion stage of the beginning and the stable erosion stage.

首次发现：①SiC增强的复合涂料涂层，树脂含量为25wt％时，具有最佳耐冲蚀性能：Al_2O_3增强的复合涂料涂层，树脂含量为40wt％时，具有最佳耐冲蚀性能；②SiC增强的涂料，有机硅树脂与丙烯酸树脂的比例为3：1时的耐冲蚀性能好于1：1的复合涂料涂层；③Al_2O_3增强体使涂层变脆的倾向大于以SiC为增强体的涂层，即SiC增强的复合涂料涂层的最大冲蚀率出现在30°，Al_2O_3增强的复合涂料涂层的最大冲蚀率出现在75°～90°之间；④低速冲蚀磨损机理主要是弹性变形与疲劳；高速冲蚀磨损机理主要是显微切削和显微犁耕。

First of all, titanium has excellent biocompatibility, high mechanical strength and low proportion; the second, the potential biological toxicity of non-noble alloys (such as alloys of Co-Cr and Ni-Cr)was avoided; the third, the disadvantage of over-abrasion of antagonization teeth resulted from high rigidity of porcelain was also avoided; the last, metal-resin bonding prostheses was easy to be repaired in mouth.

随着硬质树脂性能的进一步提高及钛铸造技术和粘结技术的发展，钛-树脂粘结修复体的应用将越来越广。通过课题组成员的一致努力，以往困扰钛-树脂粘结修复在临床应用的钛与树脂的粘结强度较低这一关键问题已较好的得以解决。

And the kinetics of exchange between FDP-Cl ion with HJ-30 weak base ion exchange resin were studied.

研究1，6—二磷酸果糖的分离工艺时，提出选择树脂时应综合考虑树脂对FDP的吸附容量和分离因数α〓和α〓，结果发现HJ—30阴离子交换树脂适合FDP的分离，并考察了该树脂和FDP相互交换动力学关系。

As an important industrial solvent,it is capable to dissolve cellulose ether, cellulose ester, nitrocellulose ,alkaline base dyestuff, PVC, polyvinyl acetate, polymethylmethacrylate, polystyrene, coumarone resin, 100% phenol resin, modified phenol resin and various natural resins.

能溶解纤维素醚、纤维素酯、硝化纤维素、碱性染料、聚氯乙烯、聚醋酸乙烯酯、聚甲基丙烯酸甲酯、聚苯乙烯、香豆酮树脂、100%酚树脂、改性酚树脂以及多种天然树脂，是一种重要的工业溶剂。

And they have been used in composites, adhesives, and electrics. However, like most other thermosets, they have suffered the drawback of brittleness. At the same time, reports on cyanate esters are all focused on bisphenol A dicyanate ester.

但像其它的热固性树脂一样，氰酸酯树脂普遍存在脆的弱点，限制了其应用，同时，目前关于这类性能优异的树脂基体的研究都集中在双酚A型氰酸酯树脂上。

The requirement of matrix resin for the high frequency and high performance copper clad laminate was introduced and polyphenylene ether resin, cyanate resin and polyimide resin were also discussed in detail.

介绍了高频高性能覆铜板对基材的性能要求，详细讨论了聚苯醚树脂、氰酸酯树脂及聚酰亚胺树脂的特性，并简要介绍了各种树脂基覆铜板的应用情况。

Anatomical experiment on slice, eduction and transparency of leaves of Cedrus deodara were conducted to study the number of resin canal, cell structure and the whole eduction observation.

通过常规切片和整体透明离析处理的方法对雪松针叶树脂道进行全面的解剖学研究，描述了雪松针叶树脂道的数目和位置、树脂道细胞的结构，对树脂道进行整体离析观察。

The good elution concentration of ethanol was 50 % for D101 resin, and 60 % for HP20 resin.

结果表明：国产多孔树脂D101和日本产HP20树脂在水溶液中，对甘草苷的最大吸附量分别为238.7 mg/g和278.9 mg/g；吸附后的D101树脂和HP20树脂洗脱甘草苷的最佳乙醇浓度分别为50%和60%。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。