树脂

So piperylene petroleum resin was applied preferably in downstream products,and the products yield was increased by improving post treatment process.

介绍了国内外间戊二烯石油树脂合成技术的改进进展，主要体现在催化体系的改进及聚合单体和溶剂的改变，通过引入官能团及共混等方法改善间戊二烯石油树脂的色度、耐候性和相容性等性能，从而使间戊二烯石油树脂在下游产品中得到更好地应用；通过后处理精制工艺的改进，可提高产品的收率。

The resol phenol-formaldehyde adhesive could be prepared from liquefied wood (wood: phenol=1:2) in phenol at r(subscript F/P) 1.8, r(subscript NaOH/P) 0.7 and resinification temperature 80℃. The physical properties of the poplar three-layer plywood bonded with LWR were similar to those with normal PF resins and also satisfied the demands of I level. Free formaldehyde content of plywood (0.1 mg/L) was lower than the E0 level set by GB/T 9846-2004 Plywood.

结果表明，采用料液比为1：2的液化物，F1.8，r0.7，树脂化温度80℃条件下合成的杉木液化物树脂压制的杨木三层胶合板满足I类胶合板强度要求，各项物理力学性能与常规PF树脂压制的板材相当，板材的甲醛释放量为0.1mg/L，远低于GB/T 9846-2004《胶合板》中的E0级要求。

The adsorption isotherms for mixture of xylose and sorbinose on 732Ca〓 and 732Fe〓 ion exchange resins are measured. All the linear equilibrium relationships are obtained in the experimental condition. The adsorption selectivity of 732Fe〓 is preferred.

本文用静态法测定了木糖—山梨糖混合溶液在732Ca〓型和732Fe〓型树脂上的吸附平衡关系，结果表明，在实验浓度范围内，吸附等温线为线性，732Fe〓型树脂的吸附选择性优于732Ca〓型树脂。

Both of adsorption of VB〓 on sulphonic resin in Zn〓form from ethanol and caffeine on sulphonic resin in Cu〓 form from ethyl acetate is considerable, with saturation adsorption capacity 60 and 76mg/g respectively.

磺酸锌型树脂对乙醇中VB〓、磺酸铜型树脂对乙酸乙脂中咖啡因和丙烯酸铁型树脂对甲醇中的鞣酸均具较好的吸附性能，其静态饱和吸附量分别为60、76和34mg/g。

Main products are Perfluorosulfonated acid resin, PFSA aqueous dispersion, and on the basic of them, HFPO,TFE sultone,PSVE,PPVE,MTPME etc fluorinated fine chemicals,and FEP,FKM,PVDF etc fluorpolymers.

公司主导产品有全氟磺酸离子交换树脂、全氟磺酸离子交换树脂溶液，同时以此为依托，配套生产六氟环氧丙烷、四氟磺内酯、PSVE、PPVE、甲氧基四氟丙酸甲酯等含氟精细化学品，聚全氟乙丙烯树脂（FEP，F46）及分散液、氟橡胶、聚偏氟乙烯等含氟高分子材料。

Totally, seven dihydroabietic-type resin acids,five dihydropimaric\isopimaric-type resin acids and three tetrahydro resin acids were identified in the tracking analysis.

在整个跟踪分析过程中，共检出7种二氢枞酸型树脂酸、5种二氢海松酸\异海松酸型树脂酸及3种四氢树脂酸。

The red pigment from Parthenocissus Tricuspidate was extracted and purified with macroporous resin of type HPD-600 using methanol as the eluent.

比较了6种不同型号的大孔树脂对爬山虎红色素的吸附能力，筛选其中最佳的HPD 600树脂作为爬山虎红色素的吸附和分离的树脂；用甲醇作为洗脱剂，洗脱效果较好；研究了食品中6种常见的共存物、4种金属离子、氧化剂、温度及光等对爬山虎红色素稳定性的影响。

In this paper, the governing equations of resin flow are presented on the base of the seepage mechanics, the thermodynamics and the chemical kinetics. The unlumped temperature system (i. e. thermal non-equilibrium locally) is used to describe the thermal behavior in the RTM process, the resin reaction and heat transfer among resin, mold walls, and fibers are considered in the model.

本文针对RTM工艺树脂润湿增强纤维特点，在渗流力学、热力学和化学动力学等基础上，建立了树脂流动控制方程，采用非局部热平衡法描述了树脂、纤维和模具之间的热传递现象。

OBJECTIVE: To explore the dynamic viscoelasticity difference of unpolymerized light-cured composite resins with retentive filler or normal filler, and to investigate effect on the clinical manipulation properties of rheological behaviors in two light-cured composite resins to define an ideal resin.

目的：评价含固位性填料（retentive filler，RF填料）和普通填料（normal filler，NF填料）的未聚合光固化复合树脂的动态黏弹性，并探讨两种光固化复合树脂动态黏弹性对临床操作性能的影响，以确定理想的光固化复合树脂应具备的条件。

The basic range of FUCHEM VER are unpromoted and required the addition of both accelerators and promoters just like general UPR. The selection criteria of the curing system and amounts depend on the desired gel time, the temperature of both the resin and workshop, the laminate thickness, humidity, impurities and the posting-curing possibilities.

FUCHEM系列乙烯基酯树脂一般为非预促进树脂，固化系统与通用不饱和树脂类似，在室温或90℃以下固化时，应该加入固化剂和促进剂，但因根据成型工艺、作业温度、制品厚度、湿度大小等调整相应的加入量，同时根据不同的情况选用不同类型的固化系统。

They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.

他们没有侵略性，但我大喊，并在他们的方向扔石头让他们过的线索，远离我，以防万一。

In slot 2 in your bag put wrapping paper, quantity does not matter in this case.

在你的书包里槽2把包装纸、数量无关紧要。