柄的

Leaves 5, not fully expanded at anthesis; petiole 5.5--15 cm, with thick long pilose hairs; leaf blade nearly kidney-shaped, rounded-ovate, or 5-angled, 2.5--7 × 4.5--11 cm,± equally 3-foliolate, abaxially with white hairs, adaxially glabrous, base broadly cordate; lateral leaflets subsessile, unevenly 2-lobed; central leaflet subsessile or with a 1--4 mm petiolule, deeply 3-lobed, lobes entire or dissected, ultimate lobes triangular to narrowly linear and 2--3.5 mm wide.

叶5，不完全膨大的在花期；叶柄5.5-15厘米，具厚具长柔毛毛；叶片差不多肾形，圆形卵形，或具5个角， 2.5-7 * 4.5-11厘米，多少具3小叶，背面具白色的毛，正面无毛，基部宽心形；侧生小叶近无柄，不均匀2裂；中心的小叶近无柄或具一1-4毫米小叶柄，3深裂，裂片全缘的或多裂，末级的裂片三角形到狭线形和2-3.5毫米宽。

We possess the particular manufacturing techniques to maintain our wooden sticks under the perdurable stability and solidity, avoiding the crazing, which is the representative of our advantages.

我们有特殊的制造工艺以使我们生产的木柄能够保持耐久的稳直和坚固，不会开裂，这是我们木柄产品的优势所在。

For our purpose, we will pass write handle of the pipe as the standard output and error of the child.

为了达到我们的目标，我们将传递管道写端的句柄作为子进程的标准输出和标准错误的句柄。

Result The results showed that the substrate carbon conversion efficiency of Amygdalus mongolica Maxim. and Amygdalus pedunculata Pall. was all a constant, was 0.55, 0.57 respectively. The adapted growth temperature scope of Amygdalus mongolica Maxim. and Amygdalus pedunculata Pall. was 14-24, 13-33 ℃ respectively. The optimal growth temperature of Amygdalus mongolica Maxim. and Amygdalus pedunculata Pall.

结果］结果表明，在所测定的范围内，随温度变化蒙古扁桃和柄扁桃的底物碳转化效率为常数，分别为0.55、0.57；适宜蒙古扁桃生长的温度范围为14~34℃，最适生长温度为25℃，适宜柄扁桃生长的温度范围为13~33℃，最适生长温度为24℃。

The main characters of this category are: 1 It possesses clear main axes and lateral branches/sporangial stalks; 2 Sporangia terminate the lateral branches or long stalks; 3 With the distinct dehiscing mechanism, the sporangia have the variation in shape, i. e. reniform, rounded or vertically elongate; 4 Primary xylem is of centrarch maturation; 5 Conducting tracheid is G-type.

该类群包括Hsüa，Renalia，Nothia，Sartilmania和Huia，其主要特征为：1）具有明显的主茎轴及侧出的分枝系／孢子囊柄；2）孢子囊顶生于侧枝上或侧生的长柄上；3）孢子囊性状存在变异，为肾形、圆形或纵向伸长，具明显的开裂机制；4）初生木质部发生顺序为心始式；5）G-型输水管胞。

It uses LVM_GETEDITCONTROL message to return the handle of the actual edit control used by MFC and then subclasses the handle in order to re-postition the control over the subitem you wish to edit.

它使用LVM_GETEDITCONTROL 消息来返回实际的由MFC使用的编辑框控件的句柄，接着子类化句柄以重定位编辑框在你想要编辑的子条目上。

The knife was a Sabre brand, with a bone handle, brown and yellow, yellowed and browned even more with age, a burl on the metal blade case as if it had been creased by a bullet, or a hot torch.

刀是骑兵牌的，黄褐色的骨柄贴片已经老化，变得越来越黄，越来越褐，柄背的金属部分有一块斑痕，像被子弹或喷灯留下的烙印。

Results show that both the densities of attached ciliates and the ratio of attached ciliates present in protozoan community could be used as indicators of removal efficiency of COD and PCP during the activated sludge process.

结果发现：每毫升活性污泥中有柄纤毛虫个数的变化趋势与系统中微生物总体活性的变化趋势一致，有柄纤毛虫占系统中原生动物总数的百分比能大致指示该系统PCP的去除效率。

Thus,locks through the rail switch electricity the contact locks for the signal electricity the magnet coil delivers the electric current,only then the switch location correct only then causes the closed circuit,the signal electricity to lock has the enough electric current,after namely the approval moves the signal handle to cause the semaphore opens,by the signal electricity locks the contact for the rail switch electricity to lock the magnet coil power transmission electric circuit to separate,therefore cannot move the rail switch handle again,soon the rail switch locks in the position.

这样，通过道岔电锁器的接点给信号电锁器的电磁线圈送电流，只有道岔位置正确才使电路接通，信号电锁器有足够电流，即准许扳动信号握柄使信号机开放后，由信号电锁器的接点给道岔电锁器电磁线圈送电的电路被断开，于是再不能扳动道岔握柄，即将道岔锁在规定位置上。

Based on the analysis of the milling theory of the mill-tenon machine, the cutting force and power were calculated. The structure and capability of milling tools (including multi-blade mill-cutter, three-blade handle mill-cutter and eccentric mill-cutter) were analyzed.

本文分析了数控铣榫机的铣削原理，对铣榫时的力和功率做了初步计算，分析了铣榫用的盘状多刃铣刀、三刃柄铣刀及偏心柄铣刀等刀具，对其结构和性能作了较深入的研究。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐