析出硬化

In the duplex steels χ-phase is a good strengthener, manifesting pronounced hardening effect at elevated temperature.

在所研究的两种复相不锈钢中，都观察到有由于x相析出所引起的沉淀硬化现象。

This welding wire not only has the inherent properties of metal powder-cored wire, such as with better welding quality, without slag, highly efficiency and conveniently adjusting the alloying elements etc., but also has the advantage of low hardness in as-welded (less than HRC45), good machinability, high hardness in as-aged (more than HRC55) and better wear resistance with customary working procedure on making or repairing equipments such as rollers when reasonable designing the alloys content. The author adequately makes use of the high-tempering in the required stress relieving working procedure. During this working procedure, which causes the hardness of overlaying metal increased by the reason of austenite changes into tempered martensite and more chiefly what is the precipitation of a lot of carbide by secondary hardening simultaneously. This wire can solve the hard rolled problems of some solid wires with higher alloys while it can get over the conflict of existing overlaying materials what are always possesed high hardness with poor machinability or low hardness, good machinability with poor wear resistance. Further, it also can overcome the intenerating phenomena between welding beads and make the external hardness of overlaying metal uniform. Be sure it could be found important meaning in the overlaying of wear-resistant equipments, such as the precise roller.

该焊丝除了具有金属粉型药芯焊丝焊接质量好、无渣、高效率和合金成分可方便调节等固有的优点外，合理的设计粉芯中的合金成分，按通常工序制造与修复轧辊等设备，充分利用必需的消除应力工序的高温回火，堆焊层金属在奥氏体转变为回火马氏体的同时更主要是通过二次硬化析出了大量碳化物导致硬度增加，使得该焊丝还具有焊态硬度低(小于HRC45)、机加工性能好和时效态硬度高(大于HRC55)、耐磨性能好等优点，解决了某些高合金实芯焊丝轧制困难的问题，同时克服了现行堆焊材料硬度高、加工性能差或者硬度低、加工性能好、耐磨性差的矛盾，并能克服焊道之间的软化现象，使堆焊表面硬度较为均匀，对耐磨件，譬如精轧辊的堆焊具有重要意义。

Along with the course of precipitations its morphology changed and the mechanical properties of AZ91HP were also changed and shown obvious precipitation hardening.

伴随着β-Al12Mg17相的析出与形态转变过程，AZ91HP性能也随之变化，显示了明显的时效硬化特征。

An in-situ precipitation hardening effect was also found to be partially responsible for the cyclic hardening in Condition A at 400oC.

其中即时的析出强化效应亦是造成Condition A於400oC下循环硬化的原因之一。

The influence of secondary carbides precipitation and transformation on hardening behavior of a 14Cr-1Mo-1.5V cast iron in sub-critical treatment was studied using optical microscope, transmission electron microscopy and X-ray diffraction.

为了揭示高铬耐磨铸铁硬化的微观机制，提高其使用性能，采用光学显微镜、透射电镜和X射线衍射研究15Cr-1Mo-1.5V高铬铸铁中二次碳化物的析出和转变对其亚临界处理硬化行为的影响。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。