板间的

The theory of complex variable function for anisotropy plate combined with boundary collocation method is applied to calculation pin-loads and contact region as well as the contact stress on the hole boundary.

采用各向异性板的复变函数理论和边界配置方法，对连接件进行分区，加以限制条件，对多钉连接的复合材料层合板的钉载和板与螺栓间的接触应力和接触区域进行了计算。

By using CFD software FLUENT,numerical simulation for the three-dimensional flow of air between honeycombed plate heat transfer component s is carried out.

应用CFD软件FLUENT对蜂窝板传热元件板间空气的三维流动进行了数值模拟。对中心间距为19 mm的蜂窝板传热元件在不同质量流量情况下的换热和阻力特性进行了计算分析，给出了在300

Therefore, combined with the past experiences of the optimization of satellite structures and based on the characteristics of honeycombed sandwich panel which is used a lot in the satellite structure, we propose an equivalent panel modeling method and it can avoid the inconveniences of design variables of honeycombed sandwich panel.

为此，作者结合卫星结构设计方面的经验，并根据卫星结构中大量应用的蜂窝夹层板的特点，提出了等效蜂窝夹层板和考虑板间连接刚度的一整套方案，为建立简单可靠，使用方便的卫星结构有限元模型提供了有效的方法，从而避免了蜂窝夹层板选取设计变量方面的诸多不便。

The restoring Casimir force, which is the force that changes from repulsion to attraction with the increasing slab separation, may be found to exist between perfectly conducting material and metamaterial slabs. This restoring force is a natural power for the system oscillation in vacuum and also can be used for system stabilization

而若将其中一个材料板取为理想导体板，Casimir效应则可表现为随板间距的增大从排斥力转变为吸引力即平衡回复力，这种力可用来产生板间振荡或稳定真空中的力学系统。

The temperature of the fuel plates and pectinate localizers is high, and the temperature of the side panels is close to the temperature of the flows between fuel plates, and the temperature of the flow outside of the side panels is low.

燃料板和定位梳的温度最高，侧板温度与板间流体温度相近，侧板外侧的流体温度较低。

Once the sparger installed in the CMT, the fluid temperature above the sparger and the initial pressure of pressurizer are the key factor, which affect the condensation characteristic and temperature equilibrium time.

通过对不同初始条件下的CMT排水量进行了分析，发现CMT排水速度主要受CMT内的压力变化的影响：CMT无遮流板排水实验中所有排水量随时间的变化曲线都是单调递增的，且都有一个较为明显的拐点，在拐点后，斜率明显增大，说明排水速度增加显著；CMT加遮流板排水实验中排水量曲线的拐点不明显且出现时间较无遮流板排水实验要早，说明排水速度增加得较早；CMT加遮流板排水实验如果PRZ初始压力较大，通过改变CMT的初始温度，将会引起排水总量较大的变化；排水速度平衡时间受CMT压力平衡响应时间的影响，且较CMT压力平衡响应时间快。

It can be used to design and calculate the oil proof sump with tilted plate.

对于斜板隔油池，考虑到板间液流的速度分布和油滴的粒径分布，提出一个油滴脱除率的计算方法，可用于斜板隔油池的设计计算

In the sense of Von Karman large displacement, the governing equation of nonlinear dynamic response of the clamped circular plates under impact of a mass is established by using the virtual displacement principle and Galerkin's method in this paper. The effect of coupling between the impact load and the displacement of. the circular plates is considered. The governing equation is solved by applying the time increment method and the singular perturbation theory, and the asymptotic solutions of nonlinear dyna...

本文在Von Kármán大位移的意义上，利用虚位移原理伽辽金方法建立了圆板在物体撞击下的非线性动力响应的控制微分方程，在研究响应问题时，考虑了冲击载荷与圆板位移响应之间的耦合影响，文中使用时间增量法和奇异摄动理论求解问题的控制方程，获得了固支圆板非线性动力响应的近似解，并且求解了具体算例，绘出了圆板位移、应力响应曲线以及冲击力随时间的变化曲线。

In electronic engineering, we usually have to bond a micro-strip board to a metalcarrier in order to provide proper stiffness, thermal conductivity and electrical conductivity, thus to make general handling,solder stencilling, pick and place of components be easier, and prevent the warping or distortion of the board during soldering.

林伟成，微带板与金属载体间的大面积焊接及胶接方法工程中常常需要把微带板和金属载体焊接或胶接起来，以获得合适的刚性、电导率和热导率，从而使丝网印刷、元器件贴装等工艺过程变得更加容易。并防止焊接过程中微带板的翘曲和变形。

In the centrifuge model test of the construction of Chahanwusu CFRD on deep overlying, the conclusion was drawn, namely it is feasible that the CFRD be construction on deep overlying, with the toe slab directly construct on deep overlying, the vertical seepage control by concrete cut-off wall, and the connection of cut-off wall and toe slab by two connect slabs.

从试验结果上看，虽然蓄水后连接板、趾板都有向上游的移动，但未发现防渗墙顶、连接板和趾板间有明显的拉开现象，说明从结构受力变形的角度来看，坝体坝基的防渗系统的防渗功能是可以保证的； 2。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。