条件方程

The electrical characteristics of SiC MOS devices are studied by solving the Poisson's equation.

通过对电中性条件和泊松方程的数值求解，研究了SiC MOS的电特性。

Using the uniform design experimental method, the optimum complexing and extracting condition is that 97.6% DMF, 1.1% FeC13 and 1.2% polar solvent after the regression equation was established and mathematical analysis was carried out.

利用均匀设计实验方法进行了络合实验，并回归出相关的数学方程。在数学分析的基础上得出了最佳的络合萃取条件，即在DMF为97.7%，FeCl3为1.1%，极性溶剂为1.2%时，可以达到最佳的络合脱硫效果。

The assumption of the variable tendency of slip-line in active zone is made based on the numerical results. Combining the slip-line equations and boundaries, the formula of bearing capacity is deduced which can consider the density of soil. The formula of bearing capacity of strip footing on ponderable soil is also deduced assuming that the slip-line field of ponderable soil is the same with that of weightless soil, which is proved to be an upper-limit solution, as its the same with that deduced by the upper-limit method in Prandtl mechanism.

在数值计算结果的基础上，对有重土地基主动区滑移线变化趋势进行了合理假设，根据边界条件和特征线方程求得了条形基础极限承载力的解析表达式，该表达式可以计算考虑土重度的条形基础的极限承载力；获得了不考虑重度对滑移线场影响时(即有重土在普朗特尔滑移线场下)极限承载力的解析表达式，该表达式与普朗特尔机动场对应的极限承载力上限解的表达式相同，这就从理论上证明了在土重度对滑移线场没有影响这一假定前提下得到的极限承载力是一个上限；(3)利用上限定理求解了极限承载力的最小上限。

Under some proper conditions we prove the existence of optimal controls in the class of Lipschitz functions, and obtain an optimality condition looks somehow like Pontryagin's maximum principle for a smooth optimal control function.

在适当的假设条件下，我们证明了状态方程解的存在唯一性和最优控制的存在性；并且根据最有控制函数的光滑性进一步对最优化存在的必要条件进行分析。

The scattering wave velocity potential to the flexible circle pile was the solution of the Laplace equation, which satisfied the cylindrical surface non-homogeneous boundary condition.

采用动力Winkler弹性地基梁模型模拟桩土动力的相互作用，通过求解满足柱面非齐次边界条件的Laplace方程，直接构造波浪对柔性桩的散射速度势，考虑了流体和桩体的相互作用，由解析法给出了埋置圆桩在波浪荷载下的动力响应。

The new method gives out a set of equations based on the fundamental algebra rules that principal stress trace obeys and the essential attributes it possess, we then combine these equations with further information described in this paper leading to an exact description of the conic representing the principal stress traces.

该方法是根据主应力迹线满足过任意三条等倾线的主应力都可以用二次曲线来描述这一条件，再利用主应力迹线本身所具有的性质列出方程组解算出描述主应力迹线的一元二次方程，然后根据方程描绘出所求的主应力迹线。

In this project, the stability of a class of complex dynamical system with infinite dimensions is investigated. The dynamical systems are described by the infinite differential equations with time delays. The comparison principle of the stability for the infinite dimension system is obtained.

本项目研究一类以无限个具有时间滞后的常微分方程关联而成的复杂动力系统的稳定性，建立了这类无限维系统中的比较原理，得到了无限维比较系统的稳定性条件和比较系统的集结方法，建立了无限维复杂时滞系统稳定性分析的矢量Liapunov方法。

Furthermore the existence condition and the variation principle of the differential equation are discussed, and the theory gist of the step-time technologies is presented.

应用相关的势算子理论对抛物型偏微分方程的泛函存在条件及变分定理进行了较系统的讨论，进而指出了"时间步进有限元法"各种处理方法的理论依据。

Starting from the main meteorological factors impacting vibration of overhead line, the impact of conductor tension variety on self-damping feature of conductors is analyzed according to state equations of overhead line, and by use of energy balance principle the variation of vibration level is calculated and the vibration life under different meteorological conditions are obtained.

文章提出了一种基于短期测量数据评估线路全年振动状态和寿命的方法，从气象影响线路振动的主要因素出发，根据导线的状态方程分析导线因张力变化对导线自阻尼特性的影响，并采用功率平衡法计算出振动水平的变化，得到了不同气象条件下的振动寿命。

Based on the variational principle of virtual voltage and virtual displacement derived in this thesis and the classical theory of linear laminated plates, and by using the constitutive equations of elastic piezoelectric materials, and the DKQ quadrilateral plate bending element, the finite element modeling for the fabric reinforced laminated plates with nonlinear voltage-electric strain relationship of piezoelectric actuators has been established for the first time in this thesis. And the expressions for the electric loadings with obvious mechanical meaning and convenient for computation are established, which can be used to the deformation analysis of laminated plates with piezoelectric actuators under specified voltages.

以本文直接导出的压电结构的虚电势—虚位移变分原理为基础，依据经典线性层合板理论和压电弹性体的本构方程，采用基于离散法线假设的DKQ四结点任意四边形薄板弯曲单元，首次建立了考虑非线性电压—电应变关系的含压电致动器的纤维增强型层合板的有限元分析模型，并推导建立了力学意义明确、便于计算的电荷载表达式，可用于指定电压条件下纤维增强型叠层合成板的变形分析。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。