条件分布

The results indicate that the cooling rate of melt droplet that can not break further depends not only on its diameter, but also on its position in atomizing chamber. As a result, the same sized particles in different positions show different cooling rates and two different kinds of microstructures. The cooling rates of melt droplets range from 104 to 108 K/s, and the critical cooling rate for glass formation of Al-Ni-Y is about 105 K/s. Moreover, the corresponding maximum diameter of amorphous particles is 25 μm, which accords well to the theoretical analysis results. The new approach, reflecting the complexity of close-coupled gas atomization objectively, is available and effective to evaluate the cooling behaviors of close-coupled gas atomization.

结果表明：在一定的工艺条件下，紧耦合气雾化存在多种破碎模式，熔滴的冷却速率因直径、雾化位置的差异，相同直径熔滴经历结晶和非晶化2种不同冷却行为；依据Al基合金粉末的粒度分布和微观结构，结合熔体的雾化过程及冷却模式，确定熔滴冷却速率的上、下限；实验得出熔滴的冷却速率为104~108 K/s，Al-Ni-Y合金的非晶化临界冷却速率为105 K/s，能形成非晶态的熔滴最大直径为25 μm左右，实验结果与理论分析结果较吻合，比较客观地反映紧耦合气雾化的复杂过程。

Integrated analysis of 7 times heavy rain in Yunnan from July 19 to August 2 based on actual observation weather datum and satellite cloud atlas and Doppler radar image. The results show that: high-low southwest jet stream is important effect system. The maintenance of southwest jet stream provides water vapor, momentum, fast transfer of unstable energy for the lasting heavy rain. The further configuration of plateau shear line and southwest jet stream is necessarily condition about 7 times heavy rain. The lasting heavy rain appeared on big value region of 500hPa vapour flux and vapour flux divergence. The shear cloud band and subtropical high cloud band crossed and confluenced in Yunnan on the satellite cloud atlas. The maintenance and intensification of shear cloud hand and periphery cloud band of subtropical high correspond quite well to heavy rain falling region and cloud band distribution.

应用实测气象资料，结合卫星云图与多普勒雷达图像分析，对2007年7月19日到8月2日云南少有的7次强降水过程进行综合分析，结果表明：高低空的西南急流是重要的影响系统，西南急流的维持为持续性强降水过程提供了水汽、动量和不稳定能量的快速传递，高原切变线与西南急流的有利配置，是7次持续性强降水过程必不可少的条件；持续性强降水出现在500hPa水汽通量大值区和水汽通量散度辐合区；卫星云图上切变云带和副高外围云带在云南汇合，切变云带和副高外围云带维持、加强的过程与强降水落区的时空分布对应较好。

Mountains by the rear-side and the context of surrounding condition of the site made the form of this house to the various composition of inclined metal roofs which are spread dynamic and horizontally.

由车侧与周围的山立地条件下所取得的这座房子的形式出现的斜屋顶的各种金属成分的分布动态和水平。

The climatic factors on effecting the variation of cotton's internal sugar are determined.

结果明显遵循温度、降水量条件影响的变化规律，且依赖于空气相对湿度、5～50cm土壤水分状况的整体分布。

Thirdly ,under 25 0.5 ,pharmacocinetics and residues of orally administered at single and multiple dose of furazolidonum (60mg/kg) were investigated in grass crap , concentration of furazolidonum in Tissues were measured using HPLC and processed with MILLEMNIUM32 work station. The plasma concentration-time data was analyzed with MCPKP practical pharmacokinetics software.

其三，在25±0.5℃水温条件下，按60mg／kg的剂量给平均体重为65±10g的草鱼单次和多次灌服呋喃唑酮，用高效液相色谱法检测用药后不同时间血浆、肝脏、肌肉、肾脏中药物浓度，采用MILLEMNIUM~(32)工作站处理原始数据，然后用MCPKP药代动力学软件处理药时数据，对药物的吸收、分布、消除及组织残留进行研究。

The subsea tunnel was constructed with the complex geological condition of connotative fault, and the crush zone and safety excavation for the zone of unfavorable geology with high external water pressure are key for the safety control of subsea tunnel.

某海底隧道地质条件异常复杂，覆岩被多处断层破碎带相割呈区域性林状分布，高外水压处断层及破碎带施工是隧道安全控制的关键所在。

Secondly, to start with the distribution of temperature field, pressure field and dryness fraction along the injector well, the paper built a steam heat loss forecast model of the injector well, obtains condition the best steam injection pressure and steam injection speed under certain formation.

其次，从蒸汽沿注汽井井筒的温度场、压力场以及干度的分布入手，建立了注蒸汽井井筒的热损失计算模型，得出一定地层条件下的最佳注入压力和注汽速度。确立了井筒的最佳注汽压力和速率。

A distributed parameter model was proposed to simulate the airside heat transfer of the finned-tube evaporators in the frosting process.

建立了结霜条件下翅片管蒸发器空气侧流动和换热的分布参数仿真模型，模型考虑了蒸发器结构、霜层厚度以及湿空气状态等参数在气流方向的沿程变化。

A distributed parameter model is proposed to simulate the airside heat transfer of the finned-tube evaporators in the frosting process. The variation of the evaporator structure, the frost thickness and humid air conditions along the flow path are taken into consideration.

建立了结霜条件下翅片管蒸发器空气侧流动和换热的分布参数仿真模型，模型考虑了蒸发器结构、霜层厚度以及湿空气状态等参数在气流方向的沿程变化。

Results of EBSD show that most of the reversed austenite in the steel treated by QT distribute along the grain boundary, but in the steel treated by two--phase region heat treatment the austenites distribute uniformly along all kinds of boundaries, especially also along the lath martensite boundary in the grain, so the cryogenic toughness can be also improved even the amount of austenitic is lower than that in the steel treated by QT process.

EBSD结果则表明：经两相区处理，回转奥氏体不仅在晶界和板条束界形成，也在晶内的板条界上形成，因此即便在其含量低于淬火+回火处理的条件下， 9Ni钢的低温韧性也有明显提高，证明回转奥氏体的分布也是影响9Ni钢低温韧性的一个主要因素。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。