英语人>网络例句>材料 相关的搜索结果
网络例句

材料

与 材料 相关的网络例句 [注:此内容来源于网络,仅供参考]

The results of flame spreading test of combustible materials show the placement fashion is the most important factor which determine the risk degree of fire.

在专门建立的火蔓延特性试验台上,进行了不同材料的燃烧试验。实验结果表明决定材料火灾危险性的首要条件是材料的放置方式。

It is suitable for longitudinal cutting of equal-amplitude disk type flexible package materials of radium film, label, aluminum foil complex film material, composite paper and paper.

适用于纸张、复合纸、铝箔复合膜材料、标签、镭射膜材料等幅状盘形软包装材料的纵向分切。

Machinable bioactive glass-ceramics containing mica and fluorapatite were prepared by high-temperature melting. The glass-ceramics were analyzed by means of X-ray diffractometry, scanning electron microscopy with energy dispersive spectrometer and Fourier transform infrared reflection spectrometry. The bending strength, hardness and fracture toughness of the materials were measured.

摘 要:采用高温熔铸法制备可加工生物活性云母/氟磷灰石玻璃陶瓷;用X射线衍射、扫描电镜和傅里叶变换红外光谱分析等手段对材料的相组成和微观形貌进行研究,测定材料的抗弯强度、硬度和断裂韧性等力学性能;采用体外模拟体液浸泡法测试材料的生物活性。

Machinable bioactive glass-ceramics containing mica and fluorapatite were prepared byhigh-temperature melting. The glass-ceramics were analyzed by means of X-ray diffractometry, scanning electron microscopy with energy dispersive spectrometer and Fourier transform infrared reflection spectrometry. The bending strength, hardness and fracture toughness of the materials were measured.

摘 要:采用高温熔铸法制备可加工生物活性云母/氟磷灰石玻璃陶瓷;用X射线衍射、扫描电镜和傅里叶变换红外光谱分析等手段对材料的相组成和微观形貌进行研究,测定材料的抗弯强度、硬度和断裂韧性等力学性能;采用体外模拟体液浸泡法测试材料的生物活性。

A bstract: Fluorination is one of the most effective chemical methods to modify and control physicochemical properties of diverse carbon materials.

氟化是修饰和控制炭材料物理化学性质的有效方法之一,炭材料的多样性和宽范围的 C-F 键是氟化炭材料具有多种多样性质的基础。

The results show that the optimal amount of foamer is 0.5 wt%and thisporous material has excellent porous structure, that is, interconnected and uniformlydistributed pores with the diameter of pores ranging from about 100μm to 700μm.

结果发现:发泡剂的最佳比例为0.5 wt%,多孔n-HA/PA6材料具有与松质骨相似的多孔结构,孔径为100~700μm,孔的贯通性好,孔隙率可通过调节工艺参数进行控制,最高可达到88.6%;总孔隙率相近的情况下,n-HA含量高的多孔材料的压缩强度较高;孔隙率在58~88%范围内,多孔材料的抗压强度在1.1~15.6MPa,与人松质骨的抗压强度相当。

However, the electrode material is not satisfied because of its poor corrosion resistance, small conductivity, big friability and poor heat shock resistance.

前人的研究工作中,对于这种电极材料完全按陶瓷材料考虑,采用细粉,以注浆或挤压方法成型;制成的电极材料耐腐蚀性能不理想,脆性大,抗热震性能不好,在电解应用过程中易产生裂纹。

It is a new type of excellent automobile friction brake material as a replacement of asbestos friction materials

研究表明:此摩擦材料力学性能高,摩擦性能稳定,特别是高温磨损小,噪声低,是一种取代石棉摩擦材料的新型制动材料

Because the metal melt fluid washes outthe furnace lining unceasingly as the metallurgy smelting, the different furnace lining material, the furnace lining smelting life is dissimilar, so power frequency furnace is also same as any other type smelting when they are manufactured, not equiping with furnace lining material, the using factoryshould have the professional furnace lining technical personnel and furnaceman.

由于冶金熔炼时,金属熔液不断冲刷炉衬,不同的炉衬材料,炉衬熔炼寿命也不一样,不同的金属所适应的炉衬材料也不一样,所以工频炉出厂也同任何种类熔炼出厂一样,不配备炉衬材料,使用厂应备有专职的炉衬技术人员和筑炉工。

Because time metallurgy smelting, the metal melt fluid washes out the furnace lining unceasingly, the different furnace lining material, the furnace lining smelting life is dissimilar, the different metal adapts the furnace lining material is dissimilar, therefore power frequency stove leaving the plant is also same as any type smelting leaving the plant, does not provide the furnace lining material, the use factory should have the professional furnace lining technical personnel and build the furnaceman.

由于冶金熔炼时,金属熔液不断冲刷炉衬,不同的炉衬材料,炉衬熔炼寿命也不一样,不同的金属所适应的炉衬材料也不一样,所以工频炉出厂也同任何种类熔炼出厂一样,不配备炉衬材料,使用厂应备有专职的炉衬技术人员和筑炉工。

第36/100页 首页 < ... 32 33 34 35 36 37 38 39 40 ... > 尾页
推荐网络例句

She gently rebuff ed him, but agreed that they could be friends

她婉言拒绝了,但同意作为朋友相处。

If in the penal farm, you were sure to be criticized.

要是在劳改农场,你等着挨绳子吧!

Several theories about reigniting and extinguishing of the arc have been refered.

本文综合考虑了几种电弧重燃和熄灭理论。