杂质

Potassium bromide produced in the elimination step was cleaned with steam treatment, then used to bromize tert-Butyl alcohol, producing tert-butyl bromide.

为了回收中间元素澳，用水蒸汽蒸馏方法除去脱漠化氢后生成演化钾盐中的杂质，通过添加硫酸以再生漠化钾用于叙丁醇漠化制漠代叔丁烷。

Calcitic limestone is mainly CaCo 3 with relatively small amounts of impurities.

方解石灰岩，主要是由CaCo 3和少量的杂质所形成。

The structures of three key active constituents are confirmed, and the structure of one main impurity β-caryophyllene is also confirmed; the wrong assignment of 13C-NMR of β-caryophyllene was firstly rectified.

不仅对榄香烯原料药的3个主要活性成分进行了结构确证，而且对原料药中的1个主要杂质成分β-石竹烯进行了结构确证，并首次对文献中β-石竹烯碳谱数据中有误的归属进行了纠正。

In fact, our method can be used to calculate the DOS of any chiral carbon nanotubes.

我们的方法可以计算任意手征型的碳管的稀疏杂质效应。

Preparation of the cathode includes:shaping under the press of 40Mpa, sintering at 550℃for 1 hour and at 900℃for 8 hours and threading with molybdenum bar; Considering the literatures we choose CaCl2 as salt for preparation titanium. Pretreatment of salt is for 1 hour at 100℃and for 2 hours at 300℃. Partial pressure of oxygen which need lower than 5.11×10-7Pa to reduct titanium oxides and hygroscopic property of salt need a sealed equipment to electrolyse. And finally successfully designed a satisfied one and the results show that the equipment can be satisfied the requirment of the experiment. Flow of the inert gas is 1.5L/min, the voltage is 2.8 V, temperature is 850℃and time is 2 hours during pre-electrolysis. Flow of the inert gas is 0.2L/min, the voltage is 3.1 V, temperature is 900℃and time changes with the mass of TiO2 during electrolysis, namely the greater need the longer time; To eliminate influence of salt and other impurities, the products need to wash with distilled water and dilute chlorhydric acid , then wash with dilute hydrochloric acid under supersonic wave assistant. Finally, electrometical properties of the electrolysis of TiO2 is researched by cyclic voltammetry and chronoamperometry, and results show that there are two main reodox steps, namely from TiO2 to TiO and from TiO to Ti.

阴极制备主要包括40MPa压力下模压成型、两段式烧结(1小时内升至550℃保温1小时，再1小时升温至900℃保温8小时)及烧结后TiO2块打孔用钼棒串接三个主要环节；实验中选用CaCl2作为电解熔盐，并对其进行预处理(100℃，保温1小时； 300℃，保温2小时)；经热力学计算，还原钛氧化物的氧分压至少要低于5.11×10-7Pa，结合电解过程中所用熔盐CaCl2有极强的吸水性的特点，电解装置应有较高的密封性，自行设计了一套密封性可靠的电解装置，便于实验过程中熔盐预处理和氧分压的控制；通过干燥处理预电解过程中Ar流量大约为1.5L/min、电压为2.8 V、温度为850℃、时间为2小时，电解过程中Ar流量大约为0.2L/min、电压为3.1V、温度为900℃，实验结果表明电解时间与TiO2质量密切相关，质量越大需要电解的时间越长；通过自来水冲洗—稀盐酸浸泡、洗涤—在超声波辅助作用下稀盐酸洗涤，可减少熔盐及其它杂质对电解产物检测结果的影响；最后，通过循环伏安法、计时电流法对电解机理的研究，确定电解还原TiO2制备金属钛主要经历了TiO2-TiO-Ti的过程。

The key techniques of this project are as followes: By means of optimum seeking of pure Cinnamomum camphora var.

本项目核心技术：通过优选含芳樟醇高达95%的纯种芳樟，再经植物克隆技术培育成种苗，种植后不变异；有效物含量高；杂质少；不经蒸馏分离工序，即可达到合格产品。

The effects of medium, amount of acid and coexistent elements in Chinese traditional medicines were also studied.

对应用ICP-AES法同时测定中成药中的As、Cd、Cr、Pb、Sb、Sn等杂质元素进行了系统的研究。

Also, in order to protect proprietary information, tests for specific impurities and even solvents are typically not listed in the compendia.

同时，为了保护专利信息，具体杂质的检测和药典中未列溶剂。

In Chapter 3 relaxation in growth with a conservation law is studied, and reduced roughness of the surface due to the effect of relaxation is found. The last chapter includes discussions of point defects in conservational surface growth.

第三章研究了守恒界面生长中界面弛豫效应的影响，发现弛豫作用使得守恒生长的界面粗糙程度下降；第四章研究了杂质点缺陷的存在对生长表面的影响，发现存在于生长的活跃表面层中的点缺陷会使表面的局域粗糙度增加。

Accelerator mass spectrometry has ultra-high sensitivity and can be used to detect extremely low impurity contents in samples. 10Be is a cosmogenic nuclide. As a tracker, it has been widely applied to earth, environmental and cosmographic sciences.

加速器质谱计具有很高的灵敏度，能测量样品中含量极微的杂质同位素。10Be是一种宇宙成因核，在地学、环境科学和宇宙学等领域有广泛的应用，它为纯β衰变核，端点能量低且半衰期很长。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。