杂质

The results in optical absorption are in good agreement with those in the electrical conductivity.

将此吸收峰归因于缺氧导致的杂质能带的产生，并与其相应的电学性质进行比较，得到了一致的结果。

In this paper,the electroforming technique summarized by our laboratory for making holographic Nickel Dies is reported.

本文介绍了我们在实验中总结出的电铸全息镍压模的工艺，并详细讨论了该工艺对镍层性能的影响，最后给出了杂质对镀层的影响及去除方法。

The crystal structure and surface property of kaolinite, illite and pyrophyllite have been discussed. The influence of residual bond, lattice impurities and grinding behavior on wettability, electrokinetics and floatability have been studied based on crystal chemistry and solution chemistry of flotation.

系统分析了我国铝土矿中含硅脉石矿物高岭石、伊利石、叶蜡石的晶体结构与表面性质，讨论了晶体结构与铝硅酸盐矿物表面断裂键的特性、润湿性、电性及可浮性的关系，以及晶格杂质与可磨性对浮选行为的影响。

Drift electron mobility, the Hall factor and Hall mobility in GaN are calculated according to Mattiessen's rule as a function of temperature for carrier concentrations with the compensation ration as a parameter on the basis of taking into account the individual average scattering momentum relaxation time of four scattering mechanisms, namely, ionized impurity scattering, polar mode optical scattering, acoustic piezoelectric scattering and acoustic phonon deformation potential scattering which have an effect on electron mobility of GaN.

考虑了对纤锌矿型氮化镓低场电子输运影响最为显著的4种散射机制－电离杂质散射，极化光学波散射，声学波压电散射和声学声子形变势散射的单个平均动量驰豫时间，采用Mattiessen's rule计算了不同补偿率以及不同载流子浓度条件下，氮化镓电子漂移迁移率，霍耳因子以及霍耳迁移率随温度的变化。

It is demonstrated that living polymerization can be achieved when the concentration of electron pair donors such as DMAB or Et3N is higher than that of trace water in the polymerization system,and that polymers with narrow molecular weight distribution can be obtained.

发现当N，N-二甲基苯胺或三乙胺的浓度稍高于质子性杂质的浓度时，即能实现异丁烯的活性聚合，得到分子量分布较窄的聚合物。

Film or paper surface dirty, and wrapped it into the dust or clear plastic mulch films after the crease or relaxation phenomena, film hemming switched to a new membrane drying temperature is too high, adhesive surface crust adjust oven temperature, clear crusts partⅱ thermotolerance cohesion and not enough use better glue wrinkle of polymer-coated film transfer after the roll is not the proper balance of films at both ends are inconsistent or wave; adjustment layer of polymer-coated machine too thick, solvent evaporation incomplete, viscosity, pressure drum extrusion, paper (Business card printing and membership card making products) and films between slide to adjust the film covering technology electrothermic roll and rubber roller ends is not plain, pressure is inconsistent, ranging from the adjustment of the linear speed of the machine after the temperature inside the plastic mulch film covering the subject in yellow glue resin particularly resin or additives not resistant to ageing, in the light, heat, under the influence of ultraviolet radiation, chemical change, build the pigments should be switched to a new glue

薄膜或纸张表面不干净，裹入灰尘或杂质清除后再行覆膜薄膜有折皱或松驰现象，薄膜卷边换用新膜干燥温度过高，粘合剂表面结皮调整烘道温度，清除结皮胶的粘接力和耐热性不够换用更好的胶水覆膜后起皱薄膜传送辊是否不平衡；薄膜两端松紧不一致或波浪边；调整覆膜机器胶层过厚，溶剂蒸发不彻底，影响了粘度，受压力滚筒挤压，纸张与薄膜之间产生滑动调整覆膜工艺电热辊与橡胶辊两端不平、压力不一致、线速度不等调整覆膜机器覆膜后易变黄胶水中的主体树脂特别是一些增粘树脂或助剂不耐老化，在光、热、紫外线的影响下，发生化学变化，生成有色物质应换用新胶水

The nature and source of the background absorption of samarium matrix and the method for elimination of the background were studied.

随着稀土元素应用领域的扩大，对高纯稀土化合物中的痕量杂质分析提出了更高的要求。

Because of you, I know what is the endless miss.

这是我的心声，最现实的，不带一点杂质。

There are two endothermic and lossing weight stages in all of the decomposition...

其它摩尔投料比产物中都不同程度的含有一些杂质。

This article briefly introduces the development from impurity engineering to energy band engineering and three methods of energy band engineering.

本文简要介绍从杂质工程到能带工程的发展过程，以及能带工程的三种基本方法。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。