有限元法

In order to analyze the effect of friction force on contact reaction inner bearing during universal rolling of H-Beam,2D finite element model of bearing block was established using numerical simulation method.

为了分析万能法轧制H型钢的过程中，轴承内部摩擦力对滚动体接触反力的影响，利用有限元的方法建立了轴承座受力的二维有限元分析模型。

Based on the method of finite element orthogonal test,this paper designs the experimental scheme and gives numerical model of top coal drawing with non chain pillar entry protection .

根据有限元正交试验法，设计了有限元正交试验方案，建立了放顶煤无煤柱护巷的数值模型；通过对计算结果分析，得出放顶煤无煤柱开采沿空巷道的布置参数和支护形式，可为放顶煤无煤柱护巷提供理论依

The Sleeve Drill Method drilling and cement injection alternated and the Grouting Method grouting from the bottom of the hole using soft pipe bound around the inclinopipe used in the building of inclinohole were suggested for the first time.

提出了有限元分区分析法以及监测网点布置原则；创造性地提出了层状若质边坡测斜孔埋设的&跟浆套钻法&和&软管跟管孔底注浆法&，该方法的应用使&硬滑&地层中的测斜孔深度达到82.5m；首次提出了基于外观成果的边坡安全性综合评判模型和基于内观成果的边坡稳定性预测预报模型。

The disciplines of monitoring mesh designation and the stability analysis methods based on zoning were introduced. The Sleeve Drill Method drilling and cement injection alternated and the Grouting Method grouting from the bottom of the hole using soft pipe bound around the inclinopipe used in the building of inclinohole were suggested for the first time.

提出了有限元分区分析法以及监测网点布置原则；创造性地提出了层状若质边坡测斜孔埋设的&跟浆套钻法&和&软管跟管孔底注浆法&，该方法的应用使&硬滑&地层中的测斜孔深度达到82.5m；首次提出了基于外观成果的边坡安全性综合评判模型和基于内观成果的边坡稳定性预测预报模型。

With this model, the deformation and stress distributions of the flange joint are analyzed using ANSYS FEM software, and the influences of gasket properties, tube side pressure and shell side pressure, bolt pr.

本论文以U形管换热器法兰夹管板接头为研究对象，考虑垫片材料压缩的非线性特性和压缩-回弹时的时滞效应，将法兰接头各元件看成一个系统，研究各元件的相互作用，建立了管板-法兰-垫片-螺栓连接系统的非线性三维有限元分析模型。

The paper analyses several predicting methods for wave load acting on SWATH ship and compares the advantages and defects of quasi static method, rigid body dynamic method, hydro elasticity method and empirical formula method.

本文分析了小水线面双体船波浪载荷预报的几种方法，比较了准静态法、刚体动力学法、水弹性法、经验公式法的优缺点，讨论了结构有限元离散的注意事项，以及斜支柱结构形式对动载荷和疲劳的有利因素。

The following are main contents studied: A finite element method for Navier-Stokes equation with ALE formulation is considered and by combined with theNewmark method of numerical intergration a pressure correction scheme is obtained for the solution of the FE formulation of N-S equation. Because the incompressibility condition can be satisfied approximately in this scheme, the interpolation functions of elements can be equalorder for the velocity field and pressure field. In the ALE formulation the fluid-solid interaction analysis became a three-field coupling problem of the fluid field, the solid field and the fluid dynamic mesh. The properties and charactiristices of this three-field coupling problem are deeply discussed.

研究的主要内容有：主容器中流体大晃动是一种强非线性问题，文中研究了求解ALE描述的粘性流体N-S方程的有限元方法，以有利于大晃动自由液面的跟踪和流体大晃动中非线性现象的描述；并结合Newmark数值积分法推出了求解ALE型N-S方程的压力修正解法，由于这种解法可以近似满足不可压条件，因此可以采用速度场和压力场等阶插值的有限元离散格式，从而较好地解决了普遍采用的不等阶插值解法中，速度场和压力场数值精度不一致、程序编制不便等的不足。

Then after a semi-rigid joint behavior can be modeled as a finite stiffness rotation spring, base on rotation and displacement equation derive the element stiffness matrixes with semi-rigid connections where the effects of jointed flexibility and shear forces in the connection deformations have been considered in and fixed-end forces are modified. Finally, a program for calculating system reliability of semi-ridge steel frames with Monte carlo method and finite element analysis has compiled for calculating and analyzing.

接着本文在介绍和分析半刚性连接弯矩和转角关系模型的基础上，用带有转动刚度的弹簧表征半刚性连接，推导出半刚性连接的刚度矩阵，对固端力进行修正，同时考虑了剪切变形的影响，编制了半刚接钢结构平面框架的有限元程序BHPFL，并在其基础上编制了基于蒙特卡洛法的Monte Carlo-BHPFL 有限元相结合的方法，进行体系可靠度的分析。

At the same time, the finite element model of six-phase ten-pole fault-tolerant permanent magnet machine is established to simulate and compute static and transient electromagnetic fields using vector magnetic potential method.

同时建立了六相十极永磁容错电机的有限元仿真模型，利用有限元矢量磁位法对该模型进行了静态和瞬态电磁场的仿真分析。

Three-dimension finite element floating mesh method is used to calculate the temperature field and thermal stress of 6Aa roller compacted concrete gravity dam section and F6 fault concrete tuck in this paper.

本文用三维有限元浮动网格法对6Aa坝段及基础部位F6断层混凝土塞的施工过程进行温度场和温度应力仿真计算，计算的基本理论是热传导理论和弹性理论以及相应的有限元计算公式。

By using competitive adsorption of activated carbom to remove unfavorable influence of carbon in carbonaceous gold concentrate on leaching process, the leaching rate of gold concentrate can be improved to 88% as compared with 10%by direct cyanidation.

本文论述了利用活性炭竞争吸附作用，消除含炭金精矿中炭在浸出过程中的影响，使金精矿的浸出率可由直接氰化的10％提高到88％。

The only thing you're ever gonna be king of is King of the Stupids!

你只配做傻瓜的国王！