有限元法

Second, the design, and static and modal analysis of the crankshaft and counterbalance shaft are presented.

再次，对发动机曲轴和平衡轴进行了设计和分析，应用有限元法对曲轴及平衡轴进行了静力学和模态计算与分析，结果表明所设计的曲轴及平衡轴满足设计要求。

It is verified that the most dangerous operation condition of crankshaft is not happening at the upper point of gas re-inlet or while the crankpin is bearing a maximum force of gas.

目前已有很多文献运用有限元法得到圆角、油孔等应力集中部位的精确应力值，以此分析曲轴的静强度，但是它们都存在一些

Dynamics and the finite element analysis make the precise analysis of crankshaft being true....

多体动力学和有限元法的发展使得较精确地分析曲轴动力学响应问题成为可能。。。。

This work employs operator-splitting method / finite element method to study dynamic performance and the stability of liquid-lubricated herringbone grooved journal bearing with micro-polar lubricants. Load capacity, friction resistance, stiffness/damping coefficients and critical rotor mass were investigated.

本文采用算子分裂/有限元法计算微极性流体润滑剂的螺旋槽径向轴承承载力、粘性阻力、润滑油膜刚度系数和阻尼系数等特征量，研究轴承的动力特性和稳定性问题。

The model of a standard maxillary central incisor restored with cast post and porcelain crown was constructed through three dimensional finite element methods .

运用三维有限元法构建解剖标准前牙桩冠修复体模型，并模拟不同牙合接触形式进行加载以分析剩余牙本质应力。

In this model, a cubic B-spline curve segment is used as one element, and the FEM is adopted to find the B-spline active contour which minimize its energy.

该模型以三次B样条曲线段作为有限单元，运用有限元法对B样条主动轮廓的能量泛函极值问题进行求解，从而实现对图像的轮廓提取。

For some particular casesof boundary-value problems such as the problems with curvilinear boundariesor a sharp re-entrant corner,the B-FEM in curvilinear coordinates will givequite fine results.

对一些特殊问题，如曲线边界问题、尖角奇异性问题等，在曲线坐标系中建立的B样条有限元法，具有良好的计算效果。

According to the structural feature of parallel single disk gate valve,the strength and rigidity of body will be calculated with finite element method,and with cylindroid shell theory .

根据主闸阀结构特点，分别用有限元法和椭圆柱板壳理论公式计算了阀体的强度与刚度，并进行了分析对比，同时对闸板的刚度进行了校核。

The train is treated as multi-body system, and its dynamic equations are derived using the D\'Alembert principle. The rail structure is modeled as discrete-supported three-layer system considering the degrees of rail, sleeper and ballast.

车辆为多刚体系统，采用D'Alembert原理建立其动力方程；轨道结构采用考虑钢轨、轨枕、道碴自由度的三层点支承模型；采用有限元法建立桥梁动力分析模型。

The method of springback finite-element for large deflection of plate shaping is established on springback potential energy principle that is already concluded.

通过引入有限变形回弹反耦联系统和反耦联方程的概念，由回弹势能原理建立了板成形的大挠度回弹有限元法。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。