有距的
- 与 有距的 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Considering the factors such as randomness of natural lightning locus and the coexistence of primary and secondary leaders, it is necessary to lead in the concept of dynamic lightning protection shielding angle. It is suggested that the angular bisector of practical protective angle formed by ground wire or earth pin in UHVAC transmission line and conductor should be aligned with the direction of lightning leader as well as the ratio of vertical span to horizontal span and the impact of wind speed should be considered.
考虑自然闪电轨迹的随机性和雷电主先导与次先导并存现象等因素,有必要引入动态防雷保护角概念,建议特高压交流线路中地线对导线的实际保护角形成的角平分线应与雷电先导的来向一致,并应计及垂直档距和水平档距的比值和风速的影响。
-
On the fracture section, three strain gauges were put above the pins of groups fixed with external fixator. The gauges were recorded when the femurs were loaded vertically. Results (1) The compressive trabeculae and femoral calcar in the femoral neck region are the main load-bearing construction. The contract of the abductor muscle can protect the hip joint. When the model femur was abducted in small degree (10-30°), the stress improved gradually with the abductor angle. But adduction of the model will gradually decrease the stress in that area. When external violence was put on it, the main stress distribution was on the upper femur, which was in the middle and lower part of the femoral neck and between greater trochanter and lesser trochanter.
同时在④⑤两组又应用电阻应变片贴于断端间的三枚斯氏针上方以测定钢针上的应力与应变结果(1)股骨颈处的压力骨小梁和股骨距是重要的承载结构;载荷的传导主要通过压力骨小梁和股骨距由股骨颈区传至股骨干的中下1/3处;外展肌力的收缩对髋关节有一定的保护作用;在小角度外展实验中(10-30°)股骨颈区的应力递增,超过30°时股骨颈区的应力又逐渐减小,但在内收实验中随角度增大股骨颈处应力呈递减趋势;当外界暴力作用时,应力主要集中在股骨上段,即股骨颈中下段和大小转子处及其之间。
-
Dot Pitch 点距 In monitors, the dot pitch is the distance between the holes in the shadow mask; the smaller the number, the sharper the image.
在监视器里,点距是距离(测量在彩色显象管阴罩过程中,在洞之间,用毫米);更小的数目,骗子这幅图像。如果你有选择,A 。虽然,但是28毫米点距是更好的。
-
Gradient,diameter,extra-deep,stem length, hole space ,row space and minimum resist line of borehole are analyzed in this paper.
主要分析了炮孔倾斜度、炮孔直径、超深和堵塞长度、孔距和排距、最小抵抗线等因素对爆破效果的影响,这对台阶爆破设计有一定的参考价值。
-
The results of the rule of law with ordinary methylation by formaldehyde Veratryl three groups the average weight of 2.5609g, the average yield was 91.31%, the melting point of the three groups were 42.4 ~ 44.8 ℃, 41.5 ~ 45.2 ℃, 41.7 ~ 44.3 ℃, from the results of we can see that the three groups of the melt from the melting point greater than that which the product of the by-product of the detection of the melting point have a certain impact; and the legal system with microwave radiation by an average of Veratrum aldehyde quality 1.4016g, the average yield was 93.23 %, melting point of the three groups were 41.8 ~ 43.2 ℃, 41.3 ~ 42.6 ℃, 41.6 ~ 43.5 ℃, melting away from the three groups as compared with ordinary methods of measuring the melt-out from the small.
结果 用普通甲基化法制出来的三组藜芦醛平均质量为2.5609g,平均产率为91.31%,三组的熔点分别为42.4~44.8℃,41.5~45.2℃,41.7~44.3℃,从结果可以看出,三组熔点的熔距都比较大,证明产物当中的副产物对熔点的检测有一定的影响;而用微波辐射法制出来的藜芦醛平均质量为1.4016g,平均产率为93.23%,三组熔点分别为41.8~43.2℃,41.3~42.6℃,41.6~43.5℃,三组熔距较普通方法测出来的熔距小。
-
The results showed that the shape of whole talus looked like a tortoise.Most of the talus had talar cauda(97%),and its cauda had long、middle、short types,the fracture of t alar cauda were 52 cases(6.8%).
距骨从整体看形似乌龟,97%的距骨有距骨尾,其尾有长、中、短之分,其中距骨尾骨折52例,占6.8%。
-
The capacity of single pile will enhance when the length and diameter of pile increases, but effect of pile diameter is more obvious. While pile diameter increases 20、40 and 60 percents, the capacity of pile will enhance 20.4、53.7 and 78.1 percents. And with the effect of mud-cake, the capacity of single bored pile will fall down nearly 20 percents, and pile-side resistance will also reduce 15 — 35 percents. In the centrifuge tests, when the relative displacement between pile and soil was 45 —85mm, which is much more than the criterions, the pile-side resistance will become most. Meanwhile the intenerated value of utmost resistance is close to the resistance in situ. In the pile group tests, the capacity of pile group , which the space among piles increases from 2D to 3D、 4D and 5D , will enhance 6.1、9.6、18 percents .
当桩径增加20%、40%、60%时,桩承载力分别增长了20.4%、53.7%和78.1%;在考虑泥皮效应后单桩侧摩阻力减小15~35%,极限承载力减小18%~24%,且减小率随桩径的增加而变小;试验中桩身侧阻软化值与原型桩实测侧阻软化值接近,且极限侧阻所对应的桩土相对位移试验要比规范值大得多,约为45~85mm;同时群桩极限承载力随桩距的增大而增加,其中桩距为3D、4D、5D的群桩承载力分别比间距为2D的群桩高6.1%、9.6%和18%;其承载力效应系数η接近或大于1,并随着桩间距的增大而不断提高;群桩侧摩阻力沿深度的分布与单桩略有不同,即桩身上部由于承台的作用,侧阻削弱,但桩身中部侧阻具有增加的趋势。
-
This is because a grade 5 climb has to have about a half-pitch vertical, and a grade 6 a full pitch vertical, which brings me to the second point. Vertical is 90 degrees, not 85 degrees.
这是因为第五级大概有一半的绳距是垂直的,第六级是整个绳距垂直,会让我到第二个点。
-
This is because a grade 5 climb has to have about a half-pitch vertical, and a grade 6 a full pitch vertical, which brings me to the second point. Vertical is 90 degrees, not 85 degrees.
這是因為第五級大概有一半的繩距是垂直的,第六級是整個繩距垂直,會讓我到第二個點。
-
The use of a trough-shaped CRT shadow mask, distance of up to 0.24mm, it is a combination of SONY Trinitron and traditional grid-like mask mask punctate characteristics: pure flat two-dimensional extension of the trough-shaped mask, Compared to traditional point-like mask to space more available to more electronic liquidity to allow more light to reach the screen, the CRT image accuracy, brightness, contrast and color purity has been improved, so more light a clearer picture, and this structure is also conducive to the improvement of resolution and distance.
该显像管使用了槽状荫罩,点距可达0.24mm,它综合了SONY特丽珑栅状荫罩和传统点状荫罩的特点:纯平面两维伸展的槽状荫罩,比起传统点状荫罩来间隙更多,可得到更大的电子流通量,让更多的光线到达屏幕,所以显像管的图像精度、亮度、对比度和色纯度都有了提高,从而获得更亮更清晰的画面,而且这种结构也有利于分辨率和点距的提高。
- 推荐网络例句
-
However, as the name(read-only memory)implies, CD disks cannot be written onorchanged in any way.
然而,正如其名字所指出的那样,CD盘不能写,也不能用任何方式改变其内容。
-
Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.
镀锌钢托盘多用于出口,替代木托盘,免薰蒸,符合欧盟、北美各国对出口货物包装材料的法令要求;喷涂钢托盘适用于重载上货架之用,托盘表面根据需要制作成平板状、波纹状及间隔形式,满足不同的使用要求。
-
A single payment file can be uploaded from an ERP system to effect all pan-China RMB payments and overseas payments in all currencies.
付款指令文件可从您的 ERP 系统上传到我们的电子银行系统来只是国内及对海外各种币种付款。