有膜的

The challenges of these material are screen printing and sintering process. Many long fine patterned lines should be printed on a large piece of glass and sustain a smooth, continuous and uniform line pattern; on the other hand, the sintering process is rapidly increasing sintering temperature to a peak in a short time, then cooling the glass substrate to low temperature under a short time shock.

汽车钢化玻璃除霜加热线，是采用在玻璃基板上印刷银浆，在玻璃的钢化热处理过程中完成银导体膜的烧结附着，由于烧结时间短(总时间250sec)和温度骤变条件相当苛刻，要求导电细线无脱落断线，在功率满足要求的情况下，与外蓄电池连接的电极的焊接及附着强度也有具体要求，另外耐候性及耐擦洗等后步要求也较苛刻。

Atomic ash blows the discretion of besmear quality, the flatness that installs to besmear has very big effect, friend should have blown atomic ash, lay good foundation to raise the flatness of film.

原子灰刮涂质量的高低，对涂装的平整度有很大的影响，故要把原子灰刮好，为提高涂膜的平整度打好基础。

When the above-mentioned anions were added into the solution, the breakdown potential and negative difference effect of aluminum were found to change.

1前盲纯铝在PH二4～9的水溶液中，由于与溶液中的氧有强烈的亲合力，生成保护性较高的饨化膜，抑制了铝的自腐蚀。

In September 2003 Fortey and Chatterton reported on a remarkable trilobite: Erbenochile erbeni, a Moroccan acastoid with an extremely well-developed schizochroal eye borne on tall, columnar palpebral lobes, rimmed with an eyeshade.

在2003年九月，福提和查特顿报道了一个不寻常的三叶虫Erbenochile erbeni，这是一个来自于摩洛哥的具有完美的裂膜眼三叶虫，桶状的眼叶，和有边缘的遮光眼罩。

Hence, it limited the spherulite congeries structure and a symmetrical bi-continuous morphology dominated all the membrane body.

结果显示，CaCO_3粒径及添加量对膜结构有明显的影响，一定量CaCO_3粒子的加入影响了PVDF结晶动力学，因而影响PVDF聚集形成大球状结构，更有利于均匀分布的双连续形态的形成。

The transmission, reflection and absorption spectra of the cyanine thin films were measured by the spectrophotometer and the reflection and the absorption of this cyanine thin film are high enough for optical recording at 780 nm.

通过染料薄膜光谱的分析，发现该染料薄膜在780 nm波长处有较大的吸收和较高的反射，多层膜的反射率达到75%，这符合橙皮书对反射率大于70%的要求。

There was a slightly increase of Fv/Fm in Cha. gracilis at 35C, which suggested there maybe an increase in the fluidity of the thylakoid membrane, which caused an acceleration of electron transport.

但当温度为35℃时角刺藻的Fv／Fm有轻微的升高，可能是此温度活化了角刺藻的类囊体膜从而促进电子传递的缘故。

The results showed that the light stabilizer BHW1 by adding component chelating metal ion in HALS complex had better light stability and balanced performance than other HALS complex .

实验表明：引入金属离子螯合剂组成的复合光稳定体系BHW 1在农用聚烯烃棚膜中应用效果良好，具有更为均衡的光、热稳定性能；自然曝晒实验和大田实验证明复合受阻胺光稳定剂的光稳定性能优于单组份光稳定剂，光稳定剂复合化是聚烯烃防老化最有成效的解决方式之一。

Results:The 3-dimensional finite element models of the minimum distal occlusal structure defect with restoration were created, which included metal crown with exterior anatomic morphology of the mandibular first molar, tooth preparation, filling material and the structure of periodontal membrane.

本研究采用逆向工程技术，通过先进的三维激光扫描技术，三维造型设计技术建立几何模型，将几何数据导入有限元分析软件中，建立了右下颌第一磨牙具有根管和远中面(distal occlusal，DO)最小缺损的全冠修复牙体预备体、充填体、金属冠、牙周膜的三维有限元模型。

When the carrier a leaky through color, should take the following measures: opening up a piece of the same color and empty color, size is large enough, rich enough ink-specialized business card printing and membership card making bar code; if a bar code business card printing and membership card making and plastic seal in the back part of the decoration, you should close two-layer between a non-transparent, to ensure that the color on the back of the decoration and does not affect the value of p C S bar code.

当载体漏光透色时，应采取以下措施：开辟一块颜色与空色相同、面积足够大、油墨足够浓的基色专门制卡和会员卡制作条形码；若条形码制卡和会员卡制作在塑膜封口处且背面有装潢的部分，应在封口的两层中间夹一不透明夹层，以确保背面装潢色彩不影响条形码p C S值。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。