有管的

The fluence and frequency of laser was controlled precisely, which could melt and destroy the adiposis tissue without damage to the adjacent tissues. The histological study of treated adiposis tissues, post-operative reaction and clinical results were observed and studied. Results Local adipose tissues were melted and liquefied effectively by the laser. Compact fibrous tissues of cellulite were broken by the laser into loosen structure. The bleeding was lower than traditional method due to the coagulation of capillary vessels. The advantages of laser lipolysis included less edema, petechia and complications, which produced a rapid recovery and satisfactory results.

但该方法也存在疼痛、血管损伤、出血较多[1]等不足，此法主要是利用机械力插入负压吸引管，通过较强的负压将脂肪组织吸出体外，比较适用于大范围、厚层次和疏松的脂肪吸除，难以应用于小范围局限致密的脂肪组织，如面颈部和手臂部等，这些部位脂肪构成较特殊，包含有大量坚韧的呈网状交织的纤维结缔组织，质地较紧密，普通负压难以吸除，吸脂管插入和抽动阻力较大，如强行反复抽吸对组织创伤明显，因此，有必要寻找一种更加有效的治疗方法。

The main causes of the vibration in pipeline system are in two respects : The first is the vibrant force of the medium acted on pipeline system,i.e.exciting signal,such as the vibrant force caused by the gas flow at the compressor ′ s inlet and outlet and at the ramified and nodel points as well as the action of pig passing through pipeline bridge,etc.;The second is the response to the exciting signal,which is relating to the characteristics of the pipeline system,i.e.the rigidity,support,quality and equipments of the system besides the waveform of the exciting signal.

管道系统振动的原因主要有两方面，一是介质对管道系统产生的振动力，即激发信号，如气流在压缩机进、出口，分支节点部位产生的振动力，清管器通过管桥时对它的作用等；另一方面是对激发信号的响应，其响应除了和激发信号的波形有关外，还和管道系统本身的特征，即系统的刚度及支撑，质量及其配置等情况有关。

We prepared the ordered porous alumina membrane by a two-step anodization method in oxalic or sulfuric acids, which is a self-ordered hexagonal array of cells with an adjustable pore diameter of 20-150nm and a different pore structures (i.e. Y-branched, dendriform, toothed and torous ones). Furthermore, the template-electrodeposition, vapor-catalytic growth, and controlled chemical etching were developed for well-aligned carbon nanotubes and oxide nanopillars with adjustable diameter, Al2O3-AlN one-dimensional heterojunction, Y-junction and dendriform metal nanowires, as well as Y-junction, and torous carbon nanotubes. The resultant one-dimensional junctions were characterized by XRD, SEM, TEM,HRTEM, and STM, and the field emission of the well-aligned carbon nanotubes and the luminescence of ZnO nanopillar array have also been mearsured.

完善和发展了阳极腐蚀法制备多孔氧化铝膜的方法，制备出了孔径在20-150nm之间可调和具有不同孔结构（如Y形、树枝状、锯齿状）的系列多孔氧化铝模板，在此基础上，利用电化学沉积、气相催化生长和化学控制腐蚀等方法，成功地生长出具有可调直径的碳纳米管和氧化物纳米柱有序阵列、Al2O3-AlN异质结纳米线、Y形和树枝状的金属纳米线以及Y形、藕节形和锯齿形的碳纳米管等多种一维结纳米材料及其阵列体系，探索了基于模板孔壁内沿生长一维结纳米材料的机制，较系统的研究了碳纳米管阵列的场发射性能和氧化锌纳米柱的发光性能，为低维纳米材料器件化提供了实验基础。

3 Enter into and upon and take possession of the Property or any part thereof (and for such purpose take any legal proceedings), and thenceforth to hold, possess and enjoy the same and to receive the rents and profits thereof without any lawful interruption or disturbance by the Borrower or any other person and/or (subject to any lease or tenancy granted by the Borrower with the Lender's prior written consent) let or lease the same or any part thereof at such rent, for such period and upon such terms and conditions as the Lender shall think fit and appoint any person at such reasonable and proper remuneration as the Lender shall determine to collect the rents and profits of the Property on behalf of the Lender, and surrender and accept the surrender of leases or tenancies of the Property

8.2.3 进入物业与取得物业或其任何部份的管有权（并为此目的提起任何法律程序），并从此在不受借款人或其他人任何合法干扰或骚扰的情况下，持有、管有与享有物业或其任何部份，以及就物业或其任何部份收取租金及收益，并／或（在不抵触经贷款人事先书面同意由借款人批出的任何租契或租约下）以贷款人认为合适的租金、租期、条款及条件，将物业或其任何部份出租或供人租赁；以贷款人认为合理与恰当的报酬，委任任何人代贷款人收取物业的租金及收益；退回物业的租约或租赁，以及接受退租

The results show that the rudder angle of torpedo, the battery activation time, and the initial velocity of torpedo all affect the trajectory of torpedo. The rudder angle ought to be set positive when torpedo is launched downwards,or set negative when torpedo is launched upwards to gain perfect trajectory. Meanwhile, shorter battery activation time and higher initial velocity of torpedo are necessary.

结果表明，以上3个参数对鱼雷弹道都有影响，由小深度向大深度发射鱼雷时，横舵管制舵角应设为正值，由大深度向小深度发射鱼雷时，横舵管制舵角应设为负值，并尽量缩短动力电池激活时间，提高鱼雷出管速度，电动力鱼雷管外激活发射可获得较好的弹道。

Guangzhou Rubber Hose Factory main products are: enhance the type of high-pressure hose steel wire, fiber-type series wrapped around pipes, to attract and scheduling category suction hose type, transmission type of hose, all kinds of flange with the first row of the large-diameter suction hose, aircraft refueling tube, refueling hose, metallurgical industry-specific management, oil drilling pipe, gas hose, steam hose, sand blasting hose and all kinds of hose assembly.

广州胶管厂主要产品有：钢丝增强类高压胶管、纤维编缠类胶管、吸引类及排吸类胶管、输送类胶管、各种带法兰头的大口径排吸胶管、飞机加油管、加油机胶管、冶金行业专用管、石油钻探管、煤气胶管、蒸汽胶管、喷砂胶管及各类胶管总成。

Jinyang company has Precision Screw Products Barrel (Barrel nitride screw, double screw alloy pipe, stainless steel screw cylinder, all-hardened screw, high-speed tool steel screw Barrel): injection molding machine screw feed extinguishers, extruder screw barrel, blow molding machine screw cylinder, chemical fiber Screw Barrel, Single-screw cylinder, parallel twin-screw barrel, conical twin-screw cylinder, screw feed tube attachment; Product selection quality 38CrMoALA; quality SACM645; quality SKD11; quality SKD61; 9Cr18MoV such as high-quality materials, the quenching and tempering, molding.

主要销售注塑机的螺杆，料筒等相关配件金洋公司主要产品有精密螺杆料筒（氮化螺杆料筒、双合金螺杆料管、不锈钢螺杆料筒、全硬化螺杆、高速工具钢螺杆料筒）：注塑机螺杆料筒、挤出机螺杆机筒、吹塑机螺杆料筒、化纤机螺杆料筒、单螺杆料筒、平行双螺杆炮筒、锥形双螺杆料筒、螺杆料管附件；产品选用优质38CrMoALA；优质SACM645；优质SKD11；优质SKD61；9Cr18MoV等优质材料，经调质、成型。

Tubular bells hang at one shelf different metal pipe of length, compass have one - 1/2 8 degrees and two 8 degrees, arrange with chromatic scale, beat the clock and in charge of carrying and bringing in sounding with the musical instrument mallet at the time of play.

管钟是将不同长度的金属管下吊在一个架子上，音域有一又二分之一个八度和两个八度，以半音阶排列，演奏时用琴槌敲击钟管顶端来发出声音。

INCLUDING JIANPI BRAND HOT-WATER BAG,CATHETER,HEMOSTATIC CATHETER,EARSYRING,BALL,RUBBER ADSORBENT BALL,MEDICAL AIR,CUSHION,BATHTUB MAT,SILICONE RUBBER CATHETER AND VARIOUS KINDS OF SILICONE RUBBERWARES ETC.

我厂是生产各种医用橡胶制品的专业厂。主要产品有健牌热水袋，道尿管、止血道尿管、洗耳球、橡胶吸球、医用气垫、浴缸垫、硅橡胶导尿管和各种硅橡胶制品等。

Its main products include electro-fusion quartz tube series, fused quartz tube series, fused quartz, crystal powder and other unshaped quartz products.

公司主要产品有：电熔石英管系列、连熔石英管系列、熔融石英、水晶粉、以及不定型的其它石英制品。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。