有管的

Dryer evaporator, heat expansion valve and control box, etc, and choosing packaged imported cooling compressor, famous brand controlling parts, and choosing packaged imported cooling compressor, famous brand controlling parts, and choosing packaged imported cooling compressor, famous brand controlling parts, and condenser used advanced B10 high efficient heat transmitting pipe, and can protect ship swing from flow-stop.

压缩机选用原装德国或美国进口制冷压缩机；冷凝器选用抗腐蚀能力强的海水型专用壳管式冷凝器，冷疑器铜管材质为B10，壳体为A3碳钢，管板、端盖为碳钢加防腐环氧树脂涂层，并且端盖内装有防腐锌块；关键电气控制元件选用进口名牌产品；电控箱内有冷冻水和超低温冰点控制，制冷系统有压力控制和超温泄放装置，有电机过热和电流电压保护措施。

SEM result showed that the sample had uniform phase distribution and smooth surface at dried state as well as interpenetrate network structure at hydrogel state. It was seen from the swell ing behavior curves that groups T1, T2 and T3 swelled rapidly within 10-30 minutes, and formed elastic composite hydrogel pipes. In addition, the expanding ratio of inner and outer diameter of the tube was 20%-30% and 100%-120% with swell ing, respectively. The equil ibrium water content of the hydrogel pipes increased with increase of collagen composition. Three groups of samples were immerged in PBS solution contained 2 mg/mL lysozyme at 37 for 1 month, their nozzle cracked, their wall became thin and more transparent. And also, there was small floc deposited on the tube surface.

扫描电镜观察到液氮脆断的人工泪小管内部成分分布均匀，内外壁表面平整，冷冻干燥的人工泪小管断口呈凝胶态的互穿网络结构。3 组不同成分的人工泪小管在PBS 溶液中浸泡30 min 后均快速吸水溶胀，外径扩大100%～ 120%，内径扩大20%～ 30%，并且随胶原含量增高，溶胀速度增快，平衡溶胀率增大。3 组人工泪小管在37℃含2 mg/mL 溶菌酶的PBS 液中浸泡1 个月后，表面有部分细小絮状物，管口开裂，管壁变薄，透明度增加。

Xuzhou Pierte Pipe System, is an earlier production of PP-R pipeline series of large private enterprises, since its creation has been committed to green fields of engineering research and development, the company adhering to the "pipeline Peart, green passage" of the concept 2001, namely the introduction of German equipment and technology imported raw materials production and sales professional in line with international standards DIN8077, DIN8078 for PP-R pipe, fittings, installation of equipment such as a full set of pipeline products, the company has main products: PP-R pipe fittings, GF PIPING, nano-antibacterial PP-R pipe pipe fittings, PE -RT heating pipe, PVC-U drainage pipes and other series.

不用担心记不住初始密码，该信息已经发往您的邮箱，请注意查收。不用担心记不住初始密码，该信息已经发往您的邮箱，请注意查收。苏州皮尔特管业，是国内较早生产PP-R 管道系列产品的大型民营企业，自创建以来一直致力于绿色环保工程领域的研究与发展，公司秉承"皮尔特管道，绿色通道"这一理念， 2001年即引进德国进口原料设备及工艺专业生产和销售符合国际标准DIN8077，DIN8078的PP-R管材、管件、安装设备等全套管道产品，公司主要产品有：PP-R管材管件、玻纤增强管材管件、纳米抗菌PP-R管材管件、 PE -RT采暖管、PVC-U排水管等系列。

The tracheary elements in secondary xylems of Actaea asiatica root and rhizomes were observered with a scanning electron microscope and found to contain abundant types, which mainly included tracheids, tracheid-like vessels, fibriform vessels, and typical vessels. Of these types, the tracheids, tracheid-like vessels, fibriform vessels were first found. Scalariform perforation plates, reticulate perforation plates, mixed perforation plates and simple perforation plates were observed in the typical vessels and the reticulate perforation plates ,mixed perforation plates were first founded the lateral-wall perforation plates, multiple end walls and pit membrane vestige were also observed in the tracheary elements.

利用扫描电子显微镜对毛茛科类叶升麻根和根状茎次生木质部中的管状分子进行观察，发现其管状分子类型丰富，主要有：管胞、管胞状导管、纤维导管和典型的导管分子，其中管胞、管胞状导管和纤维导管为在该类群中首次报道；在导管分子中，存在着梯状穿孔板、网状穿孔板、混合型穿孔板和单穿孔板，其中网状穿孔板和混合型穿孔板为在该类群中的首次报道；对其导管分子上的侧壁穿孔板、多穿孔板和纹孔膜残余也进行了描述。

MB1 root canals of the mesiobuccal root canals in maxillary molars were found obvious curve out by the rate of 82.5% in mesiodistal direction, 77.5% in buccolingual direction and there is no difference of curvature degree in the two directions.

结果：1上颌第一磨牙腭侧根管通畅、较直。2远中颊侧根管在近远中方向有80%，颊舌方向有45%出现大于5的明显弯曲，弯曲位置多位于根中1/3，且近远中向的弯曲明显大于颊舌向(P.05)。3上颌第一恒磨牙近中颊根颊侧根管在近远中方向、颊舌方向分别有82.5%、77.5%出现大于5的明显弯曲。

Companys main product includes: Each kind of specification PVC pyrocondensation drive pipe, hard tube, TPU tube, PE tube, PVC drivepipe , ABS tube, PET pyrocondensation drive pipe and so on.

公司的主要产品有：各种规格的PVC热缩套管、硬管、TPU管、PE管、PVC套管、EVA管、ABS管、PET热缩套管等等。

Thirty-five patients with carcinoma of the lower rectum were completed the cutting operation passing the belly in Dixon operation, clamping the sigmoid at the 5 cm of location for anastomosis passing anus to insert one piece of 22# foley urea pipe, using 15-20 mL of water filling into urea pipe ball bag, then pulling urea pipe to stop with clear blockage, and passing urea pope forward recta cavity to fill 100-150 mL of methylene blue dilution to observe the opening of anastomosis.

探讨直肠癌行低位Dixon手术，术中采用肠腔封闭式加压灌注检测及术后放置支架管引流对吻合口瘘的预防作用。1本组低位直肠癌患者经腹腔完成直肠癌直肠前切除吻合后，用肠钳在吻合口上端5cm处钳夹肠管，再经肛门插入1条22#Foley尿管，尿管球囊注入15~20mL水后向外拖动尿管至有明显阻力时停止。

They exhibit bending deformation following the direction of the nanotube curvature. At room temperature, a nanoparticle smaller than Au 70 often escapes from the carbon nanotube surface and can be captured again by the nanotube or coalesces with other nanoparticles to form a larger nanoparticle.

纳米颗粒在碳纳米管上形成以后，小于Au 70的纳米颗粒有可能脱离碳纳米管运动，它们在脱离后可能再度被碳纳米管俘获或者跟其他纳米颗粒结合并被重新吸附到碳纳米管上来。

The main products for the vehicle side bars, exhaust manifold, into the trachea, bumpers, and other cold-bend processing, the company has world-class computer numerical control machine automatically bend, bend forming the entire pipeline, and the corresponding Supporting the processing equipment; difficult for the stainless steel tube bending have a certain capacity and product quality, management and treatment of high demand.

主要产品有汽车侧面护杠，排气歧管，进气管，保险杠，中冷器及其他弯管加工等，公司拥有国际一流的电脑数控自动弯管机，整套弯管成形流水线，及相应配套的加工设备；对高难度的不锈钢薄壁管弯曲具有一定的能力，并对产品的质量，管理及处理有很高的要求。

The main products are various brands, a variety of aluminum tubes and the, Zi Tongguan, yellow brass, products used in refrigeration, warming system of copper pipes, electric heating pipe materials, water-car - Trachea, sanitary ware, machinery, electric furnace, chemicals, such as pipe.

主要产品有各种牌号，各种规格的铝管及铝合金管、紫铜管、黄铜管，产品用于制冷、制暖铜水管、电热管材料、汽车通水通气管，卫生洁具、机械、电炉、化工管材等。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。