有气缸的

Use the ruler and the feeler to inspect whether the joint surface of the cylinder head is deformed.

利用直尺和塞尺检查气缸头的结合面是否有变形。

By the time the crankshaft completes two revolutions, each cylinder in the engine will have gone through one power stroke.

此时，机轴完成两次旋转，在发动机里的每一个气缸都会有一次撞击。

The company, founded in 1978, has 20 years of history, specializing in the production of hydraulic cylinders, hydraulic pumping station pneumatic system of professional manufacturing company.

本公司创建于1978年，已有二十多年历史，是专业生产液压油缸气缸、液压气动系统泵站的专业制造公司。

An original exhausted-air reclaiming technical method has been presented, that is to say, the discharging chamber's pressure-air is reclaimed into the air tank through the additory of the exhausted-air reclaiming control devices which can be considered as the mid-pressure air supply for reutilization in order to realize the aim to save energy.

论文提出了一种创新性的气缸排气能量回收技术途径：通过附加排气回收控制装置将气缸排气腔的有压空气回收到储气罐中，并作为中压空气源再利用，以实现节能。

Today, in the foreign intelligent artificial leg, the executive mechanism which controls the bent and stretch"s movement of knuckle and the pendular movement of calf is a single air cylinder. In the air cylinder, there is a throttle, the cylinder"s damp can be adjusted by controlling the opening of the throttle valve, when the air cylinders damp changes, the pendular speed of calf will change too.

目前，在国外研制成功的智能人工腿中，控制膝关节屈伸运动及小腿摆动的执行机构是一个单级空压气缸，其内有一个针阀，通过调节针阀的开度可控制气缸阻尼，从而控制小腿摆动的速度。

The operation of their engine is fairly clear from the diagram; there are two vanes that slide in and out under the control of cam grooves in the end of the cylinder; it is not easy to see here but there are swivelling shoes on the ends of the vanes.

的运作，他们的引擎是相当明显的从图；有两个叶片该幻灯片在进出控制下的凸轮槽在年底气缸；它是不容易在这里看到，但有旋转鞋上的两端该叶片。

To address this situation, I believe that the operation could be improved on are: the installation and adjustment of measuring, the first sub-scale do to adjust the nominal cylinder liner size, and then dial indicator card installed and well well inserted under the initial installation of the traffic card directly into the cylinder table by measuring the smallest cylinder liner wear, the cylinder table adjust the volume of the extended length of rod inserted, so that the volume of the dial indicator cylinder table has small hands around 1.5-2.0 preloading cell volume and cylinder volume table mother under lock locking plug, the final table and then measured the volume of cylinder rod and rod card inserted at the anvil micrometer measuring bar between the seat and the large dial and adjust the dial indicator to zero.

针对这种情况，笔者认为，操作上可改进为：安装和调整量具时，先将干分尺调整到气缸套的公称尺寸，再将卡装好百分表和初步安装好插杆的量缸表直接卡入所测气缸套磨损最小处，调整量缸表插杆的伸出长度，使量缸表的百分表小表针有1.5-2.0格左右的预压量并将量缸表的插杆锁母锁紧，最后再将量缸表的测杆和插杆卡在千分尺的砧座和测杆之间并将百分表的大表盘调整到零。

The first direct measurement with micrometer piston skirt and the outside diameter Do micrometer stop screw to the locking plate position, and then dial indicator card installed and well well inserted under the initial installation of the amount of cards, directly into the cylinder corresponding cylinder kit, adjust the volume of the cylinder rod out in table inserted length, so that small hands dial indicator cell has about 1 volume of pre-press and lock locking rod inserted mother, at the same time, large dial indicator dial to adjust zero, the last cylinder to adjust the volume of good form under test card inserted rods and do at Anvil micrometer and measured the rod between the big hands dial indicator at this time than the "zero" high value is the piston and cylinder liner with the space.

3先直接用千分尺测量活塞裙部的外径并将干分尺止动螺钉扳转到锁紧位置，再将卡装好百分表和初步安装好插杆的量缸表直接卡入对应气缸套内，调整量缸表插杆的伸出长度，使百分表的小表针有1格左右的预压量并锁紧插杆锁母，同时将百分表的大表盘调整到零，最后将调整好的量缸表的测杆和插杆卡在干分尺的砧座和测杆之间，此时百分表大表针比&零&高的数值即为活塞和气缸套的配合间隙。

The first direct measurement with micrometer diameter piston skirt, and then dial indicator card installed and the initial installation of the amount of good cylinder rod inserted card table micrometer mounted on the anvil between the seat and the measuring bar, adjust the volume of cylinder table Interpolation of the extended length of rod, when the dial indicator has small hands around 1.5-2 cell volume preloading lock locking rod inserted mother, and a large dial indicator to zero adjust the final stretch to the volume of cylinder table into the Cylinder Sleeve, large dial indicator hands than "zero" low value (considering the small hands reading) is the piston and cylinder liner with the space.

2先直接用千分尺测量活塞裙部的外径，然后将卡装好百分表和初步安装好插杆的量缸表卡装在千分尺的砧座和测杆之间，调整量缸表插杆的伸出长度，当百分表的小表针有1.5-2格左右的预压量时锁紧插杆锁母，并将百分表的大表盘调整到零，最后将量缸表伸入气缸套内，百分表大表针比&零&低的数值即为活塞和气缸套的配合间隙。

On some occasions,two-step orthogonal toggle force-amplifying press based on pneumatic-mechanical compound transmission systems can be used instead of hydraulic transmission systems that cause environmental pollution.

而气压传动系统中的工作介质，是洁净的压缩空气，从这一点上来说，气压传动可以说是一种绿色化的传动技术。目前也有少量压力机采用气压传动，但是都是使用有杆活塞缸，这种气缸一般刚性比较差，且空间利用率低。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。