有机硅的

In this study, the CPE processes of four different kinds of polyaromatic hydrocarbons, acenaphthene, anthracene, phenanthrene and pyrene, with two kinds of silicone surfactants, DC-193 and DC-190, were studied separately, and four different assisting methods for the phase separation of the CPE process including heating at a higher temperature, adding salts, centrifugation and stirring were introduced, respectively.

今利用两种聚醚型有机硅表面活性剂DC-193和DC-190，对蒽、菲、芘和苊四种多环芳烃进行浊点萃取研究，分别使用加热、加盐、离心和搅拌等辅助方法改变相分离过程的速度。通过测定表面活性剂富集相的体积百分率Vs/随时间的变化和最终的萃取率，研究上述四种不同辅助方法对相分离行为和萃取性能的影响。

The results are listed as following :㏕he best anti-erosion proportion of resin present is 25wt% in the condition of silicon carbide reinforced SMCC, while the alumina reinforced SMCC is 40wt%.(2) The better anti-erosion results was achieved with the ratio of silicone resin to acrylic resin containing hydroxy being 3: 1.㏕he composites coating tends to be more brittle when added in alundum particles. It also means that the maximum erosion peak of alundum reinforced SMCC tends to normal angle.甌he change of erosion rate of SMCC can be divided into two stages with the increment erodent velocity: the slow erosion stage of the beginning and the stable erosion stage.

首次发现：①SiC增强的复合涂料涂层，树脂含量为25wt％时，具有最佳耐冲蚀性能：Al_2O_3增强的复合涂料涂层，树脂含量为40wt％时，具有最佳耐冲蚀性能；②SiC增强的涂料，有机硅树脂与丙烯酸树脂的比例为3：1时的耐冲蚀性能好于1：1的复合涂料涂层；③Al_2O_3增强体使涂层变脆的倾向大于以SiC为增强体的涂层，即SiC增强的复合涂料涂层的最大冲蚀率出现在30°，Al_2O_3增强的复合涂料涂层的最大冲蚀率出现在75°～90°之间；④低速冲蚀磨损机理主要是弹性变形与疲劳；高速冲蚀磨损机理主要是显微切削和显微犁耕。

And VTMS is added in late stage of polymerization, in this situation the system has the lowest coagulum. When the hydroxyl value of such polymer increases, the coagulum decreases; and solid content of such polymer increases, the coagulum increases greatly, so it is difficult to get higher solid content emulsion.

采用正交实验方法，通过对有机硅改性丙烯酸乳液聚合过程中凝聚物含量、乳液粘度影响的研究，确定的最佳的反应条件是：以SLS/OP为乳化剂、比例为4/6、用量为2％、丙烯酸单体的用量1.5％、反应温度为75℃、改性剂VTMS用量是1.5％、改性剂后加入方式下聚合反应过程中有最低的凝聚物含量。

Caiyan Silicones Division in order to produce high quality products, the introduction of domestic and foreign advanced production equipment and testing, research, development of equipment and facilities, and continuously improve product quality, and continuously research, develop new products, in the domestic break with tradition, pioneered the development of intermittent production of rubber.

彩艳有机硅事业部为了生产出高质量的产品，引进了国内外先进的生产设备和检测、研究、开发的仪器和设备，不断提高产品的质量，不断研究、开发出新的产品，在国内打破传统，率先开发间歇法生产生胶。

The present invention adopts polyvinyl perchloride and organosilicon modified acrylic resin as main filming material and adds cyanuramide phosphate and expanding graphite into common polytriammonium phasphate as fireproof assistant to constitute foaming material. The present invention has greatly raised foaming rate and the foamed layer has thickness of 30-50 times the original coating thickness and fireproof limit up to 90 min.

本发明采用高氯化聚乙烯和自行合成的有机硅改性丙烯酸酯树脂为主要成膜物质，并在通常所用的聚磷酸铵类防火助剂的基础上，加入三聚氰胺磷酸盐和可发性膨胀石墨作为发泡材料组成，大大提高了涂层的发泡率，发泡层厚度可达原涂层厚的30～50倍，耐火极限可达90min(涂层厚度2mm)。

Based on the deterioration mechanism of corrosive medium, a lot of polymer such as ternary-polymer, adding-felt addition, hydrophobe and polypropylene fiber were added to enhance the performance of anti-corrosion, anti-penetration, conglutination and anti-cracking of original cementious material. The microstrure of cementious material was changed from the simplex hydration product of cement to the superposition structure of the hydrolysate of polymer and the hydration product of cement. A lot of the corrosive ions were prevented from the interior of concrete by this stable structure. The results of tryout indicated that the mending material has the good effect at the corrosion form of corrosive medium.

根据介质腐蚀形式的劣化机理，该文以提高修补材料耐腐蚀性能、抗渗透性能、粘结性能和抗裂性能为出发点，采用添加有机硅改性三元共聚物、增粘剂、孔隙憎水剂等多种聚合物和聚丙烯纤维对原水泥基材料进行改性，使得修补材料的内部微观结构从单纯的水泥水化产物转变成聚合物和水泥水化产物叠合的空间网状结构，这种稳定的结构能有效抵抗各种介质离子的侵蚀，在实际工程上的试用也显示出新修补材料良好的使用效果。

Currently, the material of gifts and home appliances includes soft PVC, silicone bracelet, metal, wood atc., our main prodcuts are:craft candle, sports and Xmas series gifts, antique reproduction home products and other decorations and so on, our clients network have covered South-East Asia, Europe and America, they are recognized by market acceptance and customer unanimous assessment as the high level of skills, excellent quality and competitive price.

目前，该材料的礼品及家居产品，包括软质PVC ，有机硅，金属制品，木制品空管，我们主要prodcuts是：工艺蜡烛，体育和圣诞礼物系列礼品，古董复制家用产品及其他装饰品等，我们的客户网络已coverd东南亚，欧洲和美洲的，他们是recongnized受到市场的认同和客户的一致评价，作为高层次的技能，优良的品质和极具竞争力的价格。

Durable and water-repellent polysiloxane softeners are urgently needed auxiliaries by the textile industry recently. Their action mechanism, the preparation and application of this kind of auxiliaries are given and analyzed in the related course.

耐久型和拒水型有机硅柔软剂是一种新型的柔软剂，其制备过程和在纺织品上的应用在本章节的讲授中将予以详细的讲解分析。

Then,the hybrid coating was characterized by means of FTIR and solid state 29Si-NMR.Moreover,the conversion of ethylene linkage and the polycondensation degree of siloxane were determined.

研究了有机硅用量对杂化漆膜性能的影响，并用FTIR和固体29Si-NMR对杂化涂料进行了表征，测定了UV固化C=C的转化率和硅氧烷的缩聚度。

Two low infrared emissivities of adhesives coating are obtained: silicone varnish and EPDM_g_AA polymer .

通过研究发现，铝粉和氧化铅具有较低的发射率，并得到了以有机硅清漆和EPDM接枝聚合物为基体的低红外发射率涂料，它有助于对红外隐身涂料粘合剂、填料、颜料颗粒的选择。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。