最高速度

The line is ever developed production speed is the highest bookbinder, up to 10000 this/while the 1980s the international advanced level.

该线是我国迄今所开发出的生产速度最高的胶订机，最高可达10000本/时，达到了80年代的国际先进水平。

To travel at a constant speed, or at a speed providing maximum operating efficiency for a sustained period.

以经济速度行驶以稳定的速度行进，或在一段时间内以发动机效率最高的速度行驶

During chemotherapy both systolic maximum and diastolic minimum blood flow velocity and resistance index in renal segmental artery and interlobular artery were meaured by color doppler weekly.

于化疗中每周应用彩色多普勒超声仪监测患者肾脏血流，测定肾脏中心区域的区域动脉、叶间动脉的血流速度波形，求得收缩期最高血流速度，扩张期最低血流速度及阻力指数。

Effects of dry temperature and dry time on properties of heat cured sand and the relationship with binder composition are as follows:sands bonded by binders that are not modified have high strength when dry temperature is high and dry time is long,but their anti-wettability power is poor . Sands bonded by binders that are modified by B but not modified by M can be dried quickly and sand strength is high but anti-wettability power is also poor. Sands bonded by binders that are modified by M but not modified by B can also be dried quickly to obtain maximum strength,then the strength becomes lower when they are dried continually for more time. and sand strength is high but anti-wettability power is also poor. Sands bonded by binders that are modified by M as well as by B at the same time can be dried quickly to obtain maximum strength at low temperature and short time. But the anti-wettability of sand mold is best when they are dried at high temperature and long time.

烘干温度和烘干时间对热硬砂性能的影响及其与粘结剂改性的关系是：未经改性剂B和改性剂M改性的粘结剂砂，脱水速度较慢，烘干温度越高，时间越长，则硬化强度也越高，但未经改性的粘结剂热硬砂的抗吸湿性较差；经改性剂B而不经改性剂M改性的粘结剂热硬砂，烘干硬化速度较快，强度也高，但在高湿度下的抗吸湿性不好；经改性剂M改性而不经改性剂B改性的粘结剂热硬砂，烘干时强度先随烘干时间升高至最大值后，继续烘干时强度又出现下降；经改性剂B和经改性剂M共同改性的粘结剂热硬砂能在短时间和较低的烘干温度下就可烘干到最高强度，即烘干脱水的速度较快，但试样的抗吸湿性差，若在更高温度和更长时间下烘干，试样的抗吸湿性得到改善，综合考虑烘干强度和抗吸湿性要求，对于φ30×30mm试样，理想的烘干温度是200℃，烘干时间20分钟。

The environmental laboratory has 1,110 m 2 , in the possession of 20 advanced test equipments that both from China and other countries such as USA , France , Italy , Japan , etc. The speed of decreasing temperature could reach 15 ℃/min, the raising speed of temperature could reach 30 ℃/min and be capable of adjustment continuously. 29 m 3 test box could test temperature, temperature and humidity for large electrician and electronic equipment. The speed of raising temperature could reach 6 ℃/min at best. Vibration test equipment include slipway, it could carry through three axis vibration, and the minimum thrust force is 5 tons.

环境实验室建筑面积 1100 平方米，拥有从美国、法国、意大利、日本等国家引进的国外及国产先进试验测试设备 20 台，降温速度最高可达到 15 ℃/min ，升温速度可达 30 ℃/min且连续可调； 29 立方试验箱能对大型电工电子设备进行温度、温度循环及湿度试验，升温速度最高可达 6 ℃/min ；振动试验设备有滑台，可进行三轴向振动，最大推力可达 5 吨。

Every treatment combination has 4 replications.(1)The germination indexes of the former are higher than that of the latter; the germination of the former is stimulated by NaCl density of 0.3 %, while that of the later is restrained by all kinds of NaCl density.(2)With increasing of temperature and PEG indesity,the order of germination rate and vigor of Bromus stamineus and Bromus inermis is decreaced.(3)Under treatment of broadcast sowing and plant density of 549kermels·m~(-2), Bromus stamineus has the highest bud rate, fresh weight, seed yield, while treated with 25cm row spacing and 412kermels·m~(-2) plant densities, tillers, plant height, growth rate increased to the top;(4) Under treatment of broadcast sowing and plant density of 549kermels·m~(-2), its growth rate is took second place, while treated with 15cm row spacing and 824kermels·m~(-2) plant densities, it has the highest seed yield

3撒播时，引进种在播种密度为549粒·m~(-2)处理下单位面积出苗率最高，分蘖数最多，鲜重最大，单株最高，种子产量最大；生长速度在播种密度为412粒·m~(-2)处理下生长最快，密度为549粒·m~(-2)处理下稍次之，结合方差分析可以初步确定它在撒播时的播种密度为549粒·m~(-2)；(4)条播时，在行距为25cm、播种密度为412粒·m~(-2)处理下单位面积分蘖数最多，鲜重最大，单株最高，生长速度最快；种子产量在行距为15cm、播种密度为824粒·m~(-2)处理下最大，在行距为25cm、密度412粒·m~(-2)处理下次之；结合方差分析，就3种规格的行距来说，引进美国无芒雀麦条播时的行距为25cm，播种密度为412粒·m~(-2)；就这两种播种方式来说，应该选择撒播。

The leaves and uncrushed stems had the highest and lowest drying rates among the four components.

随着干燥温度和表现速度的增加，苜蓿的干燥速度也增加，其中叶片干燥速度最高，未压扁的茎秆速度最低，并且叶片和茎秆的水分差异也增大。

The computational results indicate that surface catalytic combustion restrains gas phase combustion. Inlet velocity and tube diameters have important influence on catalytic combustion of hydrogen. For smaller inlet velocities,reaction is dominated by gas phase combustion. As the inlet velocity increases,there exist both surface catalytic combustion and gas phase combustion. For bigger inlet velocities,reaction is dominated by surface catalytic combustion. The temperature of flame core decreases with the decrease of tube diameter.

计算结果表明，表面催化反应对空间气相反应有抑制作用；入口速度和管径对氢气的催化燃烧过程有重要的影响，在入口速度较小时，燃烧主要是空间气相化学反应，随着入口速度的增大，燃烧过程同时存在着表面催化反应和空间气相反应两种控制因素，在入口速度较大时，燃烧主要是表面催化燃烧过程；随着管径的减小，微型管道内反应的最高温度降低。

It combines rough and fine processes into one and achieves low metal removal rate as compared with cutting processes such as welding and milling.

它与普通磨削的区别在于很高的磨削速度和进给速度，而高速磨削的定义随时间的不同在不断推进。20世纪60年代以前，磨削速度在50m/s时即被称为高速磨削；而20世纪90年代磨削速度最高已达500m/s。

Passing through the nozzle at the highest speed, Impulse turbine steam directs against a row of blades which assembled in the axles of Impulse turbine with radiation shape.

当蒸汽以最高速度从喷嘴里喷出时，便冲击一列呈辐射状安装在涡轮机主轴上的动叶片。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。