最高温度

The N and Al elements hindered phase transfer of TiO_2, restrained growth of nano-TiO_2 particles and improved the crystallization temperature. Degradation ability of N and Al co-doped TiO_2 thin films annealed at 500℃to acid fuchsin whether under UV light or under artificial simulated sun light was the best.

无论是在紫外光下还是人工模拟太阳光下，其对酸性品红的降解效果存在一个最佳退火温度。500℃退火处理N和Al共掺杂TiO_2薄膜的光催化活性最高。

The revised Hargraves formula has the best result compared with Penman-Monteith formula, the average relative error is 6%, moreover, Hargaves method requiring the least data in calculating ETo, so this method has the high actual application value; The following are Radiation method and Blaney-Criddle method ; The worst is the Pan method, even after revised, the highest and average relative error is 36% and 10%, respectively. So, in this study, Penman-Monteith method, Radiation method, Blaney-Criddle method and Hargraves method are used except Pan method.

在这四种方法中，修正后的Hargraves方法与彭曼—蒙特斯方法的计算结果符合最好，其平均相对误差为6％，而Hargraves方法需要的气象数据只有计算时段的最高、最低温度，该方法具有较高的实际应用价值；辐射方法和布兰尼—克里德尔方法次之；蒸发皿方法最差，即使在修正后，E601型蒸发皿的最大误差也高达36％，平均为10％，所以在预报系统的研究设计中采用了除蒸发皿方法之外的四种方法。

This article demonstrates all kinds of techniques of fine-turning incubation temperature during incubation to keep highest hatchability

本文阐明了孵化温度的各种微调技术，以保持最高的孵化率及雏鸡质量。

Heat loss coefficient is one of the most important parameters in the solar-thermal conversion of evacuated tubular collectors.

一、前言热损系数是真空集热管的一个重要性能参数，它直接影响集热装置的效率及最高集热温度。

Found that the constitution of the absorbent could affect the debinding efficiency greatly; for the liquid phase debinding temperature extent, the mechanism of the absorbent is capillary action, 100~200 screen mesh alumina powder had the best debinding efficiency at 130℃; for the gas phase debinding temperature extent, adding some active carbon to the absorbent could control the formation of the hyperoxide barrier lay, accelerate the mass transfer rate, also enhance the debinding efficiency; studied the relationship between the debinding efficiency and the shape of the green part and the solid load; furthermore, did trial study on the solvent debinding.

发现吸附剂的组成对脱脂效率有较大影响；在液相脱脂温度段，吸附剂的作用机制为毛细管作用，100~200目的氧化铝粉末在130℃时具有最高的脱脂效率；在气相脱脂阶段，在吸附剂中引入活性碳可以抑制不利于脱脂的过氧化物阻挡层的形成，加快气相在坯体中的传质速率，进而提高脱脂效率；研究了坯体形状尺寸和装载量等因素与脱脂效率的关系；还对溶剂脱脂进行了试探性研究。

Maximum input bias current is 10 pa and typically remains below 300 pa over the entire industrial temperature range.

最高输入偏流通常仍低于10和300坝坝在整个工业温度范围。

North belongs to semi-tropical mediterranean climate littoral, inland and vast area belongs to intertropical and desert climate, air temperature is highest amount to50℃.

北部延海属亚热带地中海型天气，内地广泛地方属热带荒漠天气，温度最高，达50℃。

First of all, this study will be multi-walled carbon nanotubes by chemical oxidation process purified so it can be modified to deal with than the purification of purity before the modified 5 wt%, more than 1.89 times the surface area to increase the surface potential decrease of about 10 ~ 20 mV and the surface functional base (-COOH and-OH) to increase 1.45 times, and then the control technology of electroless preparation parameters include: analysis of plating time, plating analysis of temperature, metal ions in solution than the (Fe2+/ Ni2+), bath pH and the added value of dispersion Agent and other research towards Fe-Ni particles to increase the iron content and Fe-Ni particles spread in the MWCNT upper fixed targets,the results found that when the parameters for the preparation of 50 ℃, pH10, do not add dispersant, metal ions than the solution (Fe2 +/ Ni2 +) 7, the highest iron content can be Fe = 40.55 at%(flat iron content 111.17 mg / g) of nanocomposites Fe-Ni/CNT, then for a series of the nature of its analysis, the final evaluation Fe-Ni/CNT nanocomposites were processed on the effectiveness of the application of mixed pollutants, the results showed that in 120 minutes at the same time when Adsorption of heavy metal ions lead nitrate 10 ppm, selenium heavy metal ion degradation of 1 ppm and orange azo dye AO7 50 ppm standard of effluents, and after a total Fe-Ni nano-particles to SEM / EDS analysis of more than 50% still remaining.

本研究首先将多壁奈米碳管以化学氧化法做纯化改质处理能使其纯度较纯化改质前提高5 wt％、比表面积提高1.89倍、表面电位下降约10~20 mV以及表面官能基提高1.45倍，再控制无电镀技术之制备参数包括：析镀时间、析镀温度，镀液中金属离子比(Fe2+/Ni2+)、镀液pH值及是否添加分散剂等，研究朝提高Fe-Ni粒子的含铁量与Fe-Ni粒子散布固定在MWCNT上等目标进行，研究结果发现当制备参数为50 ℃、pH10、不添加分散剂、镀液金属离子比(Fe2+/Ni2+)7时，可得到最高铁含量Fe = 40.55 at％(单位铁含量111.17 mg/g)之奈米复合材料Fe-Ni/CNT，接著对其作一系列性质分析，最后评估奈米复合材料Fe-Ni/CNT对共处理混合污染物之应用效益，结果显示其在120分钟时能够同时吸附重金属硝酸铅离子10 ppm、重金属硒酸根离子1 ppm及降解偶氮橘色染料AO7 50 ppm达放流水标准，且共处理后奈米Fe-Ni粒子以SEM/EDS分析仍剩余50 %以上。

Result: The inductivity of leaves was the highest about 87.5%,followed with the stem section and leafstalk;The inductivity of nutrient medium such as MS,B5 callus was higher than the on...

结果：叶片的诱导率最高，为87.5%；茎段次之，叶柄较差；培养基MS，B5愈伤组织诱导率较高，达到了80%以上，高于培养基H，SH和改良W h ite的愈伤组织诱导率；偏低的pH对愈伤组织生长有利，出愈率高，但从愈伤组织生长质量方面看，不同pH差异不明显；愈伤组织诱导最适温度为25℃。

The results showed that when the catalyst amount was 4 g/L,the molar ratio of L-ascorbic acid to malic acid was 1:3,and the reaction temperature was 55 ℃,the highest L-ascorbyl malate yield of 69.30% could be obtained.

结果表明：添加固定化酶量4g/L，底物配位物质的量比1：3，温度55℃，L-抗坏血酸苹果酸酯的得率最高为69.30%。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。