最高温度

With the conventional aging treatment the critical temperature is lower than 373 K in Mn-Cu alloys.

但是目前的时效处理后的Mn—Cu阻尼合金的最高使用温度只在80℃以下。

Scenic resource features: There are tropical montane rain forest manhao; there gibbon keeping the country's largest base - Bao Hua Shan Zoo; there Yunnan that is the highest temperature 95 ° C-103 ° C at the end of the Ah sprinkling hot springs; domestic latest discovery of new multi-superoxide Cycas landscape; are renowned at home and abroad have tin culture; there is domestic only chicken months 600 mm wide rail.

风景资源特征：有曼耗热带山地雨林；有全国最大的长臂猿饲养基地－－宝华山动物园；有云南境内温度最高即95°C－103°C的丫洒底热泉；有国内最新发现的新种多歧苏铁景观；有驰名中外的锡都文化；有国内仅存鸡个600毫米宽的铁路。

The results show that the demanganization and desiliconization rate are as high as 80~90% in a best temperature of 1500℃; if more agents are added, decarburization reaction will appear with formation of foam slag.

结果表明，铁精矿A的最佳适用温度为1500℃，最高脱硅脱锰率均达80%～90%，进一步提高加入量只会促进脱碳反应的进行，从而生成泡沫渣。

With the densimeter, the reliability of it was confirmed with literature data.

该装置主体为厚壁毛细玻璃管，可耐醋酸腐蚀并可承受最高10.0MPa的压力和573.15K的工作温度。

When formaldehyde:dimethylamine is 2:1,the temperature of reaction is 55oC and the time of reaction is 2h, the ratio of production is the highest.

单体合成中探讨了羟甲基二甲胺的合成工艺，当甲醛：二甲胺为2：1，反应温度为55oC，反应时间为2h时，羟甲基二甲胺的收率最高；并通过NMR确定了其结构。

It can be assured that the temperature of elusion of the products under the highest pressure (30000Psi) is 4～10℃, which is now the best standard in the world.

项目 市场前景由于本产品在最高压力（30000Psi）情况下能保证出样温度4～10℃，此指标具有国际领先水平，故有高的破碎率和高的活性率。

Result: The inductivity of leaves was the highest about 87.5%, followed with the stem section and leafstalk; The inductivity of nutrient medium such as MS, B5 callus was higher than the ones like H, SH and the White callus amended one; It was found that low-grade Phvalue benefits the growth of callus. The experiment result showed that different pH showed little difference in quality. The best condition of culture was 25 ℃in temperature. Conclusion: The best culture condition for callus was the leaves as explantation.

结果：叶片的诱导率最高，为87.5%；茎段次之，叶柄较差；培养基MS，B5愈伤组织诱导率较高，达到了80%以上，高于培养基H，SH和改良White的愈伤组织诱导率；偏低的pH对愈伤组织生长有利，出愈率高，但从愈伤组织生长质量方面看，不同pH差异不明显；愈伤组织诱导最适温度为25 ℃。

The optimum extraction conditions were obtained by using 5 mL of water (pH=8) as the extractant at 70℃ with 5 min static extraction.

研究表明，在萃取温度70℃，萃取时间5 min，提取液的pH为8.0，提取液体积为5 mL的条件下，灭多威有最高萃取效率。

The radial mobility is highest in the region of high electron temperature and when the magnetic field lines are radial.

光线的可动性在高的电子温度和有磁性的领域线何时是光线的区域中是最高的。

After being installed and debugged, the equipment was used to spin the filature resin into firstborn fiber.

纺出了初生纤维，对初生纤维进行了固化处理并进行了 IR、XRD、DTA、TG 等结构表征，纤维的最高使用温度到达 370℃。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。