最高温度

The change of temperature had no significant effect on the amylase activity of liver and intestine.

随温度变化淀粉酶活性变化不大，在40℃时，淀粉酶活性最高。

The microspore was more like a tetrahedron, whilethe polar was more like a triangle. The number of microspore in every anther wasbetween 2600～3600, so the amount of pollen was quite large that it was propitiousto spread and pollination. P/O was 8088 and the breed system was singleheterosexual copulatoryb. The viability of pollen was normally above 50%. The testof pollen culture showed that the viability of pollen was up to the tiptop under thehigher temperature and lower humidity (38℃,40%),while it was weakest under thelower temperature and lower humidity (16℃,40%).The OCI is 4, and the breedsystem was belong to autocopulation. If it was heterosexual copulatory, there must beintermediums for pollination. It was recorded there were more than 40 species ofinsects on the anthotaxy or followers of Malania Oleifera. Under different weather,different living environments and different plants the frequency and rush hour of theinsects to visit the followers were different. Actions of different kinds of insect werealso different. According to the results of the observation, the form of fluid and seedof Malania Oleifera mostly rely on the action of insect pollination, especially thebees.

蒜头果的花序为聚伞形花序，有小花8～10朵，小花较小；按花粉大小等级划分，蒜头果的花粉粒属于小的范围；花粉粒呈近四面体，极面为近三角形：每粒花药所含的花粉粒在2600～3600粒之间，花粉量较大，有利于花粉的传播和授粉；胚珠比值为8088，繁育系统为专性异交类型；花粉生活力一般在50％以上；在不同温度湿度条件下测得蒜头果花粉的生活力在高温低湿(38℃，40％)的条件下最高，在低温低湿(16℃，40％)的条件下最低；杂交指数值为4，繁育系统自交亲和，异交，需要传粉者；记录到的访花昆虫有40余种，访花昆虫的访花频率及高峰时间不同，不同种类的昆虫的访花行为也是各有所异；从观察的结果看，蒜头果的种实的形成大多数依赖于传粉昆虫的活动，其中主要是蜂类。

And HP PLOT-U columns The inertness of the porous polymer allows the elution of a range of apolar and polar compounds, especially the most active and polar compounds such as H〓O, H〓S eluted symmetrically. It has been stabilized to withstand temperature of up to 300℃.

与一般的商品化PLOT-Q和PLOT-U型PLOT色谱柱相比，热稳定性和机械强度有明显的改善和提高，色谱柱最高使用温度分别提高了50℃和20℃（达到300℃和210℃）。

The arithmetic mean of the weekly high and low temperatures is then used in the calculation of MKT.

周最高和周最低温度的算术平均用于计算MKT。

The discovery of superconductivity with a critical temperature higher than 40 K in the iron arsenide LnFeAs has drawn much interest in condensed matter physics.

最近，由于在铁基LnFeAs化合物及其相关化合物中发现具有高于40K的超导电性，层状的铁基化合物引起了凝聚态物理学界很大的兴趣和关注。在随后的研究中发现，在该类材料中最高超导临界温度可达到55K。

The results show that in order to obtain optimal propagation results, the optimal pH is 7.0, the temperature is 28℃, the carbon source in culture medium is corn, the nitrogen source culture medium is barm.

结果表明：pH值7.0，温度28℃最适合HDF01的生长。培养基中以玉米粉为碳源，酵母粉为氮源，加入微量元素Mn及雄生素B6，HDF01的产孢量最高。

This paper also reports the fusion curves of carbon tetrachloride, chloroform, bromoform, silicon tetrachloride, benzene, nitrobenzene, bromobenzene and chlorobenzene at pressures up to 3500 MPa between 226 K and 915 K.

本论文还讨论了四氯化碳、氯仿、溴仿、四氯化硅、苯、氯苯、溴苯和硝基苯八种纯物质的熔点曲线，温度范围为226 K到915 K，压力最高为3500 MPa。

The retrieval technology of effective chlorine in mother liquor of calcium hypochlorite was researched,and the effects of cycle number on effective chlorine content of calcium hypochlorite were tested.

结果表明，烧碱质量分数为25％、氯化温度为20 ℃时，漂粉精的有效氯含量最高；标准筛目数为180目时，漂粉精的有效氯含量较高而过筛率不太低；循环次数对漂粉精有效氯含量没有显著影响，并且漂粉精有效氯含量基本上可以达到80％以上。

The results show that there are little difference of CO sensitivity between precipitation transformation method and sol-gel method, the sensitivity of copper oxide loading on zirconium oxide or cerium oxide is better than that of loading on alumina or silicon dioxide, the optimal calcinations temperature is 500 Celsius degree and the optimal copper content loading on cerium oxide is twelve percent.

实验结果表明，材料的制备方法对气敏性质的影响不大；锆铈基氧化物的气敏性质较高，而Al2O3，SiO2作载体时效果要差一些；焙烧温度在500℃时对CO具有最好的灵敏度；当负载在氧化铈载体上的氧化铜含量为12%时，对CO的气敏性质最高。

When the sodium lauryl sulfate and p-octyl polyethylene glycol phenyl ether is used and its level in 3% and 6: 4 ratio, the polymerization process has the lowest coagulum and the highest monomer conversion. Higher reaction temperature and more level hydroxyl value lead to more coagulum, the latter also lead to larger particle size. The acid value has larger influence on viscosity and coagulum, there exist a best range. The emulsion particle size is larger for its hydrophilicity, most of its particles are connected together.

在含较高亲水单体的乳液聚合体系中，难以制得稳定的预乳化液，不能采用工业生产中常用的预乳化工艺，而只能采用混合单体直接滴加的方法；由于单体混合物的亲水亲油值较高，用阴离子型乳化剂十二烷基硫酸钠和非离子型乳化剂聚乙二醇辛基苯基醚混合，用量为单体总量的3％，且比例在6：4时，乳液聚合时具有最低的凝聚物含量和最高的单体转化率；乳液聚合反应温度升高，可以提高单体转化率，增加反应速度，但凝聚率相应提高；随着羟基单体含量的增加，聚合过程中凝聚率增加，聚合物乳胶粒平均直径增加；羧基单体有一个最佳的用量（2.6％），过高或过低凝聚率均提高；羧基含量对乳液的粘度有较大的影响，当羧基含量较低时，羧基含量增加，乳液粘度增加明显；含羟基乳液粒子由于含亲水基团较多，使得乳胶粒径增大，乳胶粒子大多数互相凝聚在一起，处于凝聚态。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。