最高温度

The results showed:(1) Through glycosylated orthogonal test, When the substrate concentration is 1:2, glycosylated temperature is 60℃, the enzyme dosage is 0.5%and glycosylated time is 6 hours, glycosylating was at best, and the sugar concentration was 33%(2) through fermentation orthogonal test, when adding the yeast is 2.0%, proportion of Rhodiola and glutinous rice is 1:1, the temperature is 28℃, and fermentation time is seven days, alcoholicity of the wine was the highest and sensory evaluation was the best..

本文立足加工高品质的红景天糯米保健酒，主要对糖化条件，发酵工艺参数的确定，后发酵温度的确定，稳定性试验，膜过滤试验条件，营养成分分析等方面进行系统的研究，结果表明：(1)通过糖化正交试验，在底物浓度1∶2、糖化温度60℃、酶用量0.5％、糖化6h时糖化效果最好，糖液浓度33％；(2)通过发酵正交试验，在酵母添加量2.0％、红景天糯米比1∶1、发酵温度28℃、发酵时间7天生成的酒度最高，感官评价最好；(3)通过后发酵试验，选择10～15℃温度下后发酵，酒体澄清，感官评价最好；(4)从对红景天糯米酒稳定性分析中得知：酒体在低于-6℃时略有絮状物出现，酒体混浊沉淀的主要原因可能是蛋白质。

The calculation of degree-day is usually based on the definiation of basic temperature and average temperature in the day. The basic temperature is often calculated according to energy supply, physiological demand of human body, the level of economic development and the character of temperature changes. There are mainly four methods for the calculation of average day temperature. The most popular way is to get the average of the highest temperature and the lowest one.

度日计算的前提是基础温度和日平均温度的确定，其中基础温度往往是根据能源供应、人体生理需求、经济水平以及温度变化特点而人为规定的，也有一些学者尝试用数学方法求得；日平均温度的计算方法主要有4种，国外学者经常采用的是取日最高气温和最低气温算术平均值的方法。

The results revealed that the conversion was 92.4% when aniline concentration was 1 mol/L, feeding temperature was 25℃ and residence time was 11 s. With feeding temperature being the main factor, the effect of residence time decreases successively. The diazotization anomalies could be caused at aniline concentration above 1.5 mol/L. The proper feeding temperature which can lead to the highest conversion was 20~30℃.

试验结果表明，在苯胺浓度为1 mol/L，进料温度为25℃，停留时间为11 s时反应转化率达92.4%；苯胺浓度、进料温度、停留时间对反应影响程度各不相同，其中进料温度的影响最大，停留时间次之，苯胺浓度高于1.5mol/L后，对反应影响加剧，导致反应异常；从进料温度对反应的影响试验分析可得，反应转化率最高的进料温度在20~30℃之间。

The catalyst on calcination temperature of 400℃ had the highest conversion of isobutylene and the catalyst on calcination temperature of 500℃ had the highest selectivity of methacrolein .

焙烧温度为400℃的催化剂异丁烯的转化率最高，焙烧温度为500℃的催化剂甲基丙烯醛的选择性最高。

Different preparative conditions were required in Esterificational Reaction and Pentane Isomerization Reaction.

在异构化反应中，焙烧温度在500℃时制备的催化活性最高，当反应温度50℃最高转化率24.070/0，35℃时最高转化率7.23%。

Effects of dry temperature and dry time on properties of heat cured sand and the relationship with binder composition are as follows:sands bonded by binders that are not modified have high strength when dry temperature is high and dry time is long,but their anti-wettability power is poor . Sands bonded by binders that are modified by B but not modified by M can be dried quickly and sand strength is high but anti-wettability power is also poor. Sands bonded by binders that are modified by M but not modified by B can also be dried quickly to obtain maximum strength,then the strength becomes lower when they are dried continually for more time. and sand strength is high but anti-wettability power is also poor. Sands bonded by binders that are modified by M as well as by B at the same time can be dried quickly to obtain maximum strength at low temperature and short time. But the anti-wettability of sand mold is best when they are dried at high temperature and long time.

烘干温度和烘干时间对热硬砂性能的影响及其与粘结剂改性的关系是：未经改性剂B和改性剂M改性的粘结剂砂，脱水速度较慢，烘干温度越高，时间越长，则硬化强度也越高，但未经改性的粘结剂热硬砂的抗吸湿性较差；经改性剂B而不经改性剂M改性的粘结剂热硬砂，烘干硬化速度较快，强度也高，但在高湿度下的抗吸湿性不好；经改性剂M改性而不经改性剂B改性的粘结剂热硬砂，烘干时强度先随烘干时间升高至最大值后，继续烘干时强度又出现下降；经改性剂B和经改性剂M共同改性的粘结剂热硬砂能在短时间和较低的烘干温度下就可烘干到最高强度，即烘干脱水的速度较快，但试样的抗吸湿性差，若在更高温度和更长时间下烘干，试样的抗吸湿性得到改善，综合考虑烘干强度和抗吸湿性要求，对于φ30×30mm试样，理想的烘干温度是200℃，烘干时间20分钟。

The environmental laboratory has 1,110 m 2 , in the possession of 20 advanced test equipments that both from China and other countries such as USA , France , Italy , Japan , etc. The speed of decreasing temperature could reach 15 ℃/min, the raising speed of temperature could reach 30 ℃/min and be capable of adjustment continuously. 29 m 3 test box could test temperature, temperature and humidity for large electrician and electronic equipment. The speed of raising temperature could reach 6 ℃/min at best. Vibration test equipment include slipway, it could carry through three axis vibration, and the minimum thrust force is 5 tons.

环境实验室建筑面积 1100 平方米，拥有从美国、法国、意大利、日本等国家引进的国外及国产先进试验测试设备 20 台，降温速度最高可达到 15 ℃/min ，升温速度可达 30 ℃/min且连续可调； 29 立方试验箱能对大型电工电子设备进行温度、温度循环及湿度试验，升温速度最高可达 6 ℃/min ；振动试验设备有滑台，可进行三轴向振动，最大推力可达 5 吨。

When chemostats were used to study the Monod kinetic coefficients of garbage digestion under thermophilic condition, it was found that the maximum yield coefficient, the decay coefficient, the maximum specific utilization, and the half-velocity constant were 1.747 mg VSS/mg COD, 0.1191 1/d, 0.326 mg COD/mg VSS-d, and 2715 mg COD/L, respectively.

在温度因子对厨余之水解实验结果方面，热前处理温度设定为37℃、50℃及60℃达84小时后，发现以60℃处理之水解率(18.1%)及油脂去除率(37.7%)最高；将上述经37℃、50℃及60℃处理84小时之厨余，以气泡式呼吸仪实验探讨生物分解性之结果亦显示，以60℃处理时经过约300小时后TCOD去除率79.2%最高。

2 Maximum working temperature maximumoperatingtemperature And maximum working pressure corresponding saturation temperature.

3.2.2 最高工作温度maximumoperatingtemperature 与最高工作压力相对应的饱和温度。

2 Maximum working temperature maximumoperatingtemperature And maximum working pressure corresponding saturation temperature.

3.2.2 最高工作温度maximumoperatingtemperature 与最高工作压力相对于应的达到最高限度温度。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。