最高温度

It can be found that the two improved schemes make the power loss reduced and the minimum oil film thickness and the maximum temperature of the bearing are in the tolerance limit.

结果表明：所提出的两个改进方案都不同程度地降低了摩擦功耗，且最小膜厚及轴承最高温度都在允许范围内。

For example, the lead zirconate titanate with exellent ferroelectric properties should be integrated onto silicon substrate at low substrate temperature at which the integration circuit can not be damaged.

但是，目前铁电薄膜的制备工艺一般要经过600℃以上的热处理，然而硅MOS器件所能承受的最高温度为450℃。

The distribution of adsorbent temperature and its variation with time were derived.

理论分析表明，系统的最高温度和性能均优于一般的吸附制冷系统。

The AutoLime green liquor distribution control fine tunes and maintains the slaker's contents at the highest temperature possible without boiling while maintaining the distribution flow into the first causticizer/classifier section as large as possible.

在还未沸腾的最高温度下，由 AutoLime 绿液分布控制功能保持石灰消和器内物质含量恒定，同时保证流入最初苛化剂/分类器内的流量尽可能最大。

After optimizing the technological technique, the parameters on microwave magnetic sintering of NdFeB magnets were chosen: the powder with average particle size of 3μm was isostatically pressed at 2000kg/C㎡, and the shape of the green compact is φ18×6mm.

进行工艺优化后，我们所选用的微波烧结参数为：微波功率2kW，粉体的平均粒径3μm，压型压力2t/cm2，初坯为φ18×6mm的圆柱体，烧结最高温度约为900℃，烧结的时间70s左右。

Due to the technical reformation and enlarging the smelting intensity, the set of 30MVA silicon-manganese submerged arc furnace and the dry gas cleaning system has increased the output of silicomanganese , thus, the gas maximum temperature has risen from 650℃to 950℃, and the gas volume has increased by 80%.

MVA 锰硅矿热炉及其煤气干式净化系统由于技术改造增大冶炼强度提高了锰硅合金的产量，导致煤气最高温度从原设计的650℃提高到950℃，煤气量增加了80％。

Sometimes the high tempe nature in summer is 40度 in some...

在一些地区，夏天最高温度有时是4。

If a joint is in the cable, the temperature of the tinning welding joint is mot more than 120℃,compressing joint mot more than 150℃ and electro-welding or gas-welding joint not more than 250℃.

2.2.2 短路时（最长持续时间不超过5秒），导体最高温度不超过250℃，电缆线路中间有接头时，锡焊接头不超过120℃，压接接头不超过150℃，电焊或气焊接头不超过250℃。

It has shown that the optimum condition to modify phenol-formaldehyde resin were phenol﹕formaldehyde﹕diethylene triamine 1﹕0.8﹕0.015, reaction temperature 95～105℃and reaction time 2h, when using diethylene triamine as modifying agent.

实验结果表明，以二乙烯三胺为改性剂时，制备改性酚醛树脂的最佳实验条件是：苯酚﹕甲醛﹕二乙烯三胺为1﹕0.8﹕0.015；反应的最高温度为95～105℃；反应时间2h。

The congealing point of a substance, determined as described below, is the highest temperature, which remains constant for a short time, occuring during the solidification of the liquid.

凝点系指一种物质照下述方法测定，由液体凝结为固体时，在短时间内停留不变的最高温度。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了