最适宜

The results showed that glucose was the best carbon source and organic N was much better than inorganic N. Czapek medium was the most appropriate for sporulating.

结果表明：葡萄糖是最好的碳源，有机氮远比无机氮好，Czapek培养基对孢子形成最适宜。

One surmises that the generally drab look of all American cities is due to failure on the part of architect's creative imagination.

有人推测，美国所有城市通常为土褐色那种单调的外貌，这从建筑师角度来讲，是由于他没能毫无偏见地为建筑物尽可能寻找最适宜的基本色调，而不管其结果如何。

The optimum concentration of dye in hydrochloric acid was 0.06-0.12% for the assay.

最适宜之染料浓度为0.06─0.12%之间。

In this experiment the addition of 1.6% of fat and 6%?% alfalfa meal of the sows fed alfalfa meal to the diet dry matter proved to be the best.

试验证明，母猪日粮干物质中脂肪含量为1.6％时，苜蓿草粉的最适宜添加比例为6％～8％。

And the result is AgNO3 measuring NaIO4 titration. Amino nitrogen content in DAC derivatives was measured by element analysis technique.

通过四种醛基检测方法的比较，AgNO3滴定法是测定醛基含量最适宜的，从分析手段来讲，也是简便易行成本较低的。

The effect of reaction temperature,reaction time,materials ratio on the synthesis of piperidine alcohol benzoate ,hindered amine light stabilizer,from piperidine alcohol and benzoyl chloride by direct condensation were studied,and the proper technological conditions were given as follows:the reaction temperature is 95℃;reaction time is 4 h; the mole ratio of reactants,n∶n is 1∶1.4,the amounts of solvent is 40 mL(based 0.1mol piperidine alcohol),the arerage yield ...

王树清，高崇，苯甲酸哌啶醇酯HALS的合成工艺研究研究了以苯甲酰氯和哌啶醇为原料直接缩合合成苯甲酸哌啶醇酯受阻胺光稳定剂时反应温度、反应时间、原料配比等条件对合成反应的影响，确定了最佳工艺条件。最适宜的工艺条件是：反应温度95℃、反应时间6h、原料摩尔比n∶n为1∶1.4，溶剂用量为70mL(相对于0.1mol哌啶醇)，苯甲酸哌啶醇酯的收率为91.05%，产品纯度98.5%。

The effects of molar ratio of benzyl alcohol to acetic acid,reaction time,and the amount of catalyst and its reusability on esterification yield were discussed.

结果表明，乙酸苄酯最适宜的合成工艺条件为：酸醇摩尔比2∶1、催化剂用量3.5%、带水剂用量40%、反应时间6 h。

The results showed that the optimal conditions for synthesis of benzyl acetate were: the molar ratio of acetic acid to benzyl alcohol was 2∶1,the amount of the water carrier was 40%,the amount of the catalyst was 3.5%,and reaction time was 6 h.

结果表明，乙酸苄酯最适宜的合成工艺条件为：酸醇摩尔比2∶1、催化剂用量3.5%、带水剂用量40%、反应时间6 h。

Jatropha Curcas oil was used as feedstock for producing biodiesel by transesterification,and adding sodium hydroxide,potassium hydroxide or sodium methoxide as catalyst respectively. The optimal conditions were obtained:molar ratio of methanol to oil 6∶1,reaction temperature 60 ℃,reaction time 80 min,mixing intensity 600 r/min,catalyst concentration for NaOH,KOH,or CH3ONa 1.2% of oil weight,The yield of biodiesel was above 97%. The physico-chemical indices of the biodiesel obtained met the quality standard ASTM of USA and DIN V of Germany.

选用了非食用油麻疯果油为原料，以氢氧化钠、氢氧化钾、甲醇钠为催化剂，通过酯交换法制取生物柴油，研究表明最适宜工艺条件为：醇油比6∶1，反应温度60 ℃，反应时间80 min，搅拌强度为600 r/min，催化剂用量为1.2%，转化率达到97%以上，且生物柴油各项理化指标均符合美国和德国测试标准。

From analyzing the drip irrigation emitter types and choosing in experiment, the main conclusions are as follows: The best type of subsurface drip irrigation emitter is drip pipe. Under lower water press the stabilization discharge of orifice emitter in soil is three fifth of that in air, which can meet the request of subsurface drip irrigation.

通过对现有滴灌灌水器类型的分析及试验筛选，结果表明，内镶式滴灌管最适宜应用于地下滴灌，在低压运行时，孔口式滴头在土壤中稳定出流量为空气中的 3/ 5 ，基本可以满足地下滴灌的要求；在较高供水压力时，所选取的几种滴头基本上都可以用于地下滴灌。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。